blob: a6a41780c96f245f79ac5d797c5f2fed5abffd20 [file] [log] [blame]
// SPDX-License-Identifier: GPL-2.0+ OR BSD-3-Clause
/*
* Copyright (C) 2018, STMicroelectronics - All Rights Reserved
*/
#include <config.h>
#include <common.h>
#include <init.h>
#include <asm/io.h>
#include <asm/arch/sys_proto.h>
#include <linux/bitops.h>
#include <linux/delay.h>
#include "../common/stpmic1.h"
/* board early initialisation in board_f: need to use global variable */
static u32 opp_voltage_mv __section(".data");
void board_vddcore_init(u32 voltage_mv)
{
if (IS_ENABLED(CONFIG_PMIC_STPMIC1) && CONFIG_IS_ENABLED(POWER_SUPPORT))
opp_voltage_mv = voltage_mv;
}
int board_early_init_f(void)
{
if (IS_ENABLED(CONFIG_PMIC_STPMIC1) && CONFIG_IS_ENABLED(POWER_SUPPORT))
stpmic1_init(opp_voltage_mv);
return 0;
}
#ifdef CONFIG_DEBUG_UART_BOARD_INIT
void board_debug_uart_init(void)
{
#if (CONFIG_DEBUG_UART_BASE == STM32_UART4_BASE)
#define RCC_MP_APB1ENSETR (STM32_RCC_BASE + 0x0A00)
#define RCC_MP_AHB4ENSETR (STM32_RCC_BASE + 0x0A28)
/* UART4 clock enable */
setbits_le32(RCC_MP_APB1ENSETR, BIT(16));
#define GPIOG_BASE 0x50008000
/* GPIOG clock enable */
writel(BIT(6), RCC_MP_AHB4ENSETR);
/* GPIO configuration for ST boards: Uart4 TX = G11 */
writel(0xffbfffff, GPIOG_BASE + 0x00);
writel(0x00006000, GPIOG_BASE + 0x24);
#else
#error("CONFIG_DEBUG_UART_BASE: not supported value")
#endif
}
#endif