| /* |
| * Copyright (c) 2016 Toradex, Inc. |
| * |
| * SPDX-License-Identifier: GPL-2.0+ |
| */ |
| |
| #include <common.h> |
| #include <asm/arch-tegra/ap.h> |
| #include <asm/gpio.h> |
| #include <asm/io.h> |
| #include <asm/arch/gpio.h> |
| #include <asm/arch/pinmux.h> |
| #include <power/as3722.h> |
| |
| #include "../common/tdx-common.h" |
| #include "pinmux-config-apalis-tk1.h" |
| |
| #define LAN_RESET_N TEGRA_GPIO(S, 2) |
| |
| int arch_misc_init(void) |
| { |
| if (readl(NV_PA_BASE_SRAM + NVBOOTINFOTABLE_BOOTTYPE) == |
| NVBOOTTYPE_RECOVERY) |
| printf("USB recovery mode\n"); |
| |
| return 0; |
| } |
| |
| int checkboard(void) |
| { |
| puts("Model: Toradex Apalis TK1 2GB\n"); |
| |
| return 0; |
| } |
| |
| #if defined(CONFIG_OF_LIBFDT) && defined(CONFIG_OF_BOARD_SETUP) |
| int ft_board_setup(void *blob, bd_t *bd) |
| { |
| return ft_common_board_setup(blob, bd); |
| } |
| #endif |
| |
| /* |
| * Routine: pinmux_init |
| * Description: Do individual peripheral pinmux configs |
| */ |
| void pinmux_init(void) |
| { |
| pinmux_clear_tristate_input_clamping(); |
| |
| gpio_config_table(apalis_tk1_gpio_inits, |
| ARRAY_SIZE(apalis_tk1_gpio_inits)); |
| |
| pinmux_config_pingrp_table(apalis_tk1_pingrps, |
| ARRAY_SIZE(apalis_tk1_pingrps)); |
| |
| pinmux_config_drvgrp_table(apalis_tk1_drvgrps, |
| ARRAY_SIZE(apalis_tk1_drvgrps)); |
| } |
| |
| #ifdef CONFIG_PCI_TEGRA |
| int tegra_pcie_board_init(void) |
| { |
| struct udevice *pmic; |
| int err; |
| |
| err = as3722_init(&pmic); |
| if (err) { |
| error("failed to initialize AS3722 PMIC: %d\n", err); |
| return err; |
| } |
| |
| err = as3722_sd_enable(pmic, 4); |
| if (err < 0) { |
| error("failed to enable SD4: %d\n", err); |
| return err; |
| } |
| |
| err = as3722_sd_set_voltage(pmic, 4, 0x24); |
| if (err < 0) { |
| error("failed to set SD4 voltage: %d\n", err); |
| return err; |
| } |
| |
| err = as3722_gpio_configure(pmic, 1, AS3722_GPIO_OUTPUT_VDDH | |
| AS3722_GPIO_INVERT); |
| if (err < 0) { |
| error("failed to configure GPIO#1 as output: %d\n", err); |
| return err; |
| } |
| |
| err = as3722_gpio_direction_output(pmic, 2, 1); |
| if (err < 0) { |
| error("failed to set GPIO#2 high: %d\n", err); |
| return err; |
| } |
| |
| /* Reset I210 Gigabit Ethernet Controller */ |
| gpio_request(LAN_RESET_N, "LAN_RESET_N"); |
| gpio_direction_output(LAN_RESET_N, 0); |
| |
| /* |
| * Make sure we don't get any back feeding from LAN_WAKE_N resp. |
| * DEV_OFF_N |
| */ |
| gpio_request(TEGRA_GPIO(O, 5), "LAN_WAKE_N"); |
| gpio_direction_output(TEGRA_GPIO(O, 5), 0); |
| |
| gpio_request(TEGRA_GPIO(O, 6), "LAN_DEV_OFF_N"); |
| gpio_direction_output(TEGRA_GPIO(O, 6), 0); |
| |
| /* Make sure LDO9 and LDO10 are initially enabled @ 0V */ |
| err = as3722_ldo_enable(pmic, 9); |
| if (err < 0) { |
| error("failed to enable LDO9: %d\n", err); |
| return err; |
| } |
| err = as3722_ldo_enable(pmic, 10); |
| if (err < 0) { |
| error("failed to enable LDO10: %d\n", err); |
| return err; |
| } |
| err = as3722_ldo_set_voltage(pmic, 9, 0x80); |
| if (err < 0) { |
| error("failed to set LDO9 voltage: %d\n", err); |
| return err; |
| } |
| err = as3722_ldo_set_voltage(pmic, 10, 0x80); |
| if (err < 0) { |
| error("failed to set LDO10 voltage: %d\n", err); |
| return err; |
| } |
| |
| mdelay(100); |
| |
| /* Make sure controller gets enabled by disabling DEV_OFF_N */ |
| gpio_set_value(TEGRA_GPIO(O, 6), 1); |
| |
| /* Enable LDO9 and LDO10 for +V3.3_ETH on patched prototypes */ |
| err = as3722_ldo_set_voltage(pmic, 9, 0xff); |
| if (err < 0) { |
| error("failed to set LDO9 voltage: %d\n", err); |
| return err; |
| } |
| err = as3722_ldo_set_voltage(pmic, 10, 0xff); |
| if (err < 0) { |
| error("failed to set LDO10 voltage: %d\n", err); |
| return err; |
| } |
| |
| mdelay(100); |
| gpio_set_value(LAN_RESET_N, 1); |
| |
| #ifdef APALIS_TK1_PCIE_EVALBOARD_INIT |
| #define PEX_PERST_N TEGRA_GPIO(DD, 1) /* Apalis GPIO7 */ |
| #define RESET_MOCI_CTRL TEGRA_GPIO(U, 4) |
| |
| /* Reset PLX PEX 8605 PCIe Switch plus PCIe devices on Apalis Evaluation |
| Board */ |
| gpio_request(PEX_PERST_N, "PEX_PERST_N"); |
| gpio_request(RESET_MOCI_CTRL, "RESET_MOCI_CTRL"); |
| gpio_direction_output(PEX_PERST_N, 0); |
| gpio_direction_output(RESET_MOCI_CTRL, 0); |
| /* Must be asserted for 100 ms after power and clocks are stable */ |
| mdelay(100); |
| gpio_set_value(PEX_PERST_N, 1); |
| /* Err_5: PEX_REFCLK_OUTpx/nx Clock Outputs is not Guaranteed Until |
| 900 us After PEX_PERST# De-assertion */ |
| mdelay(1); |
| gpio_set_value(RESET_MOCI_CTRL, 1); |
| #endif /* APALIS_T30_PCIE_EVALBOARD_INIT */ |
| |
| return 0; |
| } |
| #endif /* CONFIG_PCI_TEGRA */ |