| CONFIG_ARM=y |
| CONFIG_SKIP_LOWLEVEL_INIT=y |
| CONFIG_SYS_DCACHE_OFF=y |
| CONFIG_ARCH_CPU_INIT=y |
| CONFIG_ARCH_KIRKWOOD=y |
| CONFIG_SYS_KWD_CONFIG="board/LaCie/netspace_v2/kwbimage.cfg" |
| CONFIG_SYS_TEXT_BASE=0x600000 |
| CONFIG_NR_DRAM_BANKS=2 |
| CONFIG_TARGET_NETSPACE_V2=y |
| CONFIG_NETSPACE_MAX_V2=y |
| CONFIG_ENV_SIZE=0x1000 |
| CONFIG_ENV_OFFSET=0x70000 |
| CONFIG_ENV_SECT_SIZE=0x10000 |
| CONFIG_DEFAULT_DEVICE_TREE="kirkwood-ns2max" |
| CONFIG_IDENT_STRING=" NS Max v2" |
| CONFIG_SYS_LOAD_ADDR=0x800000 |
| CONFIG_ENV_ADDR=0x70000 |
| # CONFIG_SYS_MALLOC_F is not set |
| CONFIG_BOOTDELAY=3 |
| CONFIG_USE_BOOTARGS=y |
| CONFIG_BOOTARGS="console=ttyS0,115200" |
| CONFIG_USE_BOOTCOMMAND=y |
| CONFIG_BOOTCOMMAND="dhcp && run netconsole; if run usbload || run diskload; then bootm; fi" |
| CONFIG_USE_PREBOOT=y |
| CONFIG_CONSOLE_MUX=y |
| # CONFIG_DISPLAY_BOARDINFO is not set |
| CONFIG_MISC_INIT_R=y |
| CONFIG_RESET_PHY_R=y |
| CONFIG_HUSH_PARSER=y |
| CONFIG_SYS_PROMPT="ns2> " |
| CONFIG_CMD_EEPROM=y |
| CONFIG_SYS_EEPROM_PAGE_WRITE_BITS=4 |
| CONFIG_CMD_I2C=y |
| CONFIG_CMD_SATA=y |
| CONFIG_CMD_USB=y |
| # CONFIG_CMD_SETEXPR is not set |
| CONFIG_CMD_DHCP=y |
| CONFIG_CMD_MII=y |
| CONFIG_CMD_PING=y |
| CONFIG_CMD_EXT2=y |
| CONFIG_CMD_FAT=y |
| CONFIG_ISO_PARTITION=y |
| CONFIG_EFI_PARTITION=y |
| # CONFIG_PARTITION_UUIDS is not set |
| CONFIG_OF_CONTROL=y |
| CONFIG_ENV_OVERWRITE=y |
| CONFIG_ENV_IS_IN_SPI_FLASH=y |
| CONFIG_ENV_SPI_MAX_HZ=20000000 |
| CONFIG_NETCONSOLE=y |
| CONFIG_SYS_FAULT_ECHO_LINK_DOWN=y |
| CONFIG_DM=y |
| CONFIG_SATA_MV=y |
| CONFIG_SYS_SATA_MAX_DEVICE=2 |
| CONFIG_KIRKWOOD_GPIO=y |
| CONFIG_SYS_I2C_LEGACY=y |
| CONFIG_SYS_I2C_MVTWSI=y |
| CONFIG_SYS_I2C_SLAVE=0x0 |
| CONFIG_SYS_I2C_EEPROM_ADDR=0x50 |
| # CONFIG_MMC is not set |
| CONFIG_DM_SPI_FLASH=y |
| CONFIG_SPI_FLASH_MACRONIX=y |
| CONFIG_DM_ETH=y |
| CONFIG_MVGBE=y |
| CONFIG_MII=y |
| CONFIG_SYS_NS16550=y |
| CONFIG_SPI=y |
| CONFIG_DM_SPI=y |
| CONFIG_KIRKWOOD_SPI=y |
| CONFIG_USB=y |
| CONFIG_USB_EHCI_HCD=y |
| CONFIG_USB_STORAGE=y |