| // SPDX-License-Identifier: GPL-2.0+ |
| /* |
| * (C) Copyright 2016 Rockchip Electronics Co., Ltd |
| */ |
| |
| /dts-v1/; |
| #include "rk3328.dtsi" |
| |
| / { |
| model = "Rockchip RK3328 EVB"; |
| compatible = "rockchip,rk3328-evb", "rockchip,rk3328"; |
| |
| chosen { |
| stdout-path = &uart2; |
| }; |
| |
| gmac_clkin: external-gmac-clock { |
| compatible = "fixed-clock"; |
| clock-frequency = <125000000>; |
| clock-output-names = "gmac_clkin"; |
| #clock-cells = <0>; |
| }; |
| |
| vcc3v3_sdmmc: sdmmc-pwren { |
| compatible = "regulator-fixed"; |
| regulator-name = "vcc3v3"; |
| gpio = <&gpio0 30 GPIO_ACTIVE_LOW>; |
| regulator-always-on; |
| regulator-boot-on; |
| }; |
| |
| vcc5v0_otg: vcc5v0-otg-drv { |
| compatible = "regulator-fixed"; |
| enable-active-high; |
| regulator-name = "vcc5v0_otg"; |
| gpio = <&gpio0 27 GPIO_ACTIVE_HIGH>; |
| regulator-min-microvolt = <5000000>; |
| regulator-max-microvolt = <5000000>; |
| }; |
| |
| vcc5v0_host_xhci: vcc5v0-host-xhci-drv { |
| compatible = "regulator-fixed"; |
| enable-active-high; |
| regulator-name = "vcc5v0_host_xhci"; |
| gpio = <&gpio0 0 GPIO_ACTIVE_HIGH>; |
| regulator-min-microvolt = <5000000>; |
| regulator-max-microvolt = <5000000>; |
| }; |
| |
| vcc_phy: vcc-phy-regulator { |
| compatible = "regulator-fixed"; |
| regulator-name = "vcc_phy"; |
| regulator-always-on; |
| regulator-boot-on; |
| }; |
| }; |
| |
| &saradc { |
| status = "okay"; |
| }; |
| |
| &uart2 { |
| status = "okay"; |
| }; |
| |
| &sdmmc { |
| bus-width = <4>; |
| cap-mmc-highspeed; |
| cap-sd-highspeed; |
| card-detect-delay = <200>; |
| disable-wp; |
| num-slots = <1>; |
| pinctrl-names = "default"; |
| pinctrl-0 = <&sdmmc0_clk>, <&sdmmc0_cmd>, <&sdmmc0_dectn>, <&sdmmc0_bus4>; |
| status = "okay"; |
| }; |
| |
| &emmc { |
| bus-width = <8>; |
| cap-mmc-highspeed; |
| supports-emmc; |
| disable-wp; |
| non-removable; |
| num-slots = <1>; |
| pinctrl-names = "default"; |
| pinctrl-0 = <&emmc_clk &emmc_cmd &emmc_bus8>; |
| status = "okay"; |
| }; |
| |
| &gmac2io { |
| phy-supply = <&vcc_phy>; |
| phy-mode = "rgmii"; |
| clock_in_out = "input"; |
| snps,reset-gpio = <&gpio1 RK_PC2 GPIO_ACTIVE_LOW>; |
| snps,reset-active-low; |
| snps,reset-delays-us = <0 10000 50000>; |
| assigned-clocks = <&cru SCLK_MAC2IO>, <&cru SCLK_MAC2IO_EXT>; |
| assigned-clock-parents = <&gmac_clkin>, <&gmac_clkin>; |
| pinctrl-names = "default"; |
| pinctrl-0 = <&rgmiim1_pins>; |
| tx_delay = <0x26>; |
| rx_delay = <0x11>; |
| status = "okay"; |
| }; |
| |
| &usb_host0_ehci { |
| status = "okay"; |
| }; |
| |
| &usb_host0_ohci { |
| status = "okay"; |
| }; |
| |
| &usb20_otg { |
| vbus-supply = <&vcc5v0_otg>; |
| status = "okay"; |
| }; |
| |
| &usb_host0_xhci { |
| vbus-supply = <&vcc5v0_host_xhci>; |
| status = "okay"; |
| }; |
| |
| &i2c1 { |
| clock-frequency = <400000>; |
| i2c-scl-rising-time-ns = <168>; |
| i2c-scl-falling-time-ns = <4>; |
| status = "okay"; |
| |
| rk805: pmic@18 { |
| compatible = "rockchip,rk805"; |
| status = "okay"; |
| reg = <0x18>; |
| interrupt-parent = <&gpio2>; |
| interrupts = <6 IRQ_TYPE_LEVEL_LOW>; |
| pinctrl-names = "default"; |
| pinctrl-0 = <&pmic_int_l>; |
| rockchip,system-power-controller; |
| wakeup-source; |
| gpio-controller; |
| #gpio-cells = <2>; |
| #clock-cells = <1>; |
| clock-output-names = "xin32k", "rk805-clkout2"; |
| |
| regulators { |
| vdd_logic: DCDC_REG1 { |
| regulator-name = "vdd_logic"; |
| regulator-min-microvolt = <712500>; |
| regulator-max-microvolt = <1450000>; |
| regulator-ramp-delay = <6001>; |
| regulator-boot-on; |
| regulator-always-on; |
| regulator-state-mem { |
| regulator-on-in-suspend; |
| regulator-suspend-microvolt = <1000000>; |
| }; |
| }; |
| |
| vdd_arm: DCDC_REG2 { |
| regulator-name = "vdd_arm"; |
| regulator-min-microvolt = <712500>; |
| regulator-max-microvolt = <1450000>; |
| regulator-ramp-delay = <6001>; |
| regulator-boot-on; |
| regulator-always-on; |
| regulator-state-mem { |
| regulator-on-in-suspend; |
| regulator-suspend-microvolt = <1000000>; |
| }; |
| }; |
| |
| vcc_ddr: DCDC_REG3 { |
| regulator-name = "vcc_ddr"; |
| regulator-boot-on; |
| regulator-always-on; |
| regulator-state-mem { |
| regulator-on-in-suspend; |
| }; |
| }; |
| |
| vcc_io: DCDC_REG4 { |
| regulator-name = "vcc_io"; |
| regulator-min-microvolt = <3300000>; |
| regulator-max-microvolt = <3300000>; |
| regulator-boot-on; |
| regulator-always-on; |
| regulator-state-mem { |
| regulator-on-in-suspend; |
| regulator-suspend-microvolt = <3300000>; |
| }; |
| }; |
| |
| vdd_18: LDO_REG1 { |
| regulator-name = "vdd_18"; |
| regulator-min-microvolt = <1800000>; |
| regulator-max-microvolt = <1800000>; |
| regulator-boot-on; |
| regulator-always-on; |
| regulator-state-mem { |
| regulator-on-in-suspend; |
| regulator-suspend-microvolt = <1800000>; |
| }; |
| }; |
| |
| vcc_18emmc: LDO_REG2 { |
| regulator-name = "vcc_18emmc"; |
| regulator-min-microvolt = <1800000>; |
| regulator-max-microvolt = <1800000>; |
| regulator-boot-on; |
| regulator-always-on; |
| regulator-state-mem { |
| regulator-on-in-suspend; |
| regulator-suspend-microvolt = <1800000>; |
| }; |
| }; |
| |
| vdd_10: LDO_REG3 { |
| regulator-name = "vdd_10"; |
| regulator-min-microvolt = <1000000>; |
| regulator-max-microvolt = <1000000>; |
| regulator-boot-on; |
| regulator-always-on; |
| regulator-state-mem { |
| regulator-on-in-suspend; |
| regulator-suspend-microvolt = <1000000>; |
| }; |
| }; |
| }; |
| }; |
| }; |
| |
| &pinctrl { |
| pmic { |
| pmic_int_l: pmic-int-l { |
| rockchip,pins = |
| <2 RK_PA6 RK_FUNC_GPIO &pcfg_pull_up>; /* gpio2_a6 */ |
| }; |
| }; |
| }; |
| |