| /dts-v1/; |
| #include "bcm2837.dtsi" |
| #include "bcm2835-rpi.dtsi" |
| #include "bcm283x-rpi-smsc9514.dtsi" |
| #include "bcm283x-rpi-usb-host.dtsi" |
| |
| / { |
| compatible = "raspberrypi,3-model-b", "brcm,bcm2837"; |
| model = "Raspberry Pi 3 Model B"; |
| |
| memory { |
| reg = <0 0x40000000>; |
| }; |
| |
| leds { |
| act { |
| gpios = <&gpio 47 0>; |
| }; |
| }; |
| }; |
| |
| /* uart0 communicates with the BT module */ |
| &uart0 { |
| pinctrl-names = "default"; |
| pinctrl-0 = <&uart0_gpio32 &gpclk2_gpio43>; |
| status = "okay"; |
| }; |
| |
| /* uart1 is mapped to the pin header */ |
| &uart1 { |
| pinctrl-names = "default"; |
| pinctrl-0 = <&uart1_gpio14>; |
| status = "okay"; |
| }; |
| |
| /* SDHCI is used to control the SDIO for wireless */ |
| &sdhci { |
| pinctrl-names = "default"; |
| pinctrl-0 = <&emmc_gpio34>; |
| status = "okay"; |
| bus-width = <4>; |
| non-removable; |
| }; |
| |
| /* SDHOST is used to drive the SD card */ |
| &sdhost { |
| pinctrl-names = "default"; |
| pinctrl-0 = <&sdhost_gpio48>; |
| status = "okay"; |
| bus-width = <4>; |
| }; |