| CONFIG_ARM=y |
| CONFIG_COUNTER_FREQUENCY=25000000 |
| CONFIG_TARGET_LS1046ARDB=y |
| CONFIG_TEXT_BASE=0x82000000 |
| CONFIG_SYS_MALLOC_LEN=0x102000 |
| CONFIG_SPL_LIBCOMMON_SUPPORT=y |
| CONFIG_SPL_LIBGENERIC_SUPPORT=y |
| CONFIG_NR_DRAM_BANKS=2 |
| CONFIG_HAS_CUSTOM_SYS_INIT_SP_ADDR=y |
| CONFIG_CUSTOM_SYS_INIT_SP_ADDR=0x1000fff0 |
| CONFIG_ENV_SIZE=0x2000 |
| CONFIG_ENV_OFFSET=0x300000 |
| CONFIG_SYS_I2C_MXC_I2C1=y |
| CONFIG_SYS_I2C_MXC_I2C2=y |
| CONFIG_SYS_I2C_MXC_I2C3=y |
| CONFIG_SYS_I2C_MXC_I2C4=y |
| CONFIG_DM_GPIO=y |
| CONFIG_DEFAULT_DEVICE_TREE="fsl-ls1046a-rdb" |
| CONFIG_SPL_TEXT_BASE=0x10000000 |
| CONFIG_FSL_LS_PPA=y |
| CONFIG_SYS_MONITOR_LEN=1048576 |
| CONFIG_SPL_MMC=y |
| CONFIG_SPL_SERIAL=y |
| CONFIG_SPL_DRIVERS_MISC=y |
| CONFIG_SPL_STACK=0x10020000 |
| CONFIG_SPL=y |
| CONFIG_PCI=y |
| CONFIG_AHCI=y |
| CONFIG_LAYERSCAPE_NS_ACCESS=y |
| CONFIG_PCIE1=y |
| CONFIG_PCIE2=y |
| CONFIG_PCIE3=y |
| CONFIG_REMAKE_ELF=y |
| CONFIG_MP=y |
| CONFIG_FIT_VERBOSE=y |
| CONFIG_OF_BOARD_SETUP=y |
| CONFIG_RAMBOOT_PBL=y |
| CONFIG_SYS_FSL_PBL_PBI="board/freescale/ls1046ardb/ls1046ardb_pbi.cfg" |
| CONFIG_SYS_FSL_PBL_RCW="board/freescale/ls1046ardb/ls1046ardb_rcw_emmc.cfg" |
| CONFIG_DISTRO_DEFAULTS=y |
| CONFIG_SD_BOOT=y |
| CONFIG_BOOTDELAY=10 |
| CONFIG_USE_BOOTARGS=y |
| CONFIG_BOOTARGS="console=ttyS0,115200 root=/dev/ram0 earlycon=uart8250,mmio,0x21c0500 mtdparts=1550000.spi-0:1m(rcw),15m(u-boot),48m(kernel.itb);7e800000.flash:16m(nand_uboot),48m(nand_kernel),448m(nand_free)" |
| # CONFIG_USE_BOOTCOMMAND is not set |
| CONFIG_ARCH_MISC_INIT=y |
| CONFIG_MISC_INIT_R=y |
| CONFIG_SPL_MAX_SIZE=0x1f000 |
| CONFIG_SPL_PAD_TO=0x21000 |
| CONFIG_SPL_HAS_BSS_LINKER_SECTION=y |
| CONFIG_SPL_BSS_START_ADDR=0x8f000000 |
| CONFIG_SPL_BSS_MAX_SIZE=0x80000 |
| CONFIG_SPL_FSL_PBL=y |
| CONFIG_SPL_BOARD_INIT=y |
| # CONFIG_SPL_SHARES_INIT_SP_ADDR is not set |
| CONFIG_SYS_SPL_MALLOC=y |
| CONFIG_SYS_MMCSD_RAW_MODE_U_BOOT_USE_SECTOR=y |
| CONFIG_SYS_MMCSD_RAW_MODE_U_BOOT_SECTOR=0x110 |
| CONFIG_SPL_ENV_SUPPORT=y |
| CONFIG_SPL_I2C=y |
| CONFIG_SPL_MPC8XXX_INIT_DDR=y |
| CONFIG_SPL_WATCHDOG=y |
| CONFIG_SYS_MAXARGS=64 |
| CONFIG_SYS_PBSIZE=532 |
| CONFIG_SYS_EEPROM_PAGE_WRITE_DELAY_MS=5 |
| CONFIG_CMD_DM=y |
| CONFIG_CMD_GPIO=y |
| CONFIG_CMD_GPT=y |
| CONFIG_CMD_I2C=y |
| CONFIG_CMD_MMC=y |
| CONFIG_CMD_NAND=y |
| CONFIG_CMD_PCI=y |
| CONFIG_CMD_USB=y |
| CONFIG_CMD_CACHE=y |
| CONFIG_MTDPARTS_DEFAULT="mtdparts=1550000.spi-0:1m(rcw),15m(u-boot),48m(kernel.itb);7e800000.flash:16m(nand_uboot),48m(nand_kernel),448m(nand_free)" |
| # CONFIG_SPL_EFI_PARTITION is not set |
| CONFIG_OF_CONTROL=y |
| CONFIG_ENV_OVERWRITE=y |
| CONFIG_ENV_IS_IN_MMC=y |
| CONFIG_SYS_RELOC_GD_ENV_ADDR=y |
| CONFIG_USE_ETHPRIME=y |
| CONFIG_ETHPRIME="FM1@DTSEC3" |
| CONFIG_SATA=y |
| CONFIG_SATA_CEVA=y |
| CONFIG_FSL_CAAM=y |
| CONFIG_DDR_ECC=y |
| CONFIG_ECC_INIT_VIA_DDRCONTROLLER=y |
| CONFIG_MPC8XXX_GPIO=y |
| CONFIG_DM_I2C=y |
| CONFIG_I2C_SET_DEFAULT_BUS_NUM=y |
| CONFIG_SYS_I2C_EEPROM_ADDR=0x53 |
| CONFIG_FSL_ESDHC=y |
| CONFIG_MTD=y |
| CONFIG_MTD_RAW_NAND=y |
| CONFIG_NAND_FSL_IFC=y |
| CONFIG_SYS_NAND_ONFI_DETECTION=y |
| # CONFIG_SPI_FLASH_BAR is not set |
| # CONFIG_SPI_FLASH_USE_4K_SECTORS is not set |
| CONFIG_PHYLIB=y |
| CONFIG_PHY_AQUANTIA=y |
| CONFIG_PHY_REALTEK=y |
| CONFIG_PHY_FIXED=y |
| CONFIG_DM_MDIO=y |
| CONFIG_E1000=y |
| CONFIG_FMAN_ENET=y |
| CONFIG_SYS_FMAN_FW_ADDR=0x900000 |
| CONFIG_NVME_PCI=y |
| CONFIG_PCIE_LAYERSCAPE_RC=y |
| CONFIG_PCIE_LAYERSCAPE_EP=y |
| CONFIG_POWER_LEGACY=y |
| CONFIG_POWER_I2C=y |
| CONFIG_SYS_QE_FMAN_FW_IN_MMC=y |
| CONFIG_DM_SCSI=y |
| CONFIG_DM_SERIAL=y |
| CONFIG_SPL_SYS_NS16550_SERIAL=y |
| CONFIG_SPI=y |
| CONFIG_DM_SPI=y |
| CONFIG_FSL_QSPI=y |
| CONFIG_USB=y |
| CONFIG_USB_XHCI_HCD=y |
| CONFIG_USB_XHCI_DWC3=y |
| CONFIG_EFI_LOADER_BOUNCE_BUFFER=y |