blob: ee818ede267eedab950066c5753a0536ad78fe9d [file] [log] [blame]
Nikita Kiryanov8883dda2015-07-30 23:56:23 +03001/*
2 * cm_t43.h
3 *
4 * Copyright (C) 2015 Compulab, Ltd.
5 *
6 * SPDX-License-Identifier: GPL-2.0+
7 */
8
9#ifndef __CONFIG_CM_T43_H
10#define __CONFIG_CM_T43_H
11
12#define CONFIG_AM43XX
13#define CONFIG_CM_T43
14#define CONFIG_ARCH_CPU_INIT
15#define CONFIG_MAX_RAM_BANK_SIZE (2048 << 20) /* 2GB */
16#define CONFIG_SYS_TIMERBASE 0x48040000 /* Use Timer2 */
17
18#include <asm/arch/omap.h>
19
20/* Serial support */
Nikita Kiryanov8883dda2015-07-30 23:56:23 +030021#define CONFIG_SYS_NS16550_SERIAL
22#define CONFIG_SYS_NS16550_CLK 48000000
23#define CONFIG_SYS_NS16550_COM1 0x44e09000
Nikita Kiryanov7ef77c02016-02-19 19:19:42 +020024#ifdef CONFIG_SPL_BUILD
25#define CONFIG_SYS_NS16550_REG_SIZE (-4)
26#endif
Nikita Kiryanov8883dda2015-07-30 23:56:23 +030027
28/* NAND support */
29#define CONFIG_NAND
30#define CONFIG_NAND_OMAP_ELM
31#define CONFIG_SYS_NAND_ONFI_DETECTION
32#define CONFIG_SYS_NAND_5_ADDR_CYCLE
33#define CONFIG_SYS_NAND_PAGE_SIZE 2048
34#define CONFIG_SYS_NAND_OOBSIZE 64
35#define CONFIG_SYS_NAND_BLOCK_SIZE (128 * 1024)
36#define CONFIG_SYS_NAND_BAD_BLOCK_POS NAND_LARGE_BADBLOCK_POS
37#define CONFIG_SYS_NAND_ECCSIZE 512
38#define CONFIG_SYS_NAND_ECCBYTES 14
39#define CONFIG_NAND_OMAP_ECCSCHEME OMAP_ECC_BCH8_CODE_HW
40#define CONFIG_SYS_NAND_PAGE_COUNT (CONFIG_SYS_NAND_BLOCK_SIZE / \
41 CONFIG_SYS_NAND_PAGE_SIZE)
42#define CONFIG_SYS_NAND_ECCPOS { 2, 3, 4, 5, 6, 7, 8, 9, \
43 10, 11, 12, 13, 14, 15, 16, 17, \
44 18, 19, 20, 21, 22, 23, 24, 25, \
45 26, 27, 28, 29, 30, 31, 32, 33, \
46 34, 35, 36, 37, 38, 39, 40, 41, \
47 42, 43, 44, 45, 46, 47, 48, 49, \
48 50, 51, 52, 53, 54, 55, 56, 57, }
49
50/* CPSW Ethernet support */
51#define CONFIG_DRIVER_TI_CPSW
52#define CONFIG_MII
53#define CONFIG_BOOTP_DEFAULT
54#define CONFIG_BOOTP_SEND_HOSTNAME
55#define CONFIG_BOOTP_GATEWAY
56#define CONFIG_NET_MULTI
57#define CONFIG_PHY_GIGE
58#define CONFIG_PHY_ATHEROS
59#define CONFIG_PHYLIB
60#define CONFIG_SYS_RX_ETH_BUFFER 64
61
62/* USB support */
63#define CONFIG_USB_HOST
64#define CONFIG_USB_XHCI
65#define CONFIG_USB_XHCI_OMAP
66#define CONFIG_USB_XHCI_DWC3
67#define CONFIG_USB_STORAGE
68#define CONFIG_SYS_USB_XHCI_MAX_ROOT_PORTS 2
69#define CONFIG_OMAP_USB_PHY
70#define CONFIG_AM437X_USB2PHY2_HOST
71
72/* SPI Flash support */
Nikita Kiryanov8883dda2015-07-30 23:56:23 +030073#define CONFIG_TI_SPI_MMAP
Nikita Kiryanov8883dda2015-07-30 23:56:23 +030074#define CONFIG_SF_DEFAULT_SPEED 48000000
75#define CONFIG_DEFAULT_SPI_MODE SPI_MODE_3
76
77/* Power */
78#define CONFIG_POWER
79#define CONFIG_POWER_I2C
80#define CONFIG_POWER_TPS65218
81
82/* Enabling L2 Cache */
83#define CONFIG_SYS_L2_PL310
84#define CONFIG_SYS_PL310_BASE 0x48242000
85#define CONFIG_SYS_CACHELINE_SIZE 32
86
87/*
88 * Since SPL did pll and ddr initialization for us,
89 * we don't need to do it twice.
90 */
91#if !defined(CONFIG_SPL_BUILD)
92#define CONFIG_SKIP_LOWLEVEL_INIT
93#endif
94
95#define CONFIG_HSMMC2_8BIT
96
97#include <configs/ti_armv7_omap.h>
98#undef CONFIG_SPL_OS_BOOT
99#undef CONFIG_SPL_GPIO_SUPPORT
100#undef CONFIG_SPL_NAND_SUPPORT
Nikita Kiryanov7d751d62016-02-19 19:19:50 +0200101#undef CONFIG_SYS_MONITOR_LEN
102#undef CONFIG_SYS_MMCSD_RAW_MODE_U_BOOT_SECTOR
Nikita Kiryanov8883dda2015-07-30 23:56:23 +0300103#define CONFIG_ZERO_BOOTDELAY_CHECK
Nikita Kiryanov8883dda2015-07-30 23:56:23 +0300104
105#define CONFIG_ENV_SIZE (16 * 1024)
106#define CONFIG_ENV_VARS_UBOOT_RUNTIME_CONFIG
107
108#define V_OSCK 24000000 /* Clock output from T2 */
109#define V_SCLK (V_OSCK)
110
111#define CONFIG_ENV_IS_IN_SPI_FLASH
112#define CONFIG_ENV_SECT_SIZE (64 * 1024)
113#define CONFIG_ENV_OFFSET (768 * 1024)
114#define CONFIG_ENV_SPI_MAX_HZ 48000000
115
116#define CONFIG_SPL_LDSCRIPT "$(CPUDIR)/omap-common/u-boot-spl.lds"
117
118/* Enhance our eMMC support / experience. */
119#define CONFIG_CMD_GPT
120#define CONFIG_EFI_PARTITION
121
122#define CONFIG_EXTRA_ENV_SETTINGS \
123 "loadaddr=0x80200000\0" \
124 "fdtaddr=0x81200000\0" \
125 "bootm_size=0x8000000\0" \
126 "autoload=no\0" \
127 "console=ttyO0,115200n8\0" \
128 "fdtfile=am437x-sb-som-t43.dtb\0" \
129 "kernel=zImage-cm-t43\0" \
130 "bootscr=bootscr.img\0" \
131 "emmcroot=/dev/mmcblk0p2 rw\0" \
132 "emmcrootfstype=ext4 rootwait\0" \
133 "emmcargs=setenv bootargs console=${console} " \
134 "root=${emmcroot} " \
135 "rootfstype=${emmcrootfstype}\0" \
136 "loadbootscript=load mmc 0 ${loadaddr} ${bootscr}\0" \
137 "bootscript=echo Running bootscript from mmc ...; " \
138 "source ${loadaddr}\0" \
139 "emmcboot=echo Booting from emmc ... && " \
140 "run emmcargs && " \
141 "load mmc 1 ${loadaddr} ${kernel} && " \
142 "load mmc 1 ${fdtaddr} ${fdtfile} && " \
143 "bootz ${loadaddr} - ${fdtaddr}\0"
144
145#define CONFIG_BOOTCOMMAND \
146 "mmc dev 0; " \
147 "if mmc rescan; then " \
148 "if run loadbootscript; then " \
149 "run bootscript; " \
150 "fi; " \
151 "fi; " \
152 "mmc dev 1; " \
153 "if mmc rescan; then " \
154 "run emmcboot; " \
155 "fi;"
156
Nikita Kiryanov8883dda2015-07-30 23:56:23 +0300157#define CONFIG_CONS_INDEX 1
158
159/* SPL defines. */
160#define CONFIG_SPL_TEXT_BASE 0x40300350
161#define CONFIG_SPL_MAX_SIZE (64 * 1024)
162#define CONFIG_SYS_SPL_ARGS_ADDR (CONFIG_SYS_SDRAM_BASE + (128 << 20))
163#define CONFIG_SPL_POWER_SUPPORT
164#define CONFIG_SYS_SPI_U_BOOT_OFFS (256 * 1024)
Nikita Kiryanov7d751d62016-02-19 19:19:50 +0200165#define CONFIG_SYS_MONITOR_LEN (512 * 1024)
166#define CONFIG_SYS_MMCSD_RAW_MODE_U_BOOT_SECTOR 0x480
Nikita Kiryanov8883dda2015-07-30 23:56:23 +0300167#define CONFIG_SPL_SPI_SUPPORT
168#define CONFIG_SPL_SPI_FLASH_SUPPORT
169#define CONFIG_SPL_SPI_LOAD
Nikita Kiryanov43e568c2016-02-19 19:19:49 +0200170#define CONFIG_SPL_I2C_SUPPORT
171#define CONFIG_SPL_POWER_SUPPORT
Nikita Kiryanov8883dda2015-07-30 23:56:23 +0300172
173#endif /* __CONFIG_CM_T43_H */