blob: eaba87542e76dda78375fc1ad1cfb6fe21fff555 [file] [log] [blame]
// SPDX-License-Identifier: GPL-2.0+
/*
* (C) Copyright 2008
* Sergei Poselenov, Emcraft Systems, sposelenov@emcraft.com.
*
* Copyright 2004 Freescale Semiconductor.
* (C) Copyright 2002,2003, Motorola Inc.
* Xianghua Xiao, (X.Xiao@motorola.com)
*
* (C) Copyright 2002 Scott McNutt <smcnutt@artesyncp.com>
*/
#include <common.h>
#include <clock_legacy.h>
#include <env.h>
#include <init.h>
#include <pci.h>
#include <uuid.h>
#include <asm/global_data.h>
#include <asm/processor.h>
#include <asm/immap_85xx.h>
#include <ioports.h>
#include <flash.h>
#include <linux/delay.h>
#include <linux/libfdt.h>
#include <fdt_support.h>
#include <asm/io.h>
#include <i2c.h>
#include "upm_table.h"
DECLARE_GLOBAL_DATA_PTR;
void local_bus_init (void);
ulong flash_get_size (ulong base, int banknum);
int checkboard (void)
{
volatile ccsr_gur_t *gur = (void *)(CFG_SYS_MPC85xx_GUTS_ADDR);
char buf[64];
int f;
int i = env_get_f("serial#", buf, sizeof(buf));
#ifdef CONFIG_PCI
char *src;
#endif
puts("Board: Socrates");
if (i > 0) {
puts(", serial# ");
puts(buf);
}
putc('\n');
#if defined(CONFIG_PCI)
/* Check the PCI_clk sel bit */
if (in_be32(&gur->porpllsr) & (1<<15)) {
src = "SYSCLK";
f = get_board_sys_clk();
} else {
src = "PCI_CLK";
/* PCI is clocked by the external source at 33 MHz */
f = 33000000;
}
printf ("PCI1: 32 bit, %d MHz (%s)\n", f/1000000, src);
#else
printf ("PCI1: disabled\n");
#endif
/*
* Initialize local bus.
*/
local_bus_init ();
return 0;
}
int misc_init_r (void)
{
/*
* Adjust flash start and offset to detected values
*/
gd->bd->bi_flashstart = 0 - gd->bd->bi_flashsize;
gd->bd->bi_flashoffset = 0;
/*
* Check if boot FLASH isn't max size
*/
if (gd->bd->bi_flashsize < (0 - CONFIG_SYS_FLASH0)) {
set_lbc_or(0, gd->bd->bi_flashstart |
(CONFIG_SYS_OR0_PRELIM & 0x00007fff));
set_lbc_br(0, gd->bd->bi_flashstart |
(CONFIG_SYS_BR0_PRELIM & 0x00007fff));
/*
* Re-check to get correct base address
*/
flash_get_size(gd->bd->bi_flashstart, CONFIG_SYS_MAX_FLASH_BANKS - 1);
}
/*
* Check if only one FLASH bank is available
*/
if (gd->bd->bi_flashsize != CONFIG_SYS_MAX_FLASH_BANKS * (0 - CONFIG_SYS_FLASH0)) {
set_lbc_or(1, 0);
set_lbc_br(1, 0);
/*
* Re-do flash protection upon new addresses
*/
flash_protect(FLAG_PROTECT_CLEAR,
gd->bd->bi_flashstart, 0xffffffff,
&flash_info[CONFIG_SYS_MAX_FLASH_BANKS - 1]);
/* Monitor protection ON by default */
flash_protect(FLAG_PROTECT_SET,
CONFIG_SYS_MONITOR_BASE, CONFIG_SYS_MONITOR_BASE +
monitor_flash_len - 1,
&flash_info[CONFIG_SYS_MAX_FLASH_BANKS - 1]);
/* Environment protection ON by default */
flash_protect(FLAG_PROTECT_SET,
CONFIG_ENV_ADDR,
CONFIG_ENV_ADDR + CONFIG_ENV_SECT_SIZE - 1,
&flash_info[CONFIG_SYS_MAX_FLASH_BANKS - 1]);
/* Redundant environment protection ON by default */
flash_protect(FLAG_PROTECT_SET,
CONFIG_ENV_ADDR_REDUND,
CONFIG_ENV_ADDR_REDUND + CONFIG_ENV_SECT_SIZE - 1,
&flash_info[CONFIG_SYS_MAX_FLASH_BANKS - 1]);
}
pci_init();
return 0;
}
/*
* Initialize Local Bus
*/
void local_bus_init (void)
{
volatile fsl_lbc_t *lbc = LBC_BASE_ADDR;
volatile ccsr_local_ecm_t *ecm = (void *)(CFG_SYS_MPC85xx_ECM_ADDR);
sys_info_t sysinfo;
uint clkdiv;
uint lbc_mhz;
uint lcrr = CONFIG_SYS_LBC_LCRR;
get_sys_info (&sysinfo);
clkdiv = lbc->lcrr & LCRR_CLKDIV;
lbc_mhz = sysinfo.freq_systembus / 1000000 / clkdiv;
/* Disable PLL bypass for Local Bus Clock >= 66 MHz */
if (lbc_mhz >= 66)
lcrr &= ~LCRR_DBYP; /* DLL Enabled */
else
lcrr |= LCRR_DBYP; /* DLL Bypass */
out_be32 (&lbc->lcrr, lcrr);
asm ("sync;isync;msync");
out_be32 (&lbc->ltesr, 0xffffffff); /* Clear LBC error interrupts */
out_be32 (&lbc->lteir, 0xffffffff); /* Enable LBC error interrupts */
out_be32 (&ecm->eedr, 0xffffffff); /* Clear ecm errors */
out_be32 (&ecm->eeer, 0xffffffff); /* Enable ecm errors */
/* Init UPMA for FPGA access */
out_be32 (&lbc->mamr, 0x44440); /* Use a customer-supplied value */
upmconfig(UPMA, (uint *)UPMTableA, sizeof(UPMTableA) / sizeof(int));
/* Init UPMB for Lime controller access */
out_be32 (&lbc->mbmr, 0x444440); /* Use a customer-supplied value */
upmconfig(UPMB, (uint *)UPMTableB, sizeof(UPMTableB) / sizeof(int));
}
#ifdef CONFIG_BOARD_EARLY_INIT_R
int board_early_init_r (void)
{
volatile ccsr_gur_t *gur = (void *)(CFG_SYS_MPC85xx_GUTS_ADDR);
/* set and reset the GPIO pin 2 which will reset the W83782G chip */
out_8((unsigned char*)&gur->gpoutdr, 0x3F );
out_be32((unsigned int*)&gur->gpiocr, 0x200 ); /* enable GPOut */
udelay(200);
out_8( (unsigned char*)&gur->gpoutdr, 0x1F );
return (0);
}
#endif /* CONFIG_BOARD_EARLY_INIT_R */
#ifdef CONFIG_OF_BOARD_SETUP
int ft_board_setup(void *blob, struct bd_info *bd)
{
u32 val[12];
int rc, i = 0;
ft_cpu_setup(blob, bd);
/* Fixup NOR FLASH mapping */
val[i++] = 0; /* chip select number */
val[i++] = 0; /* always 0 */
val[i++] = gd->bd->bi_flashstart;
val[i++] = gd->bd->bi_flashsize;
/* Fixup FPGA mapping */
val[i++] = 3; /* chip select number */
val[i++] = 0; /* always 0 */
val[i++] = CONFIG_SYS_FPGA_BASE;
val[i++] = CONFIG_SYS_FPGA_SIZE;
rc = fdt_find_and_setprop(blob, "/localbus", "ranges",
val, i * sizeof(u32), 1);
if (rc)
printf("Unable to update localbus ranges, err=%s\n",
fdt_strerror(rc));
return 0;
}
#endif /* CONFIG_OF_BOARD_SETUP */
#if defined(CONFIG_OF_SEPARATE)
void *board_fdt_blob_setup(int *err)
{
void *fw_dtb;
*err = 0;
fw_dtb = (void *)(CONFIG_TEXT_BASE - CONFIG_ENV_SECT_SIZE);
if (fdt_magic(fw_dtb) != FDT_MAGIC) {
printf("DTB is not passed via %x\n", (u32)fw_dtb);
*err = -ENXIO;
return NULL;
}
return fw_dtb;
}
#endif
int get_serial_clock(void)
{
return 333333330;
}