| // SPDX-License-Identifier: GPL-2.0+ |
| /* |
| * |
| * (C) Copyright 2009 Magnus Lilja <lilja.magnus@gmail.com> |
| * |
| * (c) 2007 Pengutronix, Sascha Hauer <s.hauer@pengutronix.de> |
| */ |
| |
| |
| #include <common.h> |
| #include <init.h> |
| #include <netdev.h> |
| #include <asm/arch/clock.h> |
| #include <asm/arch/imx-regs.h> |
| #include <asm/arch/sys_proto.h> |
| #include <watchdog.h> |
| #include <power/pmic.h> |
| #include <fsl_pmic.h> |
| #include <errno.h> |
| |
| DECLARE_GLOBAL_DATA_PTR; |
| |
| #ifdef CONFIG_SPL_BUILD |
| void board_init_f(ulong bootflag) |
| { |
| /* |
| * copy ourselves from where we are running to where we were |
| * linked at. Use ulong pointers as all addresses involved |
| * are 4-byte-aligned. |
| */ |
| ulong *start_ptr, *end_ptr, *link_ptr, *run_ptr, *dst; |
| asm volatile ("ldr %0, =_start" : "=r"(start_ptr)); |
| asm volatile ("ldr %0, =_end" : "=r"(end_ptr)); |
| asm volatile ("ldr %0, =board_init_f" : "=r"(link_ptr)); |
| asm volatile ("adr %0, board_init_f" : "=r"(run_ptr)); |
| for (dst = start_ptr; dst < end_ptr; dst++) |
| *dst = *(dst+(run_ptr-link_ptr)); |
| /* |
| * branch to nand_boot's link-time address. |
| */ |
| asm volatile("ldr pc, =nand_boot"); |
| } |
| #endif |
| |
| int dram_init(void) |
| { |
| /* dram_init must store complete ramsize in gd->ram_size */ |
| gd->ram_size = get_ram_size((void *)CONFIG_SYS_SDRAM_BASE, |
| PHYS_SDRAM_1_SIZE); |
| return 0; |
| } |
| |
| int board_early_init_f(void) |
| { |
| /* CS5: CPLD incl. network controller */ |
| static const struct mxc_weimcs cs5 = { |
| /* sp wp bcd bcs psz pme sync dol cnc wsc ew wws edc */ |
| CSCR_U(0, 0, 0, 0, 0, 0, 0, 0, 3, 24, 0, 4, 3), |
| /* oea oen ebwa ebwn csa ebc dsz csn psr cre wrap csen */ |
| CSCR_L(2, 2, 2, 5, 2, 0, 5, 2, 0, 0, 0, 1), |
| /* ebra ebrn rwa rwn mum lah lbn lba dww dct wwu age cnc2 fce*/ |
| CSCR_A(2, 2, 2, 2, 0, 0, 2, 2, 0, 0, 0, 0, 0, 0) |
| }; |
| |
| mxc_setup_weimcs(5, &cs5); |
| |
| /* Setup UART1 and SPI2 pins */ |
| mx31_uart1_hw_init(); |
| mx31_spi2_hw_init(); |
| |
| return 0; |
| } |
| |
| int board_init(void) |
| { |
| /* adress of boot parameters */ |
| gd->bd->bi_boot_params = PHYS_SDRAM_1 + 0x100; |
| |
| return 0; |
| } |
| |
| int board_late_init(void) |
| { |
| u32 val; |
| struct pmic *p; |
| int ret; |
| |
| ret = pmic_init(CONFIG_FSL_PMIC_BUS); |
| if (ret) |
| return ret; |
| |
| p = pmic_get("FSL_PMIC"); |
| if (!p) |
| return -ENODEV; |
| /* Enable RTC battery */ |
| pmic_reg_read(p, REG_POWER_CTL0, &val); |
| pmic_reg_write(p, REG_POWER_CTL0, val | COINCHEN); |
| pmic_reg_write(p, REG_INT_STATUS1, RTCRSTI); |
| #ifdef CONFIG_HW_WATCHDOG |
| hw_watchdog_init(); |
| #endif |
| return 0; |
| } |
| |
| int checkboard(void) |
| { |
| printf("Board: MX31PDK\n"); |
| return 0; |
| } |
| |
| int board_eth_init(bd_t *bis) |
| { |
| int rc = 0; |
| #ifdef CONFIG_SMC911X |
| rc = smc911x_initialize(0, CONFIG_SMC911X_BASE); |
| #endif |
| return rc; |
| } |