| // SPDX-License-Identifier: GPL-2.0+ |
| /* |
| * Hitachi tx18d42vm LVDS LCD panel driver |
| * |
| * (C) Copyright 2015 Hans de Goede <hdegoede@redhat.com> |
| */ |
| |
| #include <common.h> |
| #include <malloc.h> |
| #include <linux/delay.h> |
| |
| #include <asm/gpio.h> |
| #include <errno.h> |
| |
| /* |
| * Very simple write only SPI support, this does not use the generic SPI infra |
| * because that assumes R/W SPI, requiring a MISO pin. Also the necessary glue |
| * code alone would be larger then this minimal version. |
| */ |
| static void lcd_panel_spi_write(int cs, int clk, int mosi, |
| unsigned int data, int bits) |
| { |
| int i, offset; |
| |
| gpio_direction_output(cs, 0); |
| for (i = 0; i < bits; i++) { |
| gpio_direction_output(clk, 0); |
| offset = (bits - 1) - i; |
| gpio_direction_output(mosi, (data >> offset) & 1); |
| udelay(2); |
| gpio_direction_output(clk, 1); |
| udelay(2); |
| } |
| gpio_direction_output(cs, 1); |
| udelay(2); |
| } |
| |
| int hitachi_tx18d42vm_init(void) |
| { |
| const u16 init_data[] = { |
| 0x0029, /* reset */ |
| 0x0025, /* standby */ |
| 0x0840, /* enable normally black */ |
| 0x0430, /* enable FRC/dither */ |
| 0x385f, /* enter test mode(1) */ |
| 0x3ca4, /* enter test mode(2) */ |
| 0x3409, /* enable SDRRS, enlarge OE width */ |
| 0x4041, /* adopt 2 line / 1 dot */ |
| }; |
| int i, cs, clk, mosi, ret = 0; |
| |
| cs = sunxi_name_to_gpio(CONFIG_VIDEO_LCD_SPI_CS); |
| clk = sunxi_name_to_gpio(CONFIG_VIDEO_LCD_SPI_SCLK); |
| mosi = sunxi_name_to_gpio(CONFIG_VIDEO_LCD_SPI_MOSI); |
| |
| if (cs == -1 || clk == -1 || mosi == 1) { |
| printf("Error tx18d42vm spi gpio config is invalid\n"); |
| return -EINVAL; |
| } |
| |
| if (gpio_request(cs, "tx18d42vm-spi-cs") != 0 || |
| gpio_request(clk, "tx18d42vm-spi-clk") != 0 || |
| gpio_request(mosi, "tx18d42vm-spi-mosi") != 0) { |
| printf("Error cannot request tx18d42vm spi gpios\n"); |
| ret = -EBUSY; |
| goto out; |
| } |
| |
| for (i = 0; i < ARRAY_SIZE(init_data); i++) |
| lcd_panel_spi_write(cs, clk, mosi, init_data[i], 16); |
| |
| mdelay(50); /* All the tx18d42vm drivers have a delay here ? */ |
| |
| lcd_panel_spi_write(cs, clk, mosi, 0x00ad, 16); /* display on */ |
| |
| out: |
| gpio_free(mosi); |
| gpio_free(clk); |
| gpio_free(cs); |
| |
| return ret; |
| } |