blob: a354d992da72337f47121ff61173acfb32f42e9e [file] [log] [blame]
/*
* (C) Copyright 2015 Google, Inc
*
* SPDX-License-Identifier: GPL-2.0+
*/
#include <common.h>
#include <clk.h>
#include <dm.h>
#include <ram.h>
#include <syscon.h>
#include <asm/io.h>
#include <asm/arch/clock.h>
#include <asm/arch/periph.h>
#include <asm/arch/pmu_rk3288.h>
#include <asm/arch/qos_rk3288.h>
#include <asm/arch/boot_mode.h>
#include <asm/gpio.h>
#include <dm/pinctrl.h>
#include <dt-bindings/clock/rk3288-cru.h>
#include <power/regulator.h>
DECLARE_GLOBAL_DATA_PTR;
#define PMU_BASE 0xff730000
static void setup_boot_mode(void)
{
struct rk3288_pmu *const pmu = (void *)PMU_BASE;
int boot_mode = readl(&pmu->sys_reg[0]);
debug("boot mode %x.\n", boot_mode);
/* Clear boot mode */
writel(BOOT_NORMAL, &pmu->sys_reg[0]);
switch (boot_mode) {
case BOOT_FASTBOOT:
printf("enter fastboot!\n");
setenv("preboot", "setenv preboot; fastboot usb0");
break;
case BOOT_UMS:
printf("enter UMS!\n");
setenv("preboot", "setenv preboot; if mmc dev 0;"
"then ums mmc 0; else ums mmc 1;fi");
break;
}
}
__weak int rk_board_late_init(void)
{
return 0;
}
int rk3288_qos_init(void)
{
int val = 2 << PRIORITY_HIGH_SHIFT | 2 << PRIORITY_LOW_SHIFT;
/* set vop qos to higher priority */
writel(val, CPU_AXI_QOS_PRIORITY + VIO0_VOP_QOS);
writel(val, CPU_AXI_QOS_PRIORITY + VIO1_VOP_QOS);
if (!fdt_node_check_compatible(gd->fdt_blob, 0,
"rockchip,rk3288-tinker"))
{
/* set isp qos to higher priority */
writel(val, CPU_AXI_QOS_PRIORITY + VIO1_ISP_R_QOS);
writel(val, CPU_AXI_QOS_PRIORITY + VIO1_ISP_W0_QOS);
writel(val, CPU_AXI_QOS_PRIORITY + VIO1_ISP_W1_QOS);
}
return 0;
}
int board_late_init(void)
{
setup_boot_mode();
rk3288_qos_init();
return rk_board_late_init();
}
#ifndef CONFIG_ROCKCHIP_SPL_BACK_TO_BROM
static int veyron_init(void)
{
struct udevice *dev;
struct clk clk;
int ret;
ret = regulator_get_by_platname("vdd_arm", &dev);
if (ret) {
debug("Cannot set regulator name\n");
return ret;
}
/* Slowly raise to max CPU voltage to prevent overshoot */
ret = regulator_set_value(dev, 1200000);
if (ret)
return ret;
udelay(175); /* Must wait for voltage to stabilize, 2mV/us */
ret = regulator_set_value(dev, 1400000);
if (ret)
return ret;
udelay(100); /* Must wait for voltage to stabilize, 2mV/us */
ret = rockchip_get_clk(&clk.dev);
if (ret)
return ret;
clk.id = PLL_APLL;
ret = clk_set_rate(&clk, 1800000000);
if (IS_ERR_VALUE(ret))
return ret;
return 0;
}
#endif
int board_init(void)
{
#ifdef CONFIG_ROCKCHIP_SPL_BACK_TO_BROM
struct udevice *pinctrl;
int ret;
/*
* We need to implement sdcard iomux here for the further
* initlization, otherwise, it'll hit sdcard command sending
* timeout exception.
*/
ret = uclass_get_device(UCLASS_PINCTRL, 0, &pinctrl);
if (ret) {
debug("%s: Cannot find pinctrl device\n", __func__);
goto err;
}
ret = pinctrl_request_noflags(pinctrl, PERIPH_ID_SDCARD);
if (ret) {
debug("%s: Failed to set up SD card\n", __func__);
goto err;
}
return 0;
err:
printf("board_init: Error %d\n", ret);
/* No way to report error here */
hang();
return -1;
#else
int ret;
/* We do some SoC one time setting here */
if (!fdt_node_check_compatible(gd->fdt_blob, 0, "google,veyron")) {
ret = veyron_init();
if (ret)
return ret;
}
return 0;
#endif
}
int dram_init(void)
{
struct ram_info ram;
struct udevice *dev;
int ret;
ret = uclass_get_device(UCLASS_RAM, 0, &dev);
if (ret) {
debug("DRAM init failed: %d\n", ret);
return ret;
}
ret = ram_get_info(dev, &ram);
if (ret) {
debug("Cannot get DRAM size: %d\n", ret);
return ret;
}
debug("SDRAM base=%lx, size=%x\n", ram.base, ram.size);
gd->ram_size = ram.size;
return 0;
}
#ifndef CONFIG_SYS_DCACHE_OFF
void enable_caches(void)
{
/* Enable D-cache. I-cache is already enabled in start.S */
dcache_enable();
}
#endif
#if defined(CONFIG_USB_GADGET) && defined(CONFIG_USB_GADGET_DWC2_OTG)
#include <usb.h>
#include <usb/dwc2_udc.h>
static struct dwc2_plat_otg_data rk3288_otg_data = {
.rx_fifo_sz = 512,
.np_tx_fifo_sz = 16,
.tx_fifo_sz = 128,
};
int board_usb_init(int index, enum usb_init_type init)
{
int node, phy_node;
const char *mode;
bool matched = false;
const void *blob = gd->fdt_blob;
u32 grf_phy_offset;
/* find the usb_otg node */
node = fdt_node_offset_by_compatible(blob, -1,
"rockchip,rk3288-usb");
while (node > 0) {
mode = fdt_getprop(blob, node, "dr_mode", NULL);
if (mode && strcmp(mode, "otg") == 0) {
matched = true;
break;
}
node = fdt_node_offset_by_compatible(blob, node,
"rockchip,rk3288-usb");
}
if (!matched) {
debug("Not found usb_otg device\n");
return -ENODEV;
}
rk3288_otg_data.regs_otg = fdtdec_get_addr(blob, node, "reg");
node = fdtdec_lookup_phandle(blob, node, "phys");
if (node <= 0) {
debug("Not found usb phy device\n");
return -ENODEV;
}
phy_node = fdt_parent_offset(blob, node);
if (phy_node <= 0) {
debug("Not found usb phy device\n");
return -ENODEV;
}
rk3288_otg_data.phy_of_node = phy_node;
grf_phy_offset = fdtdec_get_addr(blob, node, "reg");
/* find the grf node */
node = fdt_node_offset_by_compatible(blob, -1,
"rockchip,rk3288-grf");
if (node <= 0) {
debug("Not found grf device\n");
return -ENODEV;
}
rk3288_otg_data.regs_phy = grf_phy_offset +
fdtdec_get_addr(blob, node, "reg");
return dwc2_udc_probe(&rk3288_otg_data);
}
int board_usb_cleanup(int index, enum usb_init_type init)
{
return 0;
}
#endif
static int do_clock(cmd_tbl_t *cmdtp, int flag, int argc,
char * const argv[])
{
static const struct {
char *name;
int id;
} clks[] = {
{ "osc", CLK_OSC },
{ "apll", CLK_ARM },
{ "dpll", CLK_DDR },
{ "cpll", CLK_CODEC },
{ "gpll", CLK_GENERAL },
#ifdef CONFIG_ROCKCHIP_RK3036
{ "mpll", CLK_NEW },
#else
{ "npll", CLK_NEW },
#endif
};
int ret, i;
struct udevice *dev;
ret = rockchip_get_clk(&dev);
if (ret) {
printf("clk-uclass not found\n");
return 0;
}
for (i = 0; i < ARRAY_SIZE(clks); i++) {
struct clk clk;
ulong rate;
clk.id = clks[i].id;
ret = clk_request(dev, &clk);
if (ret < 0)
continue;
rate = clk_get_rate(&clk);
printf("%s: %lu\n", clks[i].name, rate);
clk_free(&clk);
}
return 0;
}
U_BOOT_CMD(
clock, 2, 1, do_clock,
"display information about clocks",
""
);
#define GRF_SOC_CON2 0xff77024c
int board_early_init_f(void)
{
struct udevice *pinctrl;
struct udevice *dev;
int ret;
/*
* This init is done in SPL, but when chain-loading U-Boot SPL will
* have been skipped. Allow the clock driver to check if it needs
* setting up.
*/
ret = rockchip_get_clk(&dev);
if (ret) {
debug("CLK init failed: %d\n", ret);
return ret;
}
ret = uclass_get_device(UCLASS_PINCTRL, 0, &pinctrl);
if (ret) {
debug("%s: Cannot find pinctrl device\n", __func__);
return ret;
}
/* Enable debug UART */
ret = pinctrl_request_noflags(pinctrl, PERIPH_ID_UART_DBG);
if (ret) {
debug("%s: Failed to set up console UART\n", __func__);
return ret;
}
rk_setreg(GRF_SOC_CON2, 1 << 0);
return 0;
}