| // SPDX-License-Identifier: GPL-2.0+ |
| /* |
| * (C) Copyright 2008 |
| * Gururaja Hebbar gururajakr@sanyo.co.in |
| * |
| * reference linux-2.6.20.6/drivers/rtc/rtc-pl031.c |
| */ |
| |
| #include <common.h> |
| #include <command.h> |
| #include <rtc.h> |
| |
| #if defined(CONFIG_CMD_DATE) |
| |
| #ifndef CONFIG_SYS_RTC_PL031_BASE |
| #error CONFIG_SYS_RTC_PL031_BASE is not defined! |
| #endif |
| |
| /* |
| * Register definitions |
| */ |
| #define RTC_DR 0x00 /* Data read register */ |
| #define RTC_MR 0x04 /* Match register */ |
| #define RTC_LR 0x08 /* Data load register */ |
| #define RTC_CR 0x0c /* Control register */ |
| #define RTC_IMSC 0x10 /* Interrupt mask and set register */ |
| #define RTC_RIS 0x14 /* Raw interrupt status register */ |
| #define RTC_MIS 0x18 /* Masked interrupt status register */ |
| #define RTC_ICR 0x1c /* Interrupt clear register */ |
| |
| #define RTC_CR_START (1 << 0) |
| |
| #define RTC_WRITE_REG(addr, val) \ |
| (*(volatile unsigned int *)(CONFIG_SYS_RTC_PL031_BASE + (addr)) = (val)) |
| #define RTC_READ_REG(addr) \ |
| (*(volatile unsigned int *)(CONFIG_SYS_RTC_PL031_BASE + (addr))) |
| |
| static int pl031_initted = 0; |
| |
| /* Enable RTC Start in Control register*/ |
| void rtc_init(void) |
| { |
| RTC_WRITE_REG(RTC_CR, RTC_CR_START); |
| |
| pl031_initted = 1; |
| } |
| |
| /* |
| * Reset the RTC. We set the date back to 1970-01-01. |
| */ |
| void rtc_reset(void) |
| { |
| RTC_WRITE_REG(RTC_LR, 0x00); |
| if(!pl031_initted) |
| rtc_init(); |
| } |
| |
| /* |
| * Set the RTC |
| */ |
| int rtc_set(struct rtc_time *tmp) |
| { |
| unsigned long tim; |
| |
| if(!pl031_initted) |
| rtc_init(); |
| |
| if (tmp == NULL) { |
| puts("Error setting the date/time\n"); |
| return -1; |
| } |
| |
| /* Calculate number of seconds this incoming time represents */ |
| tim = rtc_mktime(tmp); |
| |
| RTC_WRITE_REG(RTC_LR, tim); |
| |
| return -1; |
| } |
| |
| /* |
| * Get the current time from the RTC |
| */ |
| int rtc_get(struct rtc_time *tmp) |
| { |
| ulong tim; |
| |
| if(!pl031_initted) |
| rtc_init(); |
| |
| if (tmp == NULL) { |
| puts("Error getting the date/time\n"); |
| return -1; |
| } |
| |
| tim = RTC_READ_REG(RTC_DR); |
| |
| rtc_to_tm(tim, tmp); |
| |
| debug ( "Get DATE: %4d-%02d-%02d (wday=%d) TIME: %2d:%02d:%02d\n", |
| tmp->tm_year, tmp->tm_mon, tmp->tm_mday, tmp->tm_wday, |
| tmp->tm_hour, tmp->tm_min, tmp->tm_sec); |
| |
| return 0; |
| } |
| |
| #endif |