| CONFIG_ARM=y |
| # CONFIG_SPL_USE_ARCH_MEMCPY is not set |
| # CONFIG_SPL_USE_ARCH_MEMSET is not set |
| CONFIG_ARCH_OMAP2PLUS=y |
| CONFIG_TEXT_BASE=0x80100000 |
| CONFIG_SYS_MALLOC_F_LEN=0x4000 |
| CONFIG_TI_COMMON_CMD_OPTIONS=y |
| CONFIG_NR_DRAM_BANKS=2 |
| CONFIG_HAS_CUSTOM_SYS_INIT_SP_ADDR=y |
| CONFIG_CUSTOM_SYS_INIT_SP_ADDR=0x4020ff00 |
| CONFIG_DEFAULT_DEVICE_TREE="ti/omap/am3517-evm" |
| CONFIG_SPL_TEXT_BASE=0x40200000 |
| CONFIG_TARGET_AM3517_EVM=y |
| CONFIG_EMIF4=y |
| CONFIG_SYS_MONITOR_LEN=262144 |
| CONFIG_SPL_SYS_MALLOC_F_LEN=0x2500 |
| CONFIG_SPL=y |
| CONFIG_LTO=y |
| CONFIG_DISTRO_DEFAULTS=y |
| CONFIG_BOOTDELAY=10 |
| CONFIG_BOOTCOMMAND="mmc dev ${mmcdev}; if mmc rescan; then echo SD/MMC found on device $mmcdev; if run loadbootenv; then run importbootenv; fi; echo Checking if uenvcmd is set ...; if test -n $uenvcmd; then echo Running uenvcmd ...; run uenvcmd; fi; echo Running default loadimage ...; setenv bootfile zImage; if run loadimage; then run loadfdt; run mmcboot; fi; else run nandboot; fi" |
| CONFIG_SYS_PBSIZE=1054 |
| CONFIG_SPL_MAX_SIZE=0xec00 |
| CONFIG_SPL_SYS_MALLOC_SIMPLE=y |
| CONFIG_SPL_SYS_MALLOC=y |
| CONFIG_SPL_SYS_MALLOC_SIZE=0x800000 |
| # CONFIG_SYS_MMCSD_RAW_MODE_U_BOOT_USE_SECTOR is not set |
| # CONFIG_SPL_FS_EXT4 is not set |
| # CONFIG_SPL_I2C is not set |
| CONFIG_SPL_MTD=y |
| CONFIG_SPL_NAND_DRIVERS=y |
| CONFIG_SPL_NAND_ECC=y |
| CONFIG_SPL_NAND_SIMPLE=y |
| CONFIG_SPL_NAND_BASE=y |
| CONFIG_SPL_OS_BOOT=y |
| CONFIG_SPL_PAYLOAD_ARGS_ADDR=0x84000000 |
| CONFIG_SYS_NAND_SPL_KERNEL_OFFS=0x2a0000 |
| CONFIG_SPL_FALCON_BOOT_MMCSD=y |
| CONFIG_SYS_MMCSD_RAW_MODE_KERNEL_SECTOR=0x1700 |
| CONFIG_SYS_MMCSD_RAW_MODE_ARGS_SECTOR=0x1500 |
| CONFIG_SYS_MMCSD_RAW_MODE_ARGS_SECTORS=0x200 |
| # CONFIG_SPL_POWER is not set |
| CONFIG_SYS_PROMPT="AM3517_EVM # " |
| # CONFIG_CMD_IMI is not set |
| CONFIG_CMD_SPL=y |
| CONFIG_CMD_SPL_NAND_OFS=0xaa0000 |
| CONFIG_CMD_SPL_WRITE_SIZE=0x20000 |
| # CONFIG_CMD_GPT is not set |
| CONFIG_CMD_NAND=y |
| # CONFIG_CMD_SPI is not set |
| # CONFIG_CMD_SETEXPR is not set |
| CONFIG_BOOTP_DNS2=y |
| CONFIG_CMD_CACHE=y |
| # CONFIG_CMD_TIME is not set |
| CONFIG_CMD_MTDPARTS=y |
| CONFIG_MTDIDS_DEFAULT="nand0=omap2-nand.0" |
| CONFIG_MTDPARTS_DEFAULT="mtdparts=omap2-nand.0:512k(MLO),1920k(u-boot),256k(u-boot-env),8m(kernel),512k(dtb),-(rootfs)" |
| CONFIG_CMD_UBI=y |
| CONFIG_OF_CONTROL=y |
| CONFIG_SPL_OF_CONTROL=y |
| CONFIG_OF_UPSTREAM=y |
| CONFIG_ENV_OVERWRITE=y |
| # CONFIG_ENV_IS_IN_FAT is not set |
| CONFIG_ENV_IS_IN_NAND=y |
| CONFIG_USE_BOOTFILE=y |
| CONFIG_BOOTFILE="uImage" |
| CONFIG_VERSION_VARIABLE=y |
| CONFIG_NET_RETRY_COUNT=10 |
| CONFIG_BOOTP_SEND_HOSTNAME=y |
| CONFIG_SPL_DM=y |
| CONFIG_DM_PCA953X=y |
| CONFIG_MMC_OMAP_HS=y |
| CONFIG_MTD=y |
| CONFIG_MTD_RAW_NAND=y |
| CONFIG_NAND_OMAP_ECCSCHEME_BCH8_CODE_HW_DETECTION_SW=y |
| CONFIG_SYS_NAND_BLOCK_SIZE=0x20000 |
| CONFIG_SYS_NAND_PAGE_SIZE=0x800 |
| CONFIG_SYS_NAND_OOBSIZE=0x40 |
| CONFIG_SYS_NAND_BUSWIDTH_16BIT=y |
| CONFIG_SYS_NAND_U_BOOT_LOCATIONS=y |
| CONFIG_SYS_NAND_U_BOOT_OFFS=0x80000 |
| CONFIG_SYS_NAND_MAX_OOBFREE=2 |
| CONFIG_SYS_NAND_MAX_ECCPOS=56 |
| CONFIG_MII=y |
| CONFIG_DRIVER_TI_EMAC=y |
| CONFIG_DRIVER_TI_EMAC_USE_RMII=y |
| CONFIG_PINCTRL=y |
| CONFIG_PINCTRL_SINGLE=y |
| CONFIG_DM_PMIC=y |
| # CONFIG_SPL_PMIC_CHILDREN is not set |
| CONFIG_DM_REGULATOR=y |
| CONFIG_DM_REGULATOR_FIXED=y |
| CONFIG_DM_REGULATOR_GPIO=y |
| # CONFIG_TWL4030_POWER is not set |
| CONFIG_SPI=y |
| CONFIG_DM_SPI=y |
| CONFIG_OMAP3_SPI=y |
| CONFIG_USB=y |
| CONFIG_USB_EHCI_HCD=y |
| CONFIG_USB_MUSB_HOST=y |
| CONFIG_USB_MUSB_AM35X=y |
| CONFIG_BCH=y |
| CONFIG_SPL_TINY_MEMSET=y |
| # CONFIG_EFI_LOADER is not set |