| // SPDX-License-Identifier: GPL-2.0+ |
| /* |
| * (C) Copyright 2000-2003 |
| * Wolfgang Denk, DENX Software Engineering, wd@denx.de. |
| * |
| * Copyright (C) 2004-2007, 2012 Freescale Semiconductor, Inc. |
| * TsiChung Liew (Tsi-Chung.Liew@freescale.com) |
| */ |
| |
| #include <common.h> |
| #include <init.h> |
| #include <pci.h> |
| #include <asm/immap.h> |
| #include <asm/io.h> |
| #include <linux/delay.h> |
| |
| DECLARE_GLOBAL_DATA_PTR; |
| |
| int checkboard(void) |
| { |
| puts("Board: "); |
| puts("Freescale M54455 EVB\n"); |
| return 0; |
| }; |
| |
| int dram_init(void) |
| { |
| u32 dramsize; |
| #ifdef CONFIG_CF_SBF |
| /* |
| * Serial Boot: The dram is already initialized in start.S |
| * only require to return DRAM size |
| */ |
| dramsize = CONFIG_SYS_SDRAM_SIZE * 0x100000 >> 1; |
| #else |
| sdramc_t *sdram = (sdramc_t *)(MMAP_SDRAM); |
| gpio_t *gpio = (gpio_t *)(MMAP_GPIO); |
| u32 i; |
| |
| dramsize = CONFIG_SYS_SDRAM_SIZE * 0x100000 >> 1; |
| |
| for (i = 0x13; i < 0x20; i++) { |
| if (dramsize == (1 << i)) |
| break; |
| } |
| i--; |
| |
| out_8(&gpio->mscr_sdram, CONFIG_SYS_SDRAM_DRV_STRENGTH); |
| |
| out_be32(&sdram->sdcs0, CONFIG_SYS_SDRAM_BASE | i); |
| out_be32(&sdram->sdcs1, CONFIG_SYS_SDRAM_BASE1 | i); |
| |
| out_be32(&sdram->sdcfg1, CONFIG_SYS_SDRAM_CFG1); |
| out_be32(&sdram->sdcfg2, CONFIG_SYS_SDRAM_CFG2); |
| |
| /* Issue PALL */ |
| out_be32(&sdram->sdcr, CONFIG_SYS_SDRAM_CTRL | 2); |
| |
| /* Issue LEMR */ |
| out_be32(&sdram->sdmr, CONFIG_SYS_SDRAM_EMOD | 0x408); |
| out_be32(&sdram->sdmr, CONFIG_SYS_SDRAM_MODE | 0x300); |
| |
| udelay(500); |
| |
| /* Issue PALL */ |
| out_be32(&sdram->sdcr, CONFIG_SYS_SDRAM_CTRL | 2); |
| |
| /* Perform two refresh cycles */ |
| out_be32(&sdram->sdcr, CONFIG_SYS_SDRAM_CTRL | 4); |
| out_be32(&sdram->sdcr, CONFIG_SYS_SDRAM_CTRL | 4); |
| |
| out_be32(&sdram->sdmr, CONFIG_SYS_SDRAM_MODE | 0x200); |
| |
| out_be32(&sdram->sdcr, |
| (CONFIG_SYS_SDRAM_CTRL & ~0x80000000) | 0x10000c00); |
| |
| udelay(100); |
| #endif |
| gd->ram_size = dramsize << 1; |
| |
| return 0; |
| }; |
| |
| int testdram(void) |
| { |
| /* TODO: XXX XXX XXX */ |
| printf("DRAM test not implemented!\n"); |
| |
| return (0); |
| } |
| |
| #if defined(CONFIG_IDE) |
| #include <ata.h> |
| |
| int ide_preinit(void) |
| { |
| gpio_t *gpio = (gpio_t *) MMAP_GPIO; |
| u32 tmp; |
| |
| tmp = (in_8(&gpio->par_fec) & GPIO_PAR_FEC_FEC1_UNMASK) | 0x10; |
| setbits_8(&gpio->par_fec, tmp); |
| tmp = ((in_be16(&gpio->par_feci2c) & 0xf0ff) | |
| (GPIO_PAR_FECI2C_MDC1_ATA_DIOR | GPIO_PAR_FECI2C_MDIO1_ATA_DIOW)); |
| setbits_be16(&gpio->par_feci2c, tmp); |
| |
| setbits_be16(&gpio->par_ata, |
| GPIO_PAR_ATA_BUFEN | GPIO_PAR_ATA_CS1 | GPIO_PAR_ATA_CS0 | |
| GPIO_PAR_ATA_DA2 | GPIO_PAR_ATA_DA1 | GPIO_PAR_ATA_DA0 | |
| GPIO_PAR_ATA_RESET_RESET | GPIO_PAR_ATA_DMARQ_DMARQ | |
| GPIO_PAR_ATA_IORDY_IORDY); |
| setbits_be16(&gpio->par_pci, |
| GPIO_PAR_PCI_GNT3_ATA_DMACK | GPIO_PAR_PCI_REQ3_ATA_INTRQ); |
| |
| return (0); |
| } |
| |
| void ide_set_reset(int idereset) |
| { |
| atac_t *ata = (atac_t *) MMAP_ATA; |
| long period; |
| /* t1, t2, t3, t4, t5, t6, t9, tRD, tA */ |
| int piotms[5][9] = { |
| {70, 165, 60, 30, 50, 5, 20, 0, 35}, /* PIO 0 */ |
| {50, 125, 45, 20, 35, 5, 15, 0, 35}, /* PIO 1 */ |
| {30, 100, 30, 15, 20, 5, 10, 0, 35}, /* PIO 2 */ |
| {30, 80, 30, 10, 20, 5, 10, 0, 35}, /* PIO 3 */ |
| {25, 70, 20, 10, 20, 5, 10, 0, 35} |
| }; /* PIO 4 */ |
| |
| if (idereset) { |
| /* control reset */ |
| out_8(&ata->cr, 0); |
| udelay(10000); |
| } else { |
| #define CALC_TIMING(t) (t + period - 1) / period |
| period = 1000000000 / gd->bus_clk; /* period in ns */ |
| |
| /*ata->ton = CALC_TIMING (180); */ |
| out_8(&ata->t1, CALC_TIMING(piotms[2][0])); |
| out_8(&ata->t2w, CALC_TIMING(piotms[2][1])); |
| out_8(&ata->t2r, CALC_TIMING(piotms[2][1])); |
| out_8(&ata->ta, CALC_TIMING(piotms[2][8])); |
| out_8(&ata->trd, CALC_TIMING(piotms[2][7])); |
| out_8(&ata->t4, CALC_TIMING(piotms[2][3])); |
| out_8(&ata->t9, CALC_TIMING(piotms[2][6])); |
| |
| /* IORDY enable */ |
| out_8(&ata->cr, 0x40); |
| udelay(200000); |
| /* IORDY enable */ |
| setbits_8(&ata->cr, 0x01); |
| } |
| } |
| #endif |
| |
| #if defined(CONFIG_PCI) |
| /* |
| * Initialize PCI devices, report devices found. |
| */ |
| static struct pci_controller hose; |
| extern void pci_mcf5445x_init(struct pci_controller *hose); |
| |
| void pci_init_board(void) |
| { |
| pci_mcf5445x_init(&hose); |
| } |
| #endif /* CONFIG_PCI */ |
| |
| #if defined(CONFIG_FLASH_CFI_LEGACY) |
| #include <flash.h> |
| ulong board_flash_get_legacy (ulong base, int banknum, flash_info_t * info) |
| { |
| int sect[] = CONFIG_SYS_ATMEL_SECT; |
| int sectsz[] = CONFIG_SYS_ATMEL_SECTSZ; |
| int i, j, k; |
| |
| if (base != CONFIG_SYS_ATMEL_BASE) |
| return 0; |
| |
| info->flash_id = 0x01000000; |
| info->portwidth = 1; |
| info->chipwidth = 1; |
| info->buffer_size = 1; |
| info->erase_blk_tout = 16384; |
| info->write_tout = 2; |
| info->buffer_write_tout = 5; |
| info->vendor = 0xFFF0; /* CFI_CMDSET_AMD_LEGACY */ |
| info->cmd_reset = 0x00F0; |
| info->interface = FLASH_CFI_X8; |
| info->legacy_unlock = 0; |
| info->manufacturer_id = (u16) ATM_MANUFACT; |
| info->device_id = ATM_ID_LV040; |
| info->device_id2 = 0; |
| |
| info->ext_addr = 0; |
| info->cfi_version = 0x3133; |
| info->cfi_offset = 0x0000; |
| info->addr_unlock1 = 0x00000555; |
| info->addr_unlock2 = 0x000002AA; |
| info->name = "CFI conformant"; |
| |
| info->size = 0; |
| info->sector_count = CONFIG_SYS_ATMEL_TOTALSECT; |
| info->start[0] = base; |
| for (k = 0, i = 0; i < CONFIG_SYS_ATMEL_REGION; i++) { |
| info->size += sect[i] * sectsz[i]; |
| |
| for (j = 0; j < sect[i]; j++, k++) { |
| info->start[k + 1] = info->start[k] + sectsz[i]; |
| info->protect[k] = 0; |
| } |
| } |
| |
| return 1; |
| } |
| #endif /* CONFIG_SYS_FLASH_CFI */ |