| CONFIG_ARM=y |
| # CONFIG_SYS_THUMB_BUILD is not set |
| CONFIG_ARCH_OMAP2PLUS=y |
| CONFIG_SYS_TEXT_BASE=0x80100000 |
| CONFIG_SYS_MALLOC_LEN=0x120000 |
| CONFIG_SYS_MALLOC_F_LEN=0x400 |
| CONFIG_NR_DRAM_BANKS=2 |
| CONFIG_SPL_TEXT_BASE=0x40200000 |
| CONFIG_TARGET_SNIPER=y |
| CONFIG_SPL=y |
| CONFIG_DISTRO_DEFAULTS=y |
| CONFIG_BOOTCOMMAND="setenv boot_mmc_part ${kernel_mmc_part}; if test reboot-${reboot-mode} = reboot-r; then echo recovery; setenv boot_mmc_part ${recovery_mmc_part}; fi; if test reboot-${reboot-mode} = reboot-b; then echo fastboot; fastboot 0; fi; part start mmc ${boot_mmc_dev} ${boot_mmc_part} boot_mmc_start; part size mmc ${boot_mmc_dev} ${boot_mmc_part} boot_mmc_size; mmc dev ${boot_mmc_dev}; mmc read ${kernel_addr_r} ${boot_mmc_start} ${boot_mmc_size} && bootm ${kernel_addr_r};" |
| CONFIG_SYS_CONSOLE_IS_IN_ENV=y |
| # CONFIG_SYS_MMCSD_RAW_MODE_U_BOOT_USE_SECTOR is not set |
| CONFIG_SYS_MMCSD_RAW_MODE_U_BOOT_USE_PARTITION=y |
| CONFIG_SYS_MMCSD_RAW_MODE_U_BOOT_PARTITION=2 |
| # CONFIG_SPL_FS_EXT4 is not set |
| # CONFIG_SPL_NAND_SUPPORT is not set |
| CONFIG_SYS_PROMPT="sniper # " |
| CONFIG_SYS_CBSIZE=512 |
| CONFIG_SYS_PBSIZE=538 |
| CONFIG_CMD_GPIO=y |
| CONFIG_CMD_I2C=y |
| CONFIG_CMD_MMC=y |
| # CONFIG_CMD_SETEXPR is not set |
| # CONFIG_CMD_NFS is not set |
| CONFIG_ENV_OVERWRITE=y |
| CONFIG_SYS_RELOC_GD_ENV_ADDR=y |
| CONFIG_SYS_I2C_LEGACY=y |
| CONFIG_SPL_SYS_I2C_LEGACY=y |
| CONFIG_SYS_I2C_SPEED=400000 |
| CONFIG_TWL4030_INPUT=y |
| CONFIG_MMC_OMAP_HS=y |
| CONFIG_CONS_INDEX=3 |
| CONFIG_OF_LIBFDT=y |