| # SPDX-License-Identifier: GPL-2.0+ |
| # Copyright (c) 2016 Toradex, Inc. |
| |
| menuconfig TDX_CFG_BLOCK |
| bool "Enable Toradex config block support" |
| select OF_BOARD_SETUP |
| help |
| The Toradex config block stored production data on the on-module |
| flash device (NAND, NOR or eMMC). The area is normally preserved by |
| software and contains the serial number (out of which the MAC |
| address is generated) and the exact module type. |
| |
| # Helper config to determine the correct default location of the cfg block |
| config TDX_HAVE_MMC |
| bool |
| |
| config TDX_HAVE_NAND |
| bool |
| |
| config TDX_HAVE_NOR |
| bool |
| |
| config TDX_HAVE_EEPROM |
| bool |
| |
| config TDX_HAVE_EEPROM_EXTRA |
| bool |
| |
| if TDX_CFG_BLOCK |
| |
| config TDX_CFG_BLOCK_IS_IN_MMC |
| bool |
| depends on TDX_HAVE_MMC |
| default y |
| |
| config TDX_CFG_BLOCK_IS_IN_NAND |
| bool |
| depends on TDX_HAVE_NAND |
| default y |
| |
| config TDX_CFG_BLOCK_IS_IN_NOR |
| bool |
| depends on TDX_HAVE_NOR |
| default y |
| |
| config TDX_CFG_BLOCK_IS_IN_EEPROM |
| bool |
| depends on TDX_HAVE_EEPROM |
| default y |
| |
| config TDX_CFG_BLOCK_DEV |
| int "Toradex config block eMMC device ID" |
| depends on TDX_CFG_BLOCK_IS_IN_MMC |
| |
| config TDX_CFG_BLOCK_PART |
| int "Toradex config block eMMC partition ID" |
| depends on TDX_CFG_BLOCK_IS_IN_MMC |
| |
| config TDX_CFG_BLOCK_OFFSET |
| int "Toradex config block offset" |
| help |
| Specify the byte offset of the Toradex config block within the flash |
| device the config block is stored on. |
| |
| config TDX_CFG_BLOCK_OFFSET2 |
| int "Toradex config block offset, second instance" |
| default 0 |
| help |
| Specify the byte offset of the 2nd instance of the Toradex config block |
| within the flash device the config block is stored on. |
| Set to 0 on modules which have no 2nd instance. |
| |
| config TDX_CFG_BLOCK_2ND_ETHADDR |
| bool "Set the second Ethernet address" |
| help |
| For each serial number two Ethernet addresses are available for dual |
| Ethernet carrier boards. This options enables the code to set the |
| second Ethernet address as environment variable (eth1addr). |
| |
| config TDX_CFG_BLOCK_EXTRA |
| bool "Support for additional EEPROMs (carrier board, display adapter)" |
| depends on TDX_HAVE_EEPROM_EXTRA |
| help |
| Enables fetching auxilary config blocks from carrier board/display |
| adapter EEPROMs. |
| |
| endif |