| CONFIG_ARM=y |
| CONFIG_ARCH_MX6=y |
| CONFIG_TEXT_BASE=0x87800000 |
| CONFIG_SYS_MALLOC_LEN=0x0200000 |
| CONFIG_SPL_LIBCOMMON_SUPPORT=y |
| CONFIG_SPL_LIBGENERIC_SUPPORT=y |
| CONFIG_NR_DRAM_BANKS=8 |
| CONFIG_ENV_SIZE=0x4000 |
| CONFIG_ENV_OFFSET=0x3c00000 |
| CONFIG_MX6ULL=y |
| CONFIG_TARGET_NPI_IMX6ULL=y |
| CONFIG_DEFAULT_DEVICE_TREE="imx6ull-seeed-npi-imx6ull-dev-board" |
| CONFIG_SPL_TEXT_BASE=0x908000 |
| CONFIG_SPL_MMC=y |
| CONFIG_SPL_SERIAL=y |
| CONFIG_SPL=y |
| CONFIG_SYS_MEMTEST_START=0x80000000 |
| CONFIG_SYS_MEMTEST_END=0x90000000 |
| CONFIG_DISTRO_DEFAULTS=y |
| CONFIG_SYS_MONITOR_LEN=409600 |
| CONFIG_FIT=y |
| CONFIG_BOOTDELAY=3 |
| CONFIG_BOARD_EARLY_INIT_F=y |
| CONFIG_SYS_SPL_MALLOC=y |
| CONFIG_SPL_DMA=y |
| CONFIG_SPL_NAND_SUPPORT=y |
| CONFIG_SPL_USB_HOST=y |
| CONFIG_SPL_USB_GADGET=y |
| CONFIG_SPL_WATCHDOG=y |
| CONFIG_SYS_MAXARGS=32 |
| CONFIG_SYS_PBSIZE=532 |
| CONFIG_CMD_MEMTEST=y |
| CONFIG_CMD_DM=y |
| CONFIG_CMD_GPIO=y |
| CONFIG_CMD_GPT=y |
| # CONFIG_RANDOM_UUID is not set |
| CONFIG_CMD_MMC=y |
| CONFIG_CMD_MTD=y |
| CONFIG_CMD_USB=y |
| CONFIG_CMD_CACHE=y |
| CONFIG_CMD_MTDPARTS=y |
| CONFIG_MTDIDS_DEFAULT="nand0=gpmi-nand" |
| CONFIG_MTDPARTS_DEFAULT="gpmi-nand:512k(spl),1m(uboot),1m(uboot-dup),-(ubi)" |
| CONFIG_CMD_UBI=y |
| # CONFIG_ISO_PARTITION is not set |
| CONFIG_OF_CONTROL=y |
| CONFIG_ENV_IS_IN_MMC=y |
| CONFIG_SYS_RELOC_GD_ENV_ADDR=y |
| CONFIG_USE_ETHPRIME=y |
| CONFIG_ETHPRIME="eth0" |
| CONFIG_NET_RANDOM_ETHADDR=y |
| CONFIG_FSL_USDHC=y |
| CONFIG_MTD=y |
| CONFIG_DM_MTD=y |
| CONFIG_MTD_RAW_NAND=y |
| CONFIG_SYS_NAND_USE_FLASH_BBT=y |
| CONFIG_NAND_MXS=y |
| CONFIG_NAND_MXS_DT=y |
| CONFIG_SYS_NAND_U_BOOT_LOCATIONS=y |
| CONFIG_SYS_NAND_U_BOOT_OFFS=0x80000 |
| CONFIG_SYS_NAND_U_BOOT_OFFS_REDUND=0x180000 |
| CONFIG_PHYLIB=y |
| CONFIG_PHY_MICREL=y |
| CONFIG_PHY_MICREL_KSZ8XXX=y |
| CONFIG_FEC_MXC=y |
| CONFIG_MII=y |
| CONFIG_PINCTRL=y |
| CONFIG_PINCTRL_IMX6=y |
| CONFIG_DM_PMIC=y |
| CONFIG_DM_REGULATOR=y |
| CONFIG_DM_REGULATOR_FIXED=y |
| CONFIG_DM_REGULATOR_GPIO=y |
| CONFIG_MXC_UART=y |
| CONFIG_IMX_THERMAL=y |
| CONFIG_USB=y |
| CONFIG_USB_GADGET=y |