| config BLK |
| bool "Support block devices" |
| depends on DM |
| default y if DM_MMC |
| help |
| Enable support for block devices, such as SCSI, MMC and USB |
| flash sticks. These provide a block-level interface which permits |
| reading, writing and (in some cases) erasing blocks. Block |
| devices often have a partition table which allows the device to |
| be partitioned into several areas, called 'partitions' in U-Boot. |
| A filesystem can be placed in each partition. |
| |
| config AHCI |
| bool "Support SATA controllers with driver model" |
| depends on DM |
| help |
| This enables a uclass for disk controllers in U-Boot. Various driver |
| types can use this, such as AHCI/SATA. It does not provide any standard |
| operations at present. The block device interface has not been converted |
| to driver model. |
| |
| config SCSI |
| bool "Support SCSI controllers" |
| help |
| This enables support for SCSI (Small Computer System Interface), |
| a parallel interface widely used with storage peripherals such as |
| hard drives and optical drives. The SCSI standards define physical |
| interfaces as well as protocols for controlling devices and |
| tranferring data. |
| |
| config DM_SCSI |
| bool "Support SCSI controllers with driver model" |
| depends on BLK |
| help |
| This option enables the SCSI (Small Computer System Interface) uclass |
| which supports SCSI and SATA HDDs. For every device configuration |
| (IDs/LUNs) a block device is created with RAW read/write and |
| filesystem support. |
| |
| config BLOCK_CACHE |
| bool "Use block device cache" |
| default n |
| help |
| This option enables a disk-block cache for all block devices. |
| This is most useful when accessing filesystems under U-Boot since |
| it will prevent repeated reads from directory structures and other |
| filesystem data structures. |
| |
| menu "SATA/SCSI device support" |
| |
| config SATA_CEVA |
| bool "Ceva Sata controller" |
| depends on AHCI |
| depends on DM_SCSI |
| help |
| This option enables Ceva Sata controller hard IP available on Xilinx |
| ZynqMP. Support up to 2 external devices. Complient with SATA 3.1 and |
| AHCI 1.3 specifications with hot-plug detect feature. |
| |
| |
| config DWC_AHCI |
| bool "Enable Synopsys DWC AHCI driver support" |
| select SCSI_AHCI |
| select PHY |
| depends on DM_SCSI |
| help |
| Enable this driver to support Sata devices through |
| Synopsys DWC AHCI module. |
| |
| endmenu |
| |
| config IDE |
| bool "Support IDE controllers" |
| help |
| Enables support for IDE (Integrated Drive Electronics) hard drives. |
| This allows access to raw blocks and filesystems on an IDE drive |
| from U-Boot. See also CMD_IDE which provides an 'ide' command for |
| performing various IDE operations. |