| // SPDX-License-Identifier: GPL-2.0+ |
| // Copyright (C) 2021 Fabio Estevam <festevam@denx.de> |
| |
| #include <init.h> |
| #include <net.h> |
| #include <asm/arch/clock.h> |
| #include <asm/arch/imx-regs.h> |
| #include <asm/arch/mx7-pins.h> |
| #include <asm/arch/sys_proto.h> |
| #include <asm/global_data.h> |
| #include <asm/gpio.h> |
| #include <asm/mach-imx/hab.h> |
| #include <asm/mach-imx/iomux-v3.h> |
| #include <asm/io.h> |
| #include <common.h> |
| #include <env.h> |
| #include <env_internal.h> |
| #include <asm/arch/crm_regs.h> |
| #include <asm/setup.h> |
| #include <asm/bootm.h> |
| #include <mmc.h> |
| |
| DECLARE_GLOBAL_DATA_PTR; |
| |
| #define UART_PAD_CTRL (PAD_CTL_DSE_3P3V_49OHM | PAD_CTL_PUS_PU100KOHM | \ |
| PAD_CTL_HYS) |
| |
| int dram_init(void) |
| { |
| gd->ram_size = PHYS_SDRAM_SIZE; |
| |
| return 0; |
| } |
| |
| static iomux_v3_cfg_t const wdog_pads[] = { |
| MX7D_PAD_GPIO1_IO00__WDOG1_WDOG_B | MUX_PAD_CTRL(NO_PAD_CTRL), |
| }; |
| |
| static iomux_v3_cfg_t const uart1_pads[] = { |
| MX7D_PAD_UART1_TX_DATA__UART1_DCE_TX | MUX_PAD_CTRL(UART_PAD_CTRL), |
| MX7D_PAD_UART1_RX_DATA__UART1_DCE_RX | MUX_PAD_CTRL(UART_PAD_CTRL), |
| }; |
| |
| static void setup_iomux_uart(void) |
| { |
| imx_iomux_v3_setup_multiple_pads(uart1_pads, ARRAY_SIZE(uart1_pads)); |
| }; |
| |
| static int setup_fec(void) |
| { |
| struct iomuxc_gpr_base_regs *const iomuxc_gpr_regs = |
| (struct iomuxc_gpr_base_regs *)IOMUXC_GPR_BASE_ADDR; |
| int ret; |
| |
| /* Use 125M anatop REF_CLK1 for ENET1, clear gpr1[13], gpr1[17]*/ |
| clrsetbits_le32(&iomuxc_gpr_regs->gpr[1], |
| (IOMUXC_GPR_GPR1_GPR_ENET1_TX_CLK_SEL_MASK | |
| IOMUXC_GPR_GPR1_GPR_ENET1_CLK_DIR_MASK), 0); |
| |
| ret = set_clk_enet(ENET_125MHZ); |
| if (ret) |
| return ret; |
| |
| return 0; |
| } |
| |
| int board_early_init_f(void) |
| { |
| setup_iomux_uart(); |
| setup_fec(); |
| return 0; |
| } |
| |
| int board_init(void) |
| { |
| /* address of boot parameters */ |
| gd->bd->bi_boot_params = PHYS_SDRAM + 0x100; |
| |
| return 0; |
| } |
| |
| int board_late_init(void) |
| { |
| struct wdog_regs *wdog = (struct wdog_regs *)WDOG1_BASE_ADDR; |
| unsigned char eth1addr[6]; |
| |
| imx_iomux_v3_setup_multiple_pads(wdog_pads, ARRAY_SIZE(wdog_pads)); |
| |
| set_wdog_reset(wdog); |
| |
| /* |
| * Do not assert internal WDOG_RESET_B_DEB(controlled by bit 4), |
| * since we use PMIC_PWRON to reset the board. |
| */ |
| clrsetbits_le16(&wdog->wcr, 0, 0x10); |
| |
| /* Get the second MAC address */ |
| imx_get_mac_from_fuse(1, eth1addr); |
| if (!env_get("eth1addr") && is_valid_ethaddr(eth1addr)) |
| eth_env_set_enetaddr("eth1addr", eth1addr); |
| |
| return 0; |
| } |
| |
| uint mmc_get_env_part(struct mmc *mmc) |
| { |
| uint part = EXT_CSD_EXTRACT_BOOT_PART(mmc->part_config); |
| |
| if (part == 7) |
| part = 0; |
| return part; |
| } |
| |
| enum env_location env_get_location(enum env_operation op, int prio) |
| { |
| if (op == ENVOP_SAVE || op == ENVOP_ERASE) |
| return ENVL_MMC; |
| |
| switch (prio) { |
| case 0: |
| return ENVL_NOWHERE; |
| |
| case 1: |
| return ENVL_MMC; |
| } |
| |
| return ENVL_UNKNOWN; |
| } |