| /dts-v1/; |
| |
| #include "tegra20.dtsi" |
| |
| / { |
| model = "Toradex Colibri T20"; |
| compatible = "toradex,colibri_t20", "nvidia,tegra20"; |
| |
| chosen { |
| stdout-path = &uarta; |
| }; |
| |
| aliases { |
| i2c0 = "/i2c@7000d000"; |
| i2c1 = "/i2c@7000c000"; |
| i2c2 = "/i2c@7000c400"; |
| usb0 = "/usb@c5008000"; |
| usb1 = "/usb@c5000000"; |
| usb2 = "/usb@c5004000"; |
| mmc0 = "/sdhci@c8000600"; |
| }; |
| |
| host1x@50000000 { |
| status = "okay"; |
| dc@54200000 { |
| status = "okay"; |
| rgb { |
| status = "okay"; |
| nvidia,panel = <&lcd_panel>; |
| }; |
| }; |
| }; |
| |
| usb@c5000000 { |
| statuc = "okay"; |
| dr_mode = "otg"; |
| }; |
| |
| usb@c5004000 { |
| statuc = "okay"; |
| /* VBUS_LAN */ |
| nvidia,phy-reset-gpio = <&gpio TEGRA_GPIO(V, 1) GPIO_ACTIVE_HIGH>; |
| nvidia,vbus-gpio = <&gpio TEGRA_GPIO(BB, 1) GPIO_ACTIVE_HIGH>; |
| }; |
| |
| usb@c5008000 { |
| statuc = "okay"; |
| /* USBH_PEN */ |
| nvidia,vbus-gpio = <&gpio TEGRA_GPIO(W, 2) GPIO_ACTIVE_LOW>; |
| }; |
| |
| nand-controller@70008000 { |
| nvidia,wp-gpios = <&gpio TEGRA_GPIO(S, 0) GPIO_ACTIVE_HIGH>; |
| nvidia,width = <8>; |
| nvidia,timing = <15 100 25 80 25 10 15 10 100>; |
| |
| nand@0 { |
| reg = <0>; |
| compatible = "nand-flash"; |
| }; |
| }; |
| |
| /* |
| * GEN1_I2C: I2C_SDA/SCL on SODIMM pin 194/196 (e.g. RTC on carrier |
| * board) |
| */ |
| i2c@7000c000 { |
| status = "okay"; |
| clock-frequency = <100000>; |
| }; |
| |
| /* GEN2_I2C: unused */ |
| |
| /* DDC_CLOCK/DATA on X3 pin 15/16 (e.g. display EDID) */ |
| i2c@7000c400 { |
| status = "okay"; |
| clock-frequency = <100000>; |
| }; |
| |
| /* |
| * PWR_I2C: power I2C to PMIC and temperature sensor |
| */ |
| i2c@7000d000 { |
| status = "okay"; |
| clock-frequency = <100000>; |
| }; |
| |
| sdhci@c8000600 { |
| status = "okay"; |
| bus-width = <4>; |
| cd-gpios = <&gpio TEGRA_GPIO(C, 7) GPIO_ACTIVE_LOW>; |
| }; |
| |
| clocks { |
| compatible = "simple-bus"; |
| #address-cells = <1>; |
| #size-cells = <0>; |
| |
| clk32k_in: clock@0 { |
| compatible = "fixed-clock"; |
| reg=<0>; |
| #clock-cells = <0>; |
| clock-frequency = <32768>; |
| }; |
| }; |
| |
| pwm: pwm@7000a000 { |
| status = "okay"; |
| }; |
| |
| lcd_panel: panel { |
| clock = <25175000>; |
| xres = <640>; |
| yres = <480>; |
| left-margin = <48>; /* horizontal back porch */ |
| right-margin = <16>; /* horizontal front porch */ |
| hsync-len = <96>; |
| lower-margin = <11>; /* vertical front porch */ |
| upper-margin = <31>; /* vertical back porch */ |
| vsync-len = <2>; |
| hsync-active-high; |
| vsync-active-high; |
| nvidia,bits-per-pixel = <16>; |
| nvidia,pwm = <&pwm 0 0>; |
| nvidia,backlight-enable-gpios = <&gpio TEGRA_GPIO(T, 4) GPIO_ACTIVE_HIGH>; |
| nvidia,panel-timings = <0 0 0 0>; |
| }; |
| }; |