| CONFIG_ARM=y |
| CONFIG_ARCH_AT91=y |
| CONFIG_SYS_TEXT_BASE=0x23f00000 |
| CONFIG_TARGET_SAM9X60EK=y |
| CONFIG_SYS_MALLOC_F_LEN=0x2000 |
| CONFIG_DM_GPIO=y |
| CONFIG_NR_DRAM_BANKS=8 |
| CONFIG_DEBUG_UART_BOARD_INIT=y |
| CONFIG_DEBUG_UART_BASE=0xfffff200 |
| CONFIG_DEBUG_UART_CLOCK=200000000 |
| CONFIG_ENV_OFFSET_REDUND=0x100000 |
| CONFIG_DEBUG_UART=y |
| CONFIG_FIT=y |
| CONFIG_NAND_BOOT=y |
| CONFIG_BOOTDELAY=3 |
| CONFIG_USE_BOOTARGS=y |
| CONFIG_BOOTARGS="console=ttyS0,115200 earlyprintk mtdparts=atmel_nand:256k(bootstrap)ro,768k(uboot)ro,256k(env_redundant),256k(env),512k(dtb),6M(kernel)ro,-(rootfs) rootfstype=ubifs ubi.mtd=12 root=ubi0:rootfs rw" |
| CONFIG_SYS_CONSOLE_IS_IN_ENV=y |
| CONFIG_MISC_INIT_R=y |
| # CONFIG_DISPLAY_BOARDINFO is not set |
| CONFIG_HUSH_PARSER=y |
| CONFIG_SYS_PROMPT="U-Boot> " |
| CONFIG_CMD_BOOTZ=y |
| CONFIG_CMD_DM=y |
| # CONFIG_CMD_FLASH is not set |
| CONFIG_CMD_I2C=y |
| CONFIG_CMD_MMC=y |
| CONFIG_CMD_NAND=y |
| CONFIG_CMD_NAND_TRIMFFS=y |
| # CONFIG_CMD_SETEXPR is not set |
| CONFIG_CMD_DHCP=y |
| CONFIG_CMD_MII=y |
| CONFIG_CMD_PING=y |
| CONFIG_CMD_FAT=y |
| CONFIG_CMD_UBI=y |
| CONFIG_OF_CONTROL=y |
| CONFIG_DEFAULT_DEVICE_TREE="sam9x60ek" |
| CONFIG_ENV_IS_IN_NAND=y |
| CONFIG_SYS_REDUNDAND_ENVIRONMENT=y |
| CONFIG_SYS_RELOC_GD_ENV_ADDR=y |
| CONFIG_DM=y |
| CONFIG_CLK=y |
| CONFIG_CLK_AT91=y |
| CONFIG_AT91_GENERIC_CLK=y |
| CONFIG_AT91_GPIO=y |
| CONFIG_DM_I2C=y |
| CONFIG_SYS_I2C_AT91=y |
| CONFIG_I2C_EEPROM=y |
| CONFIG_MICROCHIP_FLEXCOM=y |
| CONFIG_DM_MMC=y |
| CONFIG_GENERIC_ATMEL_MCI=y |
| CONFIG_MTD=y |
| CONFIG_PHY_MICREL=y |
| CONFIG_DM_ETH=y |
| CONFIG_MACB=y |
| CONFIG_PINCTRL=y |
| CONFIG_PINCTRL_AT91=y |
| CONFIG_DM_SERIAL=y |
| CONFIG_DEBUG_UART_ANNOUNCE=y |
| CONFIG_ATMEL_USART=y |
| CONFIG_TIMER=y |
| CONFIG_ATMEL_PIT_TIMER=y |
| CONFIG_W1=y |
| CONFIG_W1_GPIO=y |
| CONFIG_W1_EEPROM=y |
| CONFIG_W1_EEPROM_DS24XXX=y |
| CONFIG_OF_LIBFDT_OVERLAY=y |