blob: 598b4b1c2f5cfd43c5b6c428e8da90a75a489542 [file] [log] [blame]
Intel Interrupt Router Device Binding
=====================================
The device tree node which describes the operation of the Intel Interrupt Router
device is as follows:
Required properties :
- reg : Specifies the interrupt router's PCI configuration space address as
defined by the Open Firmware spec.
- compatible = "intel,irq-router"
- intel,pirq-config : Specifies the IRQ routing register programming mechanism.
Valid values are:
"pci": IRQ routing is controlled by PCI configuration registers
"ibase": IRQ routing is in the memory-mapped IBASE register block
- intel,ibase-offset : IBASE register offset in the interrupt router's PCI
configuration space, required only if intel,pirq-config = "ibase".
- intel,pirq-link : Specifies the PIRQ link information with two cells. The
first cell is the register offset that controls the first PIRQ link routing.
The second cell is the total number of PIRQ links the router supports.
- intel,pirq-mask : Specifies the IRQ mask reprenting the 16 IRQs in 8259 PIC.
Bit N is 1 means IRQ N is available to be routed.
- intel,pirq-routing : Specifies all PCI devices' IRQ routing information,
encoded as 3 cells a group for a device. The first cell is the device's PCI
bus number, device number and function number encoding with PCI_BDF() macro.
The second cell is the PCI interrupt pin used by this device. The last cell
is which PIRQ line the PCI interrupt pin is routed to.
Example
-------
#include <dt-bindings/interrupt-router/intel-irq.h>
irq-router@1f,0 {
reg = <0x0000f800 0 0 0 0>;
compatible = "intel,irq-router";
intel,pirq-config = "pci";
intel,pirq-link = <0x60 8>;
intel,pirq-mask = <0xdef8>;
intel,pirq-routing = <
PCI_BDF(0, 2, 0) INTA PIRQA
PCI_BDF(0, 3, 0) INTA PIRQB
PCI_BDF(0, 8, 0) INTA PIRQC
PCI_BDF(0, 8, 1) INTB PIRQD
PCI_BDF(1, 6, 0) INTA PIRQE
PCI_BDF(1, 6, 1) INTB PIRQF
PCI_BDF(1, 6, 2) INTC PIRQG
PCI_BDF(1, 6, 3) INTD PIRQH
>;
};