| // SPDX-License-Identifier: GPL-2.0+ |
| /* |
| * (C) Copyright 2018-2019 |
| * NVIDIA Corporation <www.nvidia.com> |
| * |
| */ |
| |
| #include <common.h> |
| #include <fdtdec.h> |
| #include <i2c.h> |
| #include <linux/bitops.h> |
| #include <linux/libfdt.h> |
| #include <pca953x.h> |
| #include <asm/arch-tegra/cboot.h> |
| #include <asm/arch/gpio.h> |
| #include <asm/arch/pinmux.h> |
| #include "../p2571/max77620_init.h" |
| |
| void pin_mux_mmc(void) |
| { |
| struct udevice *dev; |
| uchar val; |
| int ret; |
| |
| /* Turn on MAX77620 LDO2 to 3.3V for SD card power */ |
| debug("%s: Set LDO2 for VDDIO_SDMMC_AP power to 3.3V\n", __func__); |
| ret = i2c_get_chip_for_busnum(0, MAX77620_I2C_ADDR_7BIT, 1, &dev); |
| if (ret) { |
| printf("%s: Cannot find MAX77620 I2C chip\n", __func__); |
| return; |
| } |
| /* 0xF2 for 3.3v, enabled: bit7:6 = 11 = enable, bit5:0 = voltage */ |
| val = 0xF2; |
| ret = dm_i2c_write(dev, MAX77620_CNFG1_L2_REG, &val, 1); |
| if (ret) |
| printf("i2c_write 0 0x3c 0x27 failed: %d\n", ret); |
| |
| /* Disable LDO4 discharge */ |
| ret = dm_i2c_read(dev, MAX77620_CNFG2_L4_REG, &val, 1); |
| if (ret) { |
| printf("i2c_read 0 0x3c 0x2c failed: %d\n", ret); |
| } else { |
| val &= ~BIT(1); /* ADE */ |
| ret = dm_i2c_write(dev, MAX77620_CNFG2_L4_REG, &val, 1); |
| if (ret) |
| printf("i2c_write 0 0x3c 0x2c failed: %d\n", ret); |
| } |
| |
| /* Set MBLPD */ |
| ret = dm_i2c_read(dev, MAX77620_CNFGGLBL1_REG, &val, 1); |
| if (ret) { |
| printf("i2c_write 0 0x3c 0x00 failed: %d\n", ret); |
| } else { |
| val |= BIT(6); /* MBLPD */ |
| ret = dm_i2c_write(dev, MAX77620_CNFGGLBL1_REG, &val, 1); |
| if (ret) |
| printf("i2c_write 0 0x3c 0x00 failed: %d\n", ret); |
| } |
| } |
| |
| #ifdef CONFIG_PCI_TEGRA |
| int tegra_pcie_board_init(void) |
| { |
| struct udevice *dev; |
| uchar val; |
| int ret; |
| |
| /* Turn on MAX77620 LDO1 to 1.05V for PEX power */ |
| debug("%s: Set LDO1 for PEX power to 1.05V\n", __func__); |
| ret = i2c_get_chip_for_busnum(0, MAX77620_I2C_ADDR_7BIT, 1, &dev); |
| if (ret) { |
| printf("%s: Cannot find MAX77620 I2C chip\n", __func__); |
| return -1; |
| } |
| /* 0xCA for 1.05v, enabled: bit7:6 = 11 = enable, bit5:0 = voltage */ |
| val = 0xCA; |
| ret = dm_i2c_write(dev, MAX77620_CNFG1_L1_REG, &val, 1); |
| if (ret) |
| printf("i2c_write 0 0x3c 0x25 failed: %d\n", ret); |
| |
| return 0; |
| } |
| #endif /* PCI */ |
| |
| static void ft_mac_address_setup(void *fdt) |
| { |
| const void *cboot_fdt = (const void *)cboot_boot_x0; |
| uint8_t mac[ETH_ALEN], local_mac[ETH_ALEN]; |
| const char *path; |
| int offset, err; |
| |
| err = cboot_get_ethaddr(cboot_fdt, local_mac); |
| if (err < 0) |
| memset(local_mac, 0, ETH_ALEN); |
| |
| path = fdt_get_alias(fdt, "ethernet"); |
| if (!path) |
| return; |
| |
| debug("ethernet alias found: %s\n", path); |
| |
| offset = fdt_path_offset(fdt, path); |
| if (offset < 0) { |
| printf("ethernet alias points to absent node %s\n", path); |
| return; |
| } |
| |
| if (is_valid_ethaddr(local_mac)) { |
| err = fdt_setprop(fdt, offset, "local-mac-address", local_mac, |
| ETH_ALEN); |
| if (!err) |
| debug("Local MAC address set: %pM\n", local_mac); |
| } |
| |
| if (eth_env_get_enetaddr("ethaddr", mac)) { |
| if (memcmp(local_mac, mac, ETH_ALEN) != 0) { |
| err = fdt_setprop(fdt, offset, "mac-address", mac, |
| ETH_ALEN); |
| if (!err) |
| debug("MAC address set: %pM\n", mac); |
| } |
| } |
| } |
| |
| static int ft_copy_carveout(void *dst, const void *src, const char *node) |
| { |
| struct fdt_memory fb; |
| int err; |
| |
| err = fdtdec_get_carveout(src, node, "memory-region", 0, &fb); |
| if (err < 0) { |
| if (err != -FDT_ERR_NOTFOUND) |
| printf("failed to get carveout for %s: %d\n", node, |
| err); |
| |
| return err; |
| } |
| |
| err = fdtdec_set_carveout(dst, node, "memory-region", 0, "framebuffer", |
| &fb); |
| if (err < 0) { |
| printf("failed to set carveout for %s: %d\n", node, err); |
| return err; |
| } |
| |
| return 0; |
| } |
| |
| static void ft_carveout_setup(void *fdt) |
| { |
| const void *cboot_fdt = (const void *)cboot_boot_x0; |
| static const char * const nodes[] = { |
| "/host1x@50000000/dc@54200000", |
| "/host1x@50000000/dc@54240000", |
| }; |
| unsigned int i; |
| int err; |
| |
| for (i = 0; i < ARRAY_SIZE(nodes); i++) { |
| printf("copying carveout for %s...\n", nodes[i]); |
| |
| err = ft_copy_carveout(fdt, cboot_fdt, nodes[i]); |
| if (err < 0) { |
| if (err != -FDT_ERR_NOTFOUND) |
| printf("failed to copy carveout for %s: %d\n", |
| nodes[i], err); |
| |
| continue; |
| } |
| } |
| } |
| |
| int ft_board_setup(void *fdt, struct bd_info *bd) |
| { |
| ft_mac_address_setup(fdt); |
| ft_carveout_setup(fdt); |
| |
| return 0; |
| } |