- a6c64d2 board: ti: k2g: Program PadConfig_202 before locking RSTMUX8 by Suman Anna · 3 years, 4 months ago
- 2147a16 dm: i2c: use CONFIG_IS_ENABLED macro for DM_I2C/DM_I2C_GPIO by Igor Opaniuk · 3 years, 9 months ago
- 401d1c4 common: Drop asm/global_data.h from common header by Simon Glass · 4 years ago
- d2aa572 board: ti: k2g: Add support for K2G ICE with 1GHz Silicon by Lokesh Vutla · 4 years ago
- b75d8dc treewide: convert bd_t to struct bd_info by coccinelle by Masahiro Yamada · 4 years, 5 months ago
- 8971358 arm: ti: Remove ARCH= references from documentation by Tom Rini · 4 years, 6 months ago
- cd93d62 common: Drop linux/bitops.h from common header by Simon Glass · 4 years, 6 months ago
- c05ed00 common: Drop linux/delay.h from common header by Simon Glass · 4 years, 6 months ago
- 691d719 common: Drop init.h from common header by Simon Glass · 4 years, 6 months ago
- 4d72caa common: Drop image.h from common header by Simon Glass · 4 years, 6 months ago
- db41d65 common: Move hang() to the same header as panic() by Simon Glass · 4 years, 11 months ago
- 9b4a205 common: Move RAM-sizing functions to init.h by Simon Glass · 4 years, 11 months ago
- cb3ef68 common: Move old EEPROM functions into a new header by Simon Glass · 5 years ago
- 5255932 common: Move some board functions out of common.h by Simon Glass · 5 years ago
- f4378ca ARM: keystone: Do not enable the USB power domains at the board level by Jean-Jacques Hiblot · 5 years ago
- 7b51b57 env: Move env_get() to env.h by Simon Glass · 5 years ago
- 9eef56d env: Move env_get_ulong() to env.h by Simon Glass · 5 years ago
- 89bf9f1 ARM: k2g-ice: Add pinmux support for rgmii interface by Murali Karicheri · 6 years ago
- 63200d8 ARM: k2g-gp-evm: update to rgmii pinmux configuration by Murali Karicheri · 6 years ago
- f748ec9 ARM: k2g: add a workaround to reset the phy by Murali Karicheri · 6 years ago
- b15311c ARM: k2g-gp-evm: update to rgmii pinmux configuration by Murali Karicheri · 6 years ago
- c7206e9 ARM: k2g-ice: Add pinmux support for rgmii interface by Murali Karicheri · 6 years ago
- c9d5220 board: ks2_evm: Enable the USB clocks if DM_USB is used by Jean-Jacques Hiblot · 6 years ago
- 1514244 ti: remove usage of DM_I2C_COMPAT and don't disable DM_I2C in SPL by Jean-Jacques Hiblot · 6 years ago
- 3b074fb board: ti: ks2_evm: Over ride spl_get_load_buffer function by Keerthy · 6 years ago
- af0cf21 drivers: net: keystone_net: drop non dm code by Grygorii Strashko · 6 years ago
- 442faf6 board: ks2: move uinitrd fixup logic inside ft_board_setup_ex by Nicholas Faustini · 6 years ago
- 83d290c SPDX: Convert all of our single license tags to Linux Kernel style by Tom Rini · 7 years ago
- d024236 Remove unnecessary instances of DECLARE_GLOBAL_DATA_PTR by Tom Rini · 7 years ago
- 952c346 env: Fix missed getenv_ulong to env_get_ulong conversion by Andrew F. Davis · 7 years ago
- a47506f ARM: k2g: Add pinmux data for QSPI on K2G ICE by Vignesh R · 7 years ago
- f1627bd board: ti: k2g: Make ddr3* declarations as static by Lokesh Vutla · 7 years ago
- 4849d95 board: ti: K2G FC SoC 1GHz and DDR3 1066 MT/s support by Rex Chang · 7 years ago
- 1195559 dts: renamed FIT_EMBED to MULTI_DTB_FIT and moved it to the dts Kconfig by Jean-Jacques Hiblot · 7 years ago
- 58fac52 ARM: k2g: Add FIT image handler for PMMC firmware by Andrew F. Davis · 7 years ago
- 00caae6 env: Rename getenv/_f() to env_get() by Simon Glass · 7 years ago
- 382bee5 env: Rename setenv() to env_set() by Simon Glass · 7 years ago
- b7695c0 board: ks2: README: Update NAND wording by Cooper Jr., Franklin · 7 years ago
- bc42096 ARM: k2g: Add K2G ICE DTB to the list of possible DTBs by Cooper Jr., Franklin · 7 years ago
- 92761fc ARM: k2g: Update board_name u-boot env variable at runtime by Cooper Jr., Franklin · 7 years ago
- 4f49040 ARM: k2g: Use board detection to wrap K2G GP specific calls by Cooper Jr., Franklin · 7 years ago
- e66a5da board: ks2: Use board detection to wrap code not specific to K2G ICE evm by Cooper Jr., Franklin · 7 years ago
- 652606e ARM: k2g: Add DDR3 configuration for K2G ICE evm by Cooper Jr., Franklin · 7 years ago
- b9b342e ARM: k2g: Add pinmux support for K2G ICE evm by Cooper Jr., Franklin · 7 years ago
- e6e2435 ks2_evm: Add EEPROM based board detection helper functions by Cooper Jr., Franklin · 7 years ago
- e5e546a ARM: k2g: Program DDRPHY_DATX8 registers via mask and value variables by Cooper Jr., Franklin · 7 years ago
- a76a6f3 ARM: k2g: Program DDR PHY MR2 register with the default value by Cooper Jr., Franklin · 7 years ago
- e820f52 ks2_evm: Add EEPROM based board detection by Cooper Jr., Franklin · 7 years ago
- 7234f21 ARM: keystone2: Define board_fit_config_name_match for Keystone 2 boards by Cooper Jr., Franklin · 7 years ago
- 5f48da9 ARM: k2g: Define embedded_dtb_select for runtime DTB selection in U-boot by Cooper Jr., Franklin · 7 years ago
- 9cb5eaf ARM: k2g: Fix passing main pll info for higher speeds by Lokesh Vutla · 7 years ago
- 4aa2ba3 mmc: replace CONFIG_GENERIC_MMC with CONFIG_MMC by Masahiro Yamada · 8 years ago
- ee3c653 ARM: keystone2: Add support for getting external clock dynamically by Lokesh Vutla · 8 years ago
- c5f177d ARM: k2g: Add support for dynamic programming of PLL based on SYSCLK by Lokesh Vutla · 8 years ago
- 752a831 ARM: k2g: setup PRU ethernet MAC addresses by Roger Quadros · 8 years ago
- 66e04fb ARM: Use Kconfig for board EEPROM's I2C bus and chip address by Roger Quadros · 8 years ago
- d5abcf9 ti: boot: Register the MMC controllers in SPL in the same way as in u-boot by Jean-Jacques Hiblot · 8 years ago
- ac34286 keystone2: Move target selection to Kconfig by Andrew F. Davis · 8 years ago
- 4d0fec0 ARM: k2g: Update PLL Multiplier and divider values by Lokesh Vutla · 8 years ago
- e92a6b2 board: ks2: Enable ECC using detected DDR size by Lokesh Vutla · 8 years ago
- 01c5075 board: ks2: README: Update to add K2G support by Lokesh Vutla · 8 years ago
- e2924e5 ARM: k2g: Configure reset mux to device reset by Lokesh Vutla · 8 years ago
- 7ffe3cd Delete tests of CONFIG_OF_LIBFDT when testing CONFIG_OF_BOARD_SETUP by Robert P. J. Day · 8 years ago
- 8f69523 memory: Move TI_AEMIF config to KCONFIG by Lokesh Vutla · 9 years ago
- b8dafa2 ti: k2g: increase phy autoneg timeout by Vitaly Andrianov · 9 years ago
- 8efc243 ARM: keystone2: use detected ddr3a size by Vitaly Andrianov · 9 years ago
- d9a76e7 ARM: keystone2: use SPD info to configure K2HK and K2E DDR3 by Vitaly Andrianov · 9 years ago
- ef76ebb ARM: keystone2: K2G: Add support for different arm/device speeds by Lokesh Vutla · 9 years ago
- 5cd1f6b ARM: keystone2: Allow for board specific speed definitions by Lokesh Vutla · 9 years ago
- 0369008 board: ti: ks2_evm: remove board_eth_init when CONFIG_DM_ETH is defined by Mugunthan V N · 9 years ago
- a187559 Use correct spelling of "U-Boot" by Bin Meng · 9 years ago
- b9ca4ab ARM: k2g: Add config file by Lokesh Vutla · 9 years ago
- 83b9bf1 ARM: k2g: Enable SPI flash by Lokesh Vutla · 9 years ago
- 3b68939 ARM: k2g: add SD card and eMMC support by Roger Quadros · 9 years ago
- 91266cc ARM: k2g: Add Ethernet Support by Vitaly Andrianov · 9 years ago
- bf7bd4e driver: net: keystone_net: fix phy mode configuration by Mugunthan V N · 9 years ago
- dd78b8c ARM: k2g: Add pin mux data by Vitaly Andrianov · 9 years ago
- 235dd6e ARM: k2g: Add ddr3 info by Vitaly Andrianov · 9 years ago
- e6d71e1 ARM: k2g: Add clock information by Vitaly Andrianov · 9 years ago
- bda920c ARM: k2g: Add pll data by Vitaly Andrianov · 9 years ago
- f9c4a51 ARM: k2g: Add kconfig support by Lokesh Vutla · 9 years ago
- 1985abe ARM: keystone2: Use dtb images by default by Lokesh Vutla · 9 years ago
- 8626cb8 ARM: k2e/l: Apply WA for selecting PA clock source by Lokesh Vutla · 9 years ago
- 76b3f19 ARM: k2l: Fix device speeds by Lokesh Vutla · 9 years ago
- be8ce70 ARM: keystone2: Update README by Lokesh Vutla · 9 years ago
- 5f586e9 ARM: keystone2: Rename u-boot-nand.gph to MLO by Lokesh Vutla · 9 years ago
- 7531122 ARM: keystone2: Remove unsed external clocks by Lokesh Vutla · 9 years ago
- 9406930 ARM: keystone2: Cleanup init_pll definition by Lokesh Vutla · 9 years ago
- 7b50e15 ARM: keystone2: Fix dev and arm speed detection by Lokesh Vutla · 9 years ago
- c321a23 ARM: keystone2: Cleanup PLL init code by Lokesh Vutla · 9 years ago
- 59d4cd2 board: ks2_evm: get rid of bogus CONFIG_LINUX_BOOT_PARAM_ADDR by Nishanth Menon · 9 years ago
- 3c963d2 board: ks2: README: fix typos by Nishanth Menon · 9 years ago
- 66c98a0 keystone2: ddr3: eliminate using global ddr3_size variable by Vitaly Andrianov · 10 years ago
- e895a4b fdt: Allow ft_board_setup() to report failure by Simon Glass · 10 years ago
- 790f70c kconfig: arm: select CPU_V7 for some new boards by Masahiro Yamada · 10 years ago
- 30491fc ks2_evm: board: remove sprintf for simple string by Khoronzhuk, Ivan · 10 years ago
- 4de96c7 ks2_evm: readme: add k2l evm board information by Khoronzhuk, Ivan · 10 years ago
- 796bcee board: k2l_evm: add network support by Hao Zhang · 10 years ago
- 89f44bb keystone2: ecc: add ddr3 error detection and correction support by Vitaly Andrianov · 10 years ago
- 00b821f board: k2e_evm: add network support by Hao Zhang · 10 years ago