| // SPDX-License-Identifier: GPL-2.0+ |
| /* |
| * Intel LXT971/LXT972 PHY Driver for TI DaVinci |
| * (TMS320DM644x) based boards. |
| * |
| * Copyright (C) 2007 Sergey Kubushyn <ksi@koi8.net> |
| * |
| * -------------------------------------------------------- |
| */ |
| |
| #include <common.h> |
| #include <net.h> |
| #include <miiphy.h> |
| #include <lxt971a.h> |
| #include <asm/arch/emac_defs.h> |
| #include "../../../drivers/net/davinci_emac.h" |
| |
| #ifdef CONFIG_DRIVER_TI_EMAC |
| |
| #ifdef CONFIG_CMD_NET |
| |
| int lxt972_is_phy_connected(int phy_addr) |
| { |
| u_int16_t id1, id2; |
| |
| if (!davinci_eth_phy_read(phy_addr, MII_PHYSID1, &id1)) |
| return(0); |
| if (!davinci_eth_phy_read(phy_addr, MII_PHYSID2, &id2)) |
| return(0); |
| |
| if ((id1 == (0x0013)) && ((id2 & 0xfff0) == 0x78e0)) |
| return(1); |
| |
| return(0); |
| } |
| |
| int lxt972_get_link_speed(int phy_addr) |
| { |
| u_int16_t stat1, tmp; |
| volatile emac_regs *emac = (emac_regs *)EMAC_BASE_ADDR; |
| |
| if (!davinci_eth_phy_read(phy_addr, PHY_LXT971_STAT2, &stat1)) |
| return(0); |
| |
| if (!(stat1 & PHY_LXT971_STAT2_LINK)) /* link up? */ |
| return(0); |
| |
| if (!davinci_eth_phy_read(phy_addr, PHY_LXT971_DIG_CFG, &tmp)) |
| return(0); |
| |
| tmp |= PHY_LXT971_DIG_CFG_MII_DRIVE; |
| |
| davinci_eth_phy_write(phy_addr, PHY_LXT971_DIG_CFG, tmp); |
| /* Read back */ |
| if (!davinci_eth_phy_read(phy_addr, PHY_LXT971_DIG_CFG, &tmp)) |
| return(0); |
| |
| /* Speed doesn't matter, there is no setting for it in EMAC... */ |
| if (stat1 & PHY_LXT971_STAT2_DUPLEX_MODE) { |
| /* set DM644x EMAC for Full Duplex */ |
| emac->MACCONTROL = EMAC_MACCONTROL_MIIEN_ENABLE | |
| EMAC_MACCONTROL_FULLDUPLEX_ENABLE; |
| } else { |
| /*set DM644x EMAC for Half Duplex */ |
| emac->MACCONTROL = EMAC_MACCONTROL_MIIEN_ENABLE; |
| } |
| |
| return(1); |
| } |
| |
| |
| int lxt972_init_phy(int phy_addr) |
| { |
| int ret = 1; |
| |
| if (!lxt972_get_link_speed(phy_addr)) { |
| /* Try another time */ |
| ret = lxt972_get_link_speed(phy_addr); |
| } |
| |
| /* Disable PHY Interrupts */ |
| davinci_eth_phy_write(phy_addr, PHY_LXT971_INT_ENABLE, 0); |
| |
| return(ret); |
| } |
| |
| |
| int lxt972_auto_negotiate(int phy_addr) |
| { |
| u_int16_t tmp; |
| |
| if (!davinci_eth_phy_read(phy_addr, MII_BMCR, &tmp)) |
| return(0); |
| |
| /* Restart Auto_negotiation */ |
| tmp |= BMCR_ANRESTART; |
| davinci_eth_phy_write(phy_addr, MII_BMCR, tmp); |
| |
| /*check AutoNegotiate complete */ |
| udelay (10000); |
| if (!davinci_eth_phy_read(phy_addr, MII_BMSR, &tmp)) |
| return(0); |
| |
| if (!(tmp & BMSR_ANEGCOMPLETE)) |
| return(0); |
| |
| return (lxt972_get_link_speed(phy_addr)); |
| } |
| |
| #endif /* CONFIG_CMD_NET */ |
| |
| #endif /* CONFIG_DRIVER_ETHER */ |