mpc5xxx: Remove all references to MGT5100
We do not support a processor that never reached a real customer.
Signed-off-by: Detlev Zundel <dzu@denx.de>
diff --git a/include/configs/Total5200.h b/include/configs/Total5200.h
index 1daa574..7510ab1 100644
--- a/include/configs/Total5200.h
+++ b/include/configs/Total5200.h
@@ -41,6 +41,7 @@
*/
#define CONFIG_MPC5xxx 1 /* This is an MPC5xxx CPU */
+#define CONFIG_MPC5200 1 /* (more precisely a MPC5200 CPU) */
#define CONFIG_TOTAL5200 1 /* ... on Total5200 board */
#define CONFIG_SYS_MPC5XXX_CLKIN 33000000 /* ... running at 33.000000MHz */
@@ -73,7 +74,6 @@
#define CONFIG_SPLASH_SCREEN
-#ifdef CONFIG_MPC5200 /* MGT5100 PCI is not supported yet. */
/*
* PCI Mapping:
* 0x40000000 - 0x4fffffff - PCI Memory
@@ -98,12 +98,6 @@
#define CONFIG_SYS_RX_ETH_BUFFER 8 /* use 8 rx buffer on eepro100 */
#define CONFIG_NS8382X 1
-#else /* MGT5100 */
-
-#define CONFIG_MII 1
-
-#endif
-
/* Partitions */
#define CONFIG_MAC_PARTITION
#define CONFIG_DOS_PARTITION
@@ -127,9 +121,7 @@
*/
#include <config_cmd_default.h>
-#if defined(CONFIG_MPC5200)
- #define CONFIG_CMD_PCI
-#endif
+#define CONFIG_CMD_PCI
#define CONFIG_CMD_BMP
#define CONFIG_CMD_EEPROM
@@ -176,12 +168,10 @@
#define CONFIG_BOOTCOMMAND "run flash_self"
-#if defined(CONFIG_MPC5200)
/*
* IPB Bus clocking configuration.
*/
#undef CONFIG_SYS_IPBCLK_EQUALS_XLBCLK /* define for 133MHz speed */
-#endif
/*
* I2C configuration
@@ -326,17 +316,8 @@
/*
* Various low-level settings
*/
-#if defined(CONFIG_MPC5200)
#define CONFIG_SYS_HID0_INIT HID0_ICE | HID0_ICFI
#define CONFIG_SYS_HID0_FINAL HID0_ICE
-#else
-#define CONFIG_SYS_HID0_INIT 0
-#define CONFIG_SYS_HID0_FINAL 0
-#endif
-
-#if defined (CONFIG_MGT5100)
-# define CONFIG_BOARD_EARLY_INIT_R /* switch from CS_BOOT to CS0 */
-#endif
#if CONFIG_TOTAL5200_REV==1
# define CONFIG_SYS_BOOTCS_START CONFIG_SYS_FLASH_BASE