| // SPDX-License-Identifier: GPL-2.0+ OR X11 |
| /* |
| * Copyright 2019 Collabora Ltd |
| * Copyright 2019 General Electric Company |
| */ |
| |
| / { |
| bootcount { |
| compatible = "u-boot,bootcount-i2c-eeprom"; |
| i2c-eeprom = <&bootcount>; |
| }; |
| |
| wdt-reboot { |
| compatible = "wdt-reboot"; |
| wdt = <&wdog1>; |
| }; |
| |
| panel-lvds0 { |
| compatible = "simple-panel"; |
| }; |
| }; |
| |
| &eeprom { |
| partitions { |
| compatible = "fixed-partitions"; |
| #address-cells = <1>; |
| #size-cells = <1>; |
| |
| vpd@0 { |
| reg = <0 800>; |
| }; |
| |
| bootcount: bootcount { |
| reg = <1022 2>; |
| }; |
| }; |
| }; |
| |
| /* |
| * This is not done in imx6q-ba16.dtsi, since that file is shared |
| * with the kernel and the kernel should not reset the PHY, since |
| * it lacks support for configuring the reserved registeres to |
| * avoid a board specific voltage peak issue. |
| */ |
| &fec { |
| phy-reset-gpios = <&gpio1 28 GPIO_ACTIVE_LOW>; |
| phy-reset-duration = <1>; |
| phy-reset-post-delay = <0>; |
| }; |