| Update from original Marvell U-Boot to mainline U-Boot: |
| ------------------------------------------------------- |
| Generate the U-Boot image with these commands: |
| The resulting image including the SPL binary with the |
| full DDR setup is "u-boot-with-spl.kwb". |
| Now all you need to do is copy this image on a SD card. |
| For example with this command: |
| $ sudo dd if=u-boot-with-spl.kwb of=/dev/sdX bs=512 seek=1 |
| Please use the correct device node for your setup instead |
| Before powering up the board, boot selection should be done via the SW1 dip |
| Connect the on-board micro-USB (CF Pro: CON11, CF Base: CON5) |
| Set the SW1 DIP switches to UART boot (see above). |
| Run the following command to initiate U-Boot download: |
| ./tools/kwboot -p -b u-boot-with-spl.kwb /dev/ttyUSBX |
| Use the correct UART device node for /dev/ttyUSBX. |
| When download finishes start your favorite terminal emulator |