| .. SPDX-License-Identifier: GPL-2.0+: |
| |
| cp command |
| ========== |
| |
| Synopsis |
| -------- |
| |
| :: |
| |
| cp source target count |
| cp.b source target count |
| cp.w source target count |
| cp.l source target count |
| cp.q source target count |
| |
| Description |
| ----------- |
| |
| The cp command is used to copy *count* chunks of memory from the *source* |
| address to the *target* address. If the *target* address points to NOR flash, |
| the flash is programmed. |
| |
| The number bytes in one chunk is defined by the suffix defaulting to 4 bytes: |
| |
| ====== ========== |
| suffix chunk size |
| ====== ========== |
| .b 1 byte |
| .w 2 bytes |
| .l 4 bytes |
| .q 8 bytes |
| <none> 4 bytes |
| ====== ========== |
| |
| source |
| source address, hexadecimal |
| |
| target |
| target address, hexadecimal |
| |
| count |
| number of words to be copied, hexadecimal |
| |
| Examples |
| -------- |
| |
| The example device has a NOR flash where the lower part of the flash is |
| protected. We first copy to RAM, then to unprotected flash. Last we try to |
| write to protectd flash. |
| |
| :: |
| |
| => mtd list |
| List of MTD devices: |
| * nor0 |
| - device: flash@0 |
| - parent: root_driver |
| - driver: cfi_flash |
| - path: /flash@0 |
| - type: NOR flash |
| - block size: 0x20000 bytes |
| - min I/O: 0x1 bytes |
| - 0x000000000000-0x000002000000 : "nor0" |
| => cp.b 4020000 5000000 200000 |
| => cp.b 4020000 1e00000 20000 |
| Copy to Flash... done |
| => cp.b 4020000 0 20000 |
| Copy to Flash... Can't write to protected Flash sectors |
| => |
| |
| Configuration |
| ------------- |
| |
| The cp command is available if CONFIG_CMD_MEMORY=y. Support for 64 bit words |
| (cp.q) depends on CONFIG_MEM_SUPPORT_64BIT_DATA=y. Copying to flash depends on |
| CONFIG_MTD_NOR_FLASH=y. |
| |
| Return value |
| ------------ |
| |
| The return value $? is set to 0 (true) if the command was successfully, |
| 1 (false) otherwise. |