| // SPDX-License-Identifier: GPL-2.0 |
| /* Copyright 2016-2019 NXP Semiconductors |
| */ |
| #include <common.h> |
| #include <init.h> |
| #include <asm/arch-ls102xa/ls102xa_soc.h> |
| #include <asm/arch/ls102xa_devdis.h> |
| #include <asm/arch/immap_ls102xa.h> |
| #include <asm/arch/ls102xa_soc.h> |
| #include <asm/arch/fsl_serdes.h> |
| #include "../common/sleep.h" |
| #include <fsl_validate.h> |
| #include <fsl_immap.h> |
| #include <fsl_csu.h> |
| #include <netdev.h> |
| #include <spl.h> |
| #ifdef CONFIG_U_QE |
| #include <fsl_qe.h> |
| #endif |
| |
| DECLARE_GLOBAL_DATA_PTR; |
| |
| static void ddrmc_init(void) |
| { |
| #if (!defined(CONFIG_SPL) || defined(CONFIG_SPL_BUILD)) |
| struct ccsr_ddr *ddr = (struct ccsr_ddr *)CONFIG_SYS_FSL_DDR_ADDR; |
| u32 temp_sdram_cfg, tmp; |
| |
| out_be32(&ddr->sdram_cfg, DDR_SDRAM_CFG); |
| |
| out_be32(&ddr->cs0_bnds, DDR_CS0_BNDS); |
| out_be32(&ddr->cs0_config, DDR_CS0_CONFIG); |
| |
| out_be32(&ddr->timing_cfg_0, DDR_TIMING_CFG_0); |
| out_be32(&ddr->timing_cfg_1, DDR_TIMING_CFG_1); |
| out_be32(&ddr->timing_cfg_2, DDR_TIMING_CFG_2); |
| out_be32(&ddr->timing_cfg_3, DDR_TIMING_CFG_3); |
| out_be32(&ddr->timing_cfg_4, DDR_TIMING_CFG_4); |
| out_be32(&ddr->timing_cfg_5, DDR_TIMING_CFG_5); |
| |
| #ifdef CONFIG_DEEP_SLEEP |
| if (is_warm_boot()) { |
| out_be32(&ddr->sdram_cfg_2, |
| DDR_SDRAM_CFG_2 & ~SDRAM_CFG2_D_INIT); |
| out_be32(&ddr->init_addr, CONFIG_SYS_SDRAM_BASE); |
| out_be32(&ddr->init_ext_addr, (1 << 31)); |
| |
| /* DRAM VRef will not be trained */ |
| out_be32(&ddr->ddr_cdr2, |
| DDR_DDR_CDR2 & ~DDR_CDR2_VREF_TRAIN_EN); |
| } else |
| #endif |
| { |
| out_be32(&ddr->sdram_cfg_2, DDR_SDRAM_CFG_2); |
| out_be32(&ddr->ddr_cdr2, DDR_DDR_CDR2); |
| } |
| |
| out_be32(&ddr->sdram_mode, DDR_SDRAM_MODE); |
| out_be32(&ddr->sdram_mode_2, DDR_SDRAM_MODE_2); |
| |
| out_be32(&ddr->sdram_interval, DDR_SDRAM_INTERVAL); |
| |
| out_be32(&ddr->ddr_wrlvl_cntl, DDR_DDR_WRLVL_CNTL); |
| |
| out_be32(&ddr->ddr_wrlvl_cntl_2, DDR_DDR_WRLVL_CNTL_2); |
| out_be32(&ddr->ddr_wrlvl_cntl_3, DDR_DDR_WRLVL_CNTL_3); |
| |
| out_be32(&ddr->ddr_cdr1, DDR_DDR_CDR1); |
| |
| out_be32(&ddr->sdram_clk_cntl, DDR_SDRAM_CLK_CNTL); |
| out_be32(&ddr->ddr_zq_cntl, DDR_DDR_ZQ_CNTL); |
| |
| out_be32(&ddr->cs0_config_2, DDR_CS0_CONFIG_2); |
| |
| /* DDR erratum A-009942 */ |
| tmp = in_be32(&ddr->debug[28]); |
| out_be32(&ddr->debug[28], tmp | 0x0070006f); |
| |
| udelay(1); |
| |
| #ifdef CONFIG_DEEP_SLEEP |
| if (is_warm_boot()) { |
| /* enter self-refresh */ |
| temp_sdram_cfg = in_be32(&ddr->sdram_cfg_2); |
| temp_sdram_cfg |= SDRAM_CFG2_FRC_SR; |
| out_be32(&ddr->sdram_cfg_2, temp_sdram_cfg); |
| |
| temp_sdram_cfg = (DDR_SDRAM_CFG_MEM_EN | SDRAM_CFG_BI); |
| } else |
| #endif |
| temp_sdram_cfg = (DDR_SDRAM_CFG_MEM_EN & ~SDRAM_CFG_BI); |
| |
| out_be32(&ddr->sdram_cfg, DDR_SDRAM_CFG | temp_sdram_cfg); |
| |
| #ifdef CONFIG_DEEP_SLEEP |
| if (is_warm_boot()) { |
| /* exit self-refresh */ |
| temp_sdram_cfg = in_be32(&ddr->sdram_cfg_2); |
| temp_sdram_cfg &= ~SDRAM_CFG2_FRC_SR; |
| out_be32(&ddr->sdram_cfg_2, temp_sdram_cfg); |
| } |
| #endif |
| #endif /* !defined(CONFIG_SPL) || defined(CONFIG_SPL_BUILD) */ |
| } |
| |
| int dram_init(void) |
| { |
| ddrmc_init(); |
| |
| erratum_a008850_post(); |
| |
| gd->ram_size = get_ram_size((void *)PHYS_SDRAM, PHYS_SDRAM_SIZE); |
| |
| #if defined(CONFIG_DEEP_SLEEP) && !defined(CONFIG_SPL_BUILD) |
| fsl_dp_resume(); |
| #endif |
| |
| return 0; |
| } |
| |
| int board_eth_init(bd_t *bis) |
| { |
| return pci_eth_init(bis); |
| } |
| |
| int board_early_init_f(void) |
| { |
| struct ccsr_scfg *scfg = (struct ccsr_scfg *)CONFIG_SYS_FSL_SCFG_ADDR; |
| |
| #ifdef CONFIG_TSEC_ENET |
| /* |
| * Clear BD & FR bits for big endian BD's and frame data (aka set |
| * correct eTSEC endianness). This is crucial in ensuring that it does |
| * not report Data Parity Errors in its RX/TX FIFOs when attempting to |
| * send traffic. |
| */ |
| clrbits_be32(&scfg->etsecdmamcr, SCFG_ETSECDMAMCR_LE_BD_FR); |
| /* EC3_GTX_CLK125 (of enet2) used for all RGMII interfaces */ |
| out_be32(&scfg->etsecmcr, SCFG_ETSECCMCR_GE2_CLK125); |
| #endif |
| |
| arch_soc_init(); |
| |
| #if defined(CONFIG_DEEP_SLEEP) |
| if (is_warm_boot()) { |
| timer_init(); |
| dram_init(); |
| } |
| #endif |
| |
| return 0; |
| } |
| |
| #ifdef CONFIG_SPL_BUILD |
| void board_init_f(ulong dummy) |
| { |
| void (*second_uboot)(void); |
| |
| /* Clear the BSS */ |
| memset(__bss_start, 0, __bss_end - __bss_start); |
| |
| get_clocks(); |
| |
| #if defined(CONFIG_DEEP_SLEEP) |
| if (is_warm_boot()) |
| fsl_dp_disable_console(); |
| #endif |
| |
| preloader_console_init(); |
| |
| dram_init(); |
| |
| /* Allow OCRAM access permission as R/W */ |
| #ifdef CONFIG_LAYERSCAPE_NS_ACCESS |
| enable_layerscape_ns_access(); |
| enable_layerscape_ns_access(); |
| #endif |
| |
| /* |
| * if it is woken up from deep sleep, then jump to second |
| * stage U-Boot and continue executing without recopying |
| * it from SD since it has already been reserved in memory |
| * in last boot. |
| */ |
| if (is_warm_boot()) { |
| second_uboot = (void (*)(void))CONFIG_SYS_TEXT_BASE; |
| second_uboot(); |
| } |
| |
| board_init_r(NULL, 0); |
| } |
| #endif |
| |
| int board_init(void) |
| { |
| #ifndef CONFIG_SYS_FSL_NO_SERDES |
| fsl_serdes_init(); |
| #endif |
| ls102xa_smmu_stream_id_init(); |
| |
| #ifdef CONFIG_LAYERSCAPE_NS_ACCESS |
| enable_layerscape_ns_access(); |
| #endif |
| |
| #ifdef CONFIG_U_QE |
| u_qe_init(); |
| #endif |
| |
| return 0; |
| } |
| |
| #if defined(CONFIG_SPL_BUILD) |
| void spl_board_init(void) |
| { |
| ls102xa_smmu_stream_id_init(); |
| } |
| #endif |
| |
| #ifdef CONFIG_BOARD_LATE_INIT |
| int board_late_init(void) |
| { |
| #ifdef CONFIG_CHAIN_OF_TRUST |
| fsl_setenv_chain_of_trust(); |
| #endif |
| |
| return 0; |
| } |
| #endif |
| |
| #if defined(CONFIG_MISC_INIT_R) |
| int misc_init_r(void) |
| { |
| #ifdef CONFIG_FSL_DEVICE_DISABLE |
| device_disable(devdis_tbl, ARRAY_SIZE(devdis_tbl)); |
| #endif |
| |
| #ifdef CONFIG_FSL_CAAM |
| return sec_init(); |
| #endif |
| } |
| #endif |
| |
| #if defined(CONFIG_DEEP_SLEEP) |
| void board_sleep_prepare(void) |
| { |
| #ifdef CONFIG_LAYERSCAPE_NS_ACCESS |
| enable_layerscape_ns_access(); |
| #endif |
| } |
| #endif |
| |
| int ft_board_setup(void *blob, bd_t *bd) |
| { |
| ft_cpu_setup(blob, bd); |
| |
| #ifdef CONFIG_PCI |
| ft_pci_setup(blob, bd); |
| #endif |
| |
| return 0; |
| } |