| * Freescale ColdFire DMA-FEC ethernet controller |
| |
| Required properties: |
| - compatible: should be "fsl,mcf-dma-fec" |
| - reg: address and length of the register set for the device. |
| - rx-task: dma channel |
| - tx-task: dma channel |
| - rx-priority: dma channel |
| - tx-priority: dma channel |
| - rx-init: dma channel |
| - tx-init: dma channel |
| |
| Optional properties: |
| - mii-base: index of FEC reg area, 0 for FEC0, 1 for FEC1 |
| - max-speed: max speedm Mbits/sec |
| - phy-addr: phy address |
| - timeout-loop: integer value for driver loops time out |
| |
| |
| Example: |
| |
| fec0: ethernet@9000 { |
| compatible = "fsl,mcf-dma-fec"; |
| reg = <0x9000 0x800>; |
| mii-base = <0>; |
| phy-addr = <0>; |
| timeout-loop = <5000>; |
| rx-task = <0>; |
| tx-task = <1>; |
| rx-piority = <6>; |
| tx-piority = <7>; |
| rx-init = <16>; |
| tx-init = <17>; |
| status = "disabled"; |
| }; |