| /* |
| * Copyright (C) 2014 Gateworks Corporation |
| * Author: Tim Harvey <tharvey@gateworks.com> |
| * |
| * SPDX-License-Identifier: GPL-2.0+ |
| */ |
| #ifndef __IMX6_SPL_CONFIG_H |
| #define __IMX6_SPL_CONFIG_H |
| |
| #ifdef CONFIG_SPL |
| |
| #define CONFIG_SPL_FRAMEWORK |
| |
| /* |
| * see Figure 8-3 in IMX6DQ/IMX6SDL Reference manuals: |
| * - IMX6SDL OCRAM (IRAM) is from 0x00907000 to 0x0091FFFF |
| * - IMX6DQ has 2x IRAM of IMX6SDL but we intend to support IMX6SDL as well |
| * - BOOT ROM stack is at 0x0091FFB8 |
| * - if icache/dcache is enabled (eFuse/strapping controlled) then the |
| * IMX BOOT ROM will setup MMU table at 0x00918000, therefore we need to |
| * fit between 0x00907000 and 0x00918000. |
| * - Additionally the BOOT ROM loads what they consider the firmware image |
| * which consists of a 4K header in front of us that contains the IVT, DCD |
| * and some padding thus 'our' max size is really 0x00908000 - 0x00918000 |
| * or 64KB |
| */ |
| #define CONFIG_SYS_THUMB_BUILD |
| #define CONFIG_SPL_LDSCRIPT "arch/arm/cpu/armv7/omap-common/u-boot-spl.lds" |
| #define CONFIG_SPL_TEXT_BASE 0x00908000 |
| #define CONFIG_SPL_MAX_SIZE 0x10000 |
| #define CONFIG_SPL_STACK 0x0091FFB8 |
| #define CONFIG_SPL_LIBCOMMON_SUPPORT |
| #define CONFIG_SPL_LIBGENERIC_SUPPORT |
| #define CONFIG_SPL_SERIAL_SUPPORT |
| #define CONFIG_SPL_I2C_SUPPORT |
| #define CONFIG_SPL_GPIO_SUPPORT |
| |
| /* NAND support */ |
| #if defined(CONFIG_SPL_NAND_SUPPORT) |
| #define CONFIG_SPL_NAND_MXS |
| #define CONFIG_SPL_DMA_SUPPORT |
| #endif |
| |
| /* MMC support */ |
| #if defined(CONFIG_SPL_MMC_SUPPORT) |
| #define CONFIG_SYS_MMCSD_RAW_MODE_U_BOOT_SECTOR 138 /* offset 69KB */ |
| #define CONFIG_SYS_U_BOOT_MAX_SIZE_SECTORS 800 /* 400 KB */ |
| #define CONFIG_SYS_MMCSD_FS_BOOT_PARTITION 1 |
| #define CONFIG_SYS_MONITOR_LEN (CONFIG_SYS_U_BOOT_MAX_SIZE_SECTORS/2*1024) |
| #endif |
| |
| /* SATA support */ |
| #if defined(CONFIG_SPL_SATA_SUPPORT) |
| #define CONFIG_SPL_SATA_BOOT_DEVICE 0 |
| #define CONFIG_SYS_SATA_FAT_BOOT_PARTITION 1 |
| #endif |
| |
| /* Define the payload for FAT/EXT support */ |
| #if defined(CONFIG_SPL_FAT_SUPPORT) || defined(CONFIG_SPL_EXT_SUPPORT) |
| #define CONFIG_SPL_FS_LOAD_PAYLOAD_NAME "u-boot.img" |
| #define CONFIG_SPL_LIBDISK_SUPPORT |
| #endif |
| |
| #if defined(CONFIG_MX6SX) || defined(CONFIG_MX6UL) || defined(CONFIG_MX6SL) |
| #define CONFIG_SPL_BSS_START_ADDR 0x88200000 |
| #define CONFIG_SPL_BSS_MAX_SIZE 0x100000 /* 1 MB */ |
| #define CONFIG_SYS_SPL_MALLOC_START 0x88300000 |
| #define CONFIG_SYS_SPL_MALLOC_SIZE 0x3200000 /* 50 MB */ |
| #define CONFIG_SYS_TEXT_BASE 0x87800000 |
| #else |
| #define CONFIG_SPL_BSS_START_ADDR 0x18200000 |
| #define CONFIG_SPL_BSS_MAX_SIZE 0x100000 /* 1 MB */ |
| #define CONFIG_SYS_SPL_MALLOC_START 0x18300000 |
| #define CONFIG_SYS_SPL_MALLOC_SIZE 0x3200000 /* 50 MB */ |
| #define CONFIG_SYS_TEXT_BASE 0x17800000 |
| #endif |
| #endif |
| |
| #endif |