| // SPDX-License-Identifier: GPL-2.0+ |
| /* |
| * K3: Architecture initialization |
| * |
| * Copyright (C) 2017-2018 Texas Instruments Incorporated - http://www.ti.com/ |
| * Lokesh Vutla <lokeshvutla@ti.com> |
| */ |
| |
| #include <common.h> |
| #include <asm/io.h> |
| #include <spl.h> |
| #include <asm/arch/hardware.h> |
| |
| #ifdef CONFIG_SPL_BUILD |
| static void mmr_unlock(u32 base, u32 partition) |
| { |
| /* Translate the base address */ |
| phys_addr_t part_base = base + partition * CTRL_MMR0_PARTITION_SIZE; |
| |
| /* Unlock the requested partition if locked using two-step sequence */ |
| writel(CTRLMMR_LOCK_KICK0_UNLOCK_VAL, part_base + CTRLMMR_LOCK_KICK0); |
| writel(CTRLMMR_LOCK_KICK1_UNLOCK_VAL, part_base + CTRLMMR_LOCK_KICK1); |
| } |
| |
| static void ctrl_mmr_unlock(void) |
| { |
| /* Unlock all WKUP_CTRL_MMR0 module registers */ |
| mmr_unlock(WKUP_CTRL_MMR0_BASE, 0); |
| mmr_unlock(WKUP_CTRL_MMR0_BASE, 1); |
| mmr_unlock(WKUP_CTRL_MMR0_BASE, 2); |
| mmr_unlock(WKUP_CTRL_MMR0_BASE, 3); |
| mmr_unlock(WKUP_CTRL_MMR0_BASE, 6); |
| mmr_unlock(WKUP_CTRL_MMR0_BASE, 7); |
| |
| /* Unlock all MCU_CTRL_MMR0 module registers */ |
| mmr_unlock(MCU_CTRL_MMR0_BASE, 0); |
| mmr_unlock(MCU_CTRL_MMR0_BASE, 1); |
| mmr_unlock(MCU_CTRL_MMR0_BASE, 2); |
| mmr_unlock(MCU_CTRL_MMR0_BASE, 6); |
| |
| /* Unlock all CTRL_MMR0 module registers */ |
| mmr_unlock(CTRL_MMR0_BASE, 0); |
| mmr_unlock(CTRL_MMR0_BASE, 1); |
| mmr_unlock(CTRL_MMR0_BASE, 2); |
| mmr_unlock(CTRL_MMR0_BASE, 3); |
| mmr_unlock(CTRL_MMR0_BASE, 6); |
| mmr_unlock(CTRL_MMR0_BASE, 7); |
| } |
| |
| static void store_boot_index_from_rom(void) |
| { |
| u32 *boot_index = (u32 *)K3_BOOT_PARAM_TABLE_INDEX_VAL; |
| |
| *boot_index = *(u32 *)(CONFIG_SYS_K3_BOOT_PARAM_TABLE_INDEX); |
| } |
| |
| void board_init_f(ulong dummy) |
| { |
| /* |
| * Cannot delay this further as there is a chance that |
| * K3_BOOT_PARAM_TABLE_INDEX can be over written by SPL MALLOC section. |
| */ |
| store_boot_index_from_rom(); |
| |
| /* Make all control module registers accessible */ |
| ctrl_mmr_unlock(); |
| |
| /* Init DM early in-order to invoke system controller */ |
| spl_early_init(); |
| |
| /* Prepare console output */ |
| preloader_console_init(); |
| } |
| |
| u32 spl_boot_mode(const u32 boot_device) |
| { |
| #if defined(CONFIG_SUPPORT_EMMC_BOOT) |
| u32 devstat = readl(CTRLMMR_MAIN_DEVSTAT); |
| u32 bootindex = readl(K3_BOOT_PARAM_TABLE_INDEX_VAL); |
| |
| u32 bootmode = (devstat & CTRLMMR_MAIN_DEVSTAT_BOOTMODE_MASK) >> |
| CTRLMMR_MAIN_DEVSTAT_BOOTMODE_SHIFT; |
| |
| /* eMMC boot0 mode is only supported for primary boot */ |
| if (bootindex == K3_PRIMARY_BOOTMODE && |
| bootmode == BOOT_DEVICE_MMC1) |
| return MMCSD_MODE_EMMCBOOT; |
| #endif |
| |
| /* Everything else use filesystem if available */ |
| #if defined(CONFIG_SPL_FAT_SUPPORT) || defined(CONFIG_SPL_EXT_SUPPORT) |
| return MMCSD_MODE_FS; |
| #else |
| return MMCSD_MODE_RAW; |
| #endif |
| } |
| |
| static u32 __get_backup_bootmedia(u32 devstat) |
| { |
| u32 bkup_boot = (devstat & CTRLMMR_MAIN_DEVSTAT_BKUP_BOOTMODE_MASK) >> |
| CTRLMMR_MAIN_DEVSTAT_BKUP_BOOTMODE_SHIFT; |
| |
| switch (bkup_boot) { |
| case BACKUP_BOOT_DEVICE_USB: |
| return BOOT_DEVICE_USB; |
| case BACKUP_BOOT_DEVICE_UART: |
| return BOOT_DEVICE_UART; |
| case BACKUP_BOOT_DEVICE_ETHERNET: |
| return BOOT_DEVICE_ETHERNET; |
| case BACKUP_BOOT_DEVICE_MMC2: |
| { |
| u32 port = (devstat & CTRLMMR_MAIN_DEVSTAT_BKUP_MMC_PORT_MASK) >> |
| CTRLMMR_MAIN_DEVSTAT_BKUP_MMC_PORT_SHIFT; |
| if (port == 0x0) |
| return BOOT_DEVICE_MMC1; |
| return BOOT_DEVICE_MMC2; |
| } |
| case BACKUP_BOOT_DEVICE_SPI: |
| return BOOT_DEVICE_SPI; |
| case BACKUP_BOOT_DEVICE_HYPERFLASH: |
| return BOOT_DEVICE_HYPERFLASH; |
| case BACKUP_BOOT_DEVICE_I2C: |
| return BOOT_DEVICE_I2C; |
| }; |
| |
| return BOOT_DEVICE_RAM; |
| } |
| |
| static u32 __get_primary_bootmedia(u32 devstat) |
| { |
| u32 bootmode = (devstat & CTRLMMR_MAIN_DEVSTAT_BOOTMODE_MASK) >> |
| CTRLMMR_MAIN_DEVSTAT_BOOTMODE_SHIFT; |
| |
| if (bootmode == BOOT_DEVICE_OSPI || bootmode == BOOT_DEVICE_QSPI) |
| bootmode = BOOT_DEVICE_SPI; |
| |
| if (bootmode == BOOT_DEVICE_MMC2) { |
| u32 port = (devstat & CTRLMMR_MAIN_DEVSTAT_MMC_PORT_MASK) >> |
| CTRLMMR_MAIN_DEVSTAT_MMC_PORT_SHIFT; |
| if (port == 0x0) |
| bootmode = BOOT_DEVICE_MMC1; |
| } else if (bootmode == BOOT_DEVICE_MMC1) { |
| u32 port = (devstat & CTRLMMR_MAIN_DEVSTAT_EMMC_PORT_MASK) >> |
| CTRLMMR_MAIN_DEVSTAT_EMMC_PORT_SHIFT; |
| if (port == 0x1) |
| bootmode = BOOT_DEVICE_MMC2; |
| } |
| |
| return bootmode; |
| } |
| |
| u32 spl_boot_device(void) |
| { |
| u32 devstat = readl(CTRLMMR_MAIN_DEVSTAT); |
| u32 bootindex = readl(K3_BOOT_PARAM_TABLE_INDEX_VAL); |
| |
| if (bootindex == K3_PRIMARY_BOOTMODE) |
| return __get_primary_bootmedia(devstat); |
| else |
| return __get_backup_bootmedia(devstat); |
| } |
| #endif |
| |
| #ifndef CONFIG_SYSRESET |
| void reset_cpu(ulong ignored) |
| { |
| } |
| #endif |