blob: f8335c74a747e4d396d688b89b3eb89dccc5328a [file] [log] [blame]
// SPDX-License-Identifier: GPL-2.0+
#include "rk3399-u-boot.dtsi"
#ifdef CONFIG_TARGET_PUMA_RK3399_RAM_DDR3_1333
#include "rk3399-sdram-ddr3-1333.dtsi"
#endif
#ifdef CONFIG_TARGET_PUMA_RK3399_RAM_DDR3_1600
#include "rk3399-sdram-ddr3-1600.dtsi"
#endif
#ifdef CONFIG_TARGET_PUMA_RK3399_RAM_DDR3_1866
#include "rk3399-sdram-ddr3-1866.dtsi"
#endif
/ {
config {
u-boot,spl-payload-offset = <0x80000>; /* @ 512KB */
u-boot,mmc-env-offset = <0x4000>; /* @ 16KB */
u-boot,efi-partition-entries-offset = <0x200000>; /* 2MB */
u-boot,boot-led = "module_led";
sysreset-gpio = <&gpio1 RK_PA6 GPIO_ACTIVE_HIGH>;
};
chosen {
stdout-path = "serial0:115200n8";
u-boot,spl-boot-order = \
"same-as-spl", &norflash, &sdhci, &sdmmc;
};
aliases {
spi5 = &spi5;
};
vdd_log: vdd-log {
compatible = "pwm-regulator";
pwms = <&pwm2 0 25000 1>;
regulator-name = "vdd_log";
regulator-always-on;
regulator-boot-on;
regulator-min-microvolt = <800000>;
regulator-max-microvolt = <1400000>;
regulator-init-microvolt = <950000>;
vin-supply = <&vcc5v0_sys>;
};
};
&binman {
simple-bin {
blob {
offset = <((CONFIG_SYS_MMCSD_RAW_MODE_U_BOOT_SECTOR - 64) * 512)>;
};
};
#ifdef CONFIG_ROCKCHIP_SPI_IMAGE
simple-bin-spi {
blob {
/* same as u-boot,spl-payload-offset */
offset = <0x80000>;
};
};
#endif
};
&gpio1 {
u-boot,dm-pre-reloc;
};
&gpio3 {
u-boot,dm-pre-reloc;
/*
* The Qseven BIOS_DISABLE signal on the RK3399-Q7 keeps the on-module
* eMMC and SPI flash powered-down initially (in fact it keeps the
* reset signal asserted). BIOS_DISABLE_OVERRIDE pin allows to re-enable
* eMMC and SPI after the SPL has been booted from SD Card.
*/
bios_disable_override {
u-boot,dm-pre-reloc;
gpios = <RK_PD5 GPIO_ACTIVE_LOW>;
output-high;
line-name = "bios_disable_override";
gpio-hog;
};
};
&gpio4 {
u-boot,dm-pre-reloc;
};
&norflash {
u-boot,dm-pre-reloc;
};
&pcfg_pull_none {
u-boot,dm-pre-reloc;
};
&pcfg_pull_up {
u-boot,dm-pre-reloc;
};
&sdmmc_bus4 {
u-boot,dm-pre-reloc;
};
&sdmmc_clk {
u-boot,dm-pre-reloc;
};
&sdmmc_cmd {
u-boot,dm-pre-reloc;
};