| // SPDX-License-Identifier: GPL-2.0+ |
| /* |
| * (C) Copyright 2010-2013 |
| * NVIDIA Corporation <www.nvidia.com> |
| */ |
| |
| #include <common.h> |
| #include <dm.h> |
| #include <asm/arch/pinmux.h> |
| #include <asm/arch/gp_padctrl.h> |
| #include <asm/arch/gpio.h> |
| #include <asm/gpio.h> |
| #include "pinmux-config-cardhu.h" |
| #include <i2c.h> |
| |
| #define PMU_I2C_ADDRESS 0x2D |
| #define MAX_I2C_RETRY 3 |
| |
| /* |
| * Routine: pinmux_init |
| * Description: Do individual peripheral pinmux configs |
| */ |
| void pinmux_init(void) |
| { |
| pinmux_config_pingrp_table(tegra3_pinmux_common, |
| ARRAY_SIZE(tegra3_pinmux_common)); |
| |
| pinmux_config_pingrp_table(unused_pins_lowpower, |
| ARRAY_SIZE(unused_pins_lowpower)); |
| |
| /* Initialize any non-default pad configs (APB_MISC_GP regs) */ |
| pinmux_config_drvgrp_table(cardhu_padctrl, ARRAY_SIZE(cardhu_padctrl)); |
| } |
| |
| #if defined(CONFIG_MMC_SDHCI_TEGRA) |
| /* |
| * Do I2C/PMU writes to bring up SD card bus power |
| * |
| */ |
| void board_sdmmc_voltage_init(void) |
| { |
| struct udevice *dev; |
| uchar reg, data_buffer[1]; |
| int ret; |
| int i; |
| |
| ret = i2c_get_chip_for_busnum(0, PMU_I2C_ADDRESS, 1, &dev); |
| if (ret) { |
| debug("%s: Cannot find PMIC I2C chip\n", __func__); |
| return; |
| } |
| |
| /* TPS659110: LDO5_REG = 3.3v, ACTIVE to SDMMC1 */ |
| data_buffer[0] = 0x65; |
| reg = 0x32; |
| |
| for (i = 0; i < MAX_I2C_RETRY; ++i) { |
| if (dm_i2c_write(dev, reg, data_buffer, 1)) |
| udelay(100); |
| } |
| |
| /* TPS659110: GPIO7_REG = PDEN, output a 1 to EN_3V3_SYS */ |
| data_buffer[0] = 0x09; |
| reg = 0x67; |
| |
| for (i = 0; i < MAX_I2C_RETRY; ++i) { |
| if (dm_i2c_write(dev, reg, data_buffer, 1)) |
| udelay(100); |
| } |
| } |
| |
| /* |
| * Routine: pin_mux_mmc |
| * Description: setup the MMC muxes, power rails, etc. |
| */ |
| void pin_mux_mmc(void) |
| { |
| /* |
| * NOTE: We don't do mmc-specific pin muxes here. |
| * They were done globally in pinmux_init(). |
| */ |
| |
| /* Bring up the SDIO1 power rail */ |
| board_sdmmc_voltage_init(); |
| } |
| #endif /* MMC */ |
| |
| #ifdef CONFIG_PCI_TEGRA |
| int tegra_pcie_board_init(void) |
| { |
| struct udevice *dev; |
| u8 addr, data[1]; |
| int err; |
| |
| err = i2c_get_chip_for_busnum(0, PMU_I2C_ADDRESS, 1, &dev); |
| if (err) { |
| debug("failed to find PMU bus\n"); |
| return err; |
| } |
| |
| /* TPS659110: LDO1_REG = 1.05V, ACTIVE */ |
| data[0] = 0x15; |
| addr = 0x30; |
| |
| err = dm_i2c_write(dev, addr, data, 1); |
| if (err) { |
| debug("failed to set VDD supply\n"); |
| return err; |
| } |
| |
| /* GPIO: PEX = 3.3V */ |
| err = gpio_request(TEGRA_GPIO(L, 7), "PEX"); |
| if (err < 0) |
| return err; |
| |
| gpio_direction_output(TEGRA_GPIO(L, 7), 1); |
| |
| /* TPS659110: LDO2_REG = 1.05V, ACTIVE */ |
| data[0] = 0x15; |
| addr = 0x31; |
| |
| err = dm_i2c_write(dev, addr, data, 1); |
| if (err) { |
| debug("failed to set AVDD supply\n"); |
| return err; |
| } |
| |
| return 0; |
| } |
| #endif /* PCI */ |