| /* SPDX-License-Identifier: GPL-2.0+ */ |
| /* |
| * Configuation settings for the Renesas Solutions Migo-R board |
| * |
| * Copyright (C) 2007 Nobuhiro Iwamatsu <iwamatsu@nigauri.org> |
| */ |
| |
| #ifndef __MIGO_R_H |
| #define __MIGO_R_H |
| |
| #define CONFIG_CPU_SH7722 1 |
| |
| #define CONFIG_DISPLAY_BOARDINFO |
| |
| /* SMC9111 */ |
| #define CONFIG_SMC91111 |
| #define CONFIG_SMC91111_BASE (0xB0000000) |
| |
| /* MEMORY */ |
| #define MIGO_R_SDRAM_BASE (0x8C000000) |
| #define MIGO_R_FLASH_BASE_1 (0xA0000000) |
| #define MIGO_R_FLASH_BANK_SIZE (64 * 1024 * 1024) |
| |
| #define CONFIG_SYS_PBSIZE 256 /* Buffer size for Console output */ |
| #define CONFIG_SYS_BAUDRATE_TABLE { 115200 } /* List of legal baudrate settings for this board */ |
| |
| /* SCIF */ |
| #define CONFIG_CONS_SCIF0 1 |
| |
| /* Enable alternate, more extensive, memory test */ |
| /* Scratch address used by the alternate memory test */ |
| |
| /* Enable temporary baudrate change while serial download */ |
| #undef CONFIG_SYS_LOADS_BAUD_CHANGE |
| |
| #define CONFIG_SYS_SDRAM_BASE (MIGO_R_SDRAM_BASE) |
| /* maybe more, but if so u-boot doesn't know about it... */ |
| #define CONFIG_SYS_SDRAM_SIZE (64 * 1024 * 1024) |
| /* default load address for scripts ?!? */ |
| #define CONFIG_SYS_LOAD_ADDR (CONFIG_SYS_SDRAM_BASE + 16 * 1024 * 1024) |
| |
| /* Address of u-boot image in Flash (NOT run time address in SDRAM) ?!? */ |
| #define CONFIG_SYS_MONITOR_BASE (MIGO_R_FLASH_BASE_1) |
| /* Monitor size */ |
| #define CONFIG_SYS_MONITOR_LEN (128 * 1024) |
| /* Size of DRAM reserved for malloc() use */ |
| #define CONFIG_SYS_MALLOC_LEN (256 * 1024) |
| #define CONFIG_SYS_BOOTMAPSZ (8 * 1024 * 1024) |
| |
| /* FLASH */ |
| #undef CONFIG_SYS_FLASH_QUIET_TEST |
| /* print 'E' for empty sector on flinfo */ |
| #define CONFIG_SYS_FLASH_EMPTY_INFO |
| /* Physical start address of Flash memory */ |
| #define CONFIG_SYS_FLASH_BASE (MIGO_R_FLASH_BASE_1) |
| /* Max number of sectors on each Flash chip */ |
| #define CONFIG_SYS_MAX_FLASH_SECT 512 |
| |
| /* if you use all NOR Flash , you change dip-switch. Please see MIGO_R01 Manual. */ |
| #define CONFIG_SYS_MAX_FLASH_BANKS 1 |
| #define CONFIG_SYS_FLASH_BANKS_LIST { CONFIG_SYS_FLASH_BASE + (0 * MIGO_R_FLASH_BANK_SIZE) } |
| |
| /* Timeout for Flash erase operations (in ms) */ |
| #define CONFIG_SYS_FLASH_ERASE_TOUT (3 * 1000) |
| /* Timeout for Flash write operations (in ms) */ |
| #define CONFIG_SYS_FLASH_WRITE_TOUT (3 * 1000) |
| /* Timeout for Flash set sector lock bit operations (in ms) */ |
| #define CONFIG_SYS_FLASH_LOCK_TOUT (3 * 1000) |
| /* Timeout for Flash clear lock bit operations (in ms) */ |
| #define CONFIG_SYS_FLASH_UNLOCK_TOUT (3 * 1000) |
| |
| /* Use hardware flash sectors protection instead of U-Boot software protection */ |
| #undef CONFIG_SYS_DIRECT_FLASH_TFTP |
| |
| /* ENV setting */ |
| /* Offset of env Flash sector relative to CONFIG_SYS_FLASH_BASE */ |
| |
| /* Board Clock */ |
| #define CONFIG_SYS_CLK_FREQ 33333333 |
| #define CONFIG_SH_SCIF_CLK_FREQ CONFIG_SYS_CLK_FREQ |
| |
| #endif /* __MIGO_R_H */ |