| if ARCH_MX23 |
| |
| config MX23 |
| bool |
| default y |
| |
| choice |
| prompt "MX23 board select" |
| optional |
| |
| config TARGET_MX23_OLINUXINO |
| bool "Support mx23_olinuxino" |
| select BOARD_EARLY_INIT_F |
| |
| config TARGET_MX23EVK |
| bool "Support mx23evk" |
| select BOARD_EARLY_INIT_F |
| |
| config TARGET_XFI3 |
| bool "Support xfi3" |
| |
| endchoice |
| |
| config SYS_SOC |
| default "mxs" |
| |
| source "board/olimex/mx23_olinuxino/Kconfig" |
| source "board/freescale/mx23evk/Kconfig" |
| |
| endif |
| |
| if ARCH_MX28 |
| |
| config MX28 |
| bool |
| default y |
| |
| choice |
| prompt "MX28 board select" |
| optional |
| |
| config TARGET_MX28EVK |
| bool "Support mx28evk" |
| select BOARD_EARLY_INIT_F |
| |
| config TARGET_XEA |
| bool "Support XEA" |
| select PL01X_SERIAL |
| |
| endchoice |
| |
| config SYS_SOC |
| default "mxs" |
| |
| config SPL_MXS_PMU_MINIMAL_VDD5V_CURRENT |
| bool "Force minimal current draw from VDD5V by MX28 PMU" |
| default n |
| help |
| After setting this option, the current drawn from VDD5V |
| by the PMU is reduced to zero - the DCDC_BATT is used as |
| the main power source for PMU. |
| |
| config SPL_MXS_PMU_DISABLE_BATT_CHARGE |
| bool "Disable Battery Charging in MX28 PMU" |
| default n |
| |
| config SPL_MXS_PMU_ENABLE_4P2_LINEAR_REGULATOR |
| bool "Enable the 4P2 linear regulator in MX28 PMU" |
| default y |
| help |
| This option enables the 4P2 linear regulator (derived |
| from VDD5V) - so the VDD4P2 power source is operational. |
| |
| source "board/freescale/mx28evk/Kconfig" |
| source "board/liebherr/xea/Kconfig" |
| |
| endif |