Cleanup
diff --git a/doc/README-integrator b/doc/README-integrator
index 93d7688..c435c88 100644
--- a/doc/README-integrator
+++ b/doc/README-integrator
@@ -12,7 +12,7 @@
--------
There are two Integrator variants - Integrator/AP and Integrator/CP.
Each may be fitted with a variety of core modules (CMs).
-Each CM consists of a ARM processor core and associated hardware e.g
+Each CM consists of a ARM processor core and associated hardware e.g
FPGA implementing various controllers and/or register
SSRAM
SDRAM
@@ -26,29 +26,29 @@
b) Run ARM boot monitor, automatically run U-Boot image from flash
c) Run U-Boot image direct from flash.
-In cases a) and b) the ARM boot monitor will have configured the CM and mapped
+In cases a) and b) the ARM boot monitor will have configured the CM and mapped
writeable memory to 0x00000000 in the Integrator address space.
U-Boot has to carry out minimal configration before standard code is run.
In case c) it may be necessary for U-Boot to perform CM dependent initialization.
Configuring U-Boot :
-------------------
+------------------
The makefile contains targets for Integrator platforms of both types
-fitted with all current variants of CM. If these targets are to be used with
-boot process c) above then CONFIG_INIT_CRITICAL may need to be defined to ensure
+fitted with all current variants of CM. If these targets are to be used with
+boot process c) above then CONFIG_INIT_CRITICAL may need to be defined to ensure
that the CM is correctly configured.
There are also targets independent of CM. These may not be suitable for
-boot process c) above. They have been preserved for backward compatibility with
+boot process c) above. They have been preserved for backward compatibility with
existing build processes.
Code Hierarchy Applied :
----------------------
-Code specific to initialization of a particular ARM processor has been placed in
+Code specific to initialization of a particular ARM processor has been placed in
cpu/arm<>/start.S so that it may be used by other boards.
-However, to avoid duplicating code through all processor files, a generic core
+However, to avoid duplicating code through all processor files, a generic core
for ARM Integrator CMs has been added
cpu/arm_intcm
@@ -57,10 +57,7 @@
need placing in each CM processor file......
Code specific to the initialization of the CM, rather than the cpu, and initialization
-of the Integrator board itself, has been placed in
+of the Integrator board itself, has been placed in
- board/integrator<>/platform.S
+ board/integrator<>/platform.S
board/integrator<>/integrator<>.c
-
-
-