blob: f8b69406d4b9293e81f39f6fb4aae21f4e9f35de [file] [log] [blame]
// SPDX-License-Identifier: GPL-2.0+
/*
* Copyright (C) 2012
* Altera Corporation <www.altera.com>
*/
#include <common.h>
#include <clk.h>
#include <asm-generic/io.h>
#include <dm.h>
#include <fdtdec.h>
#include <malloc.h>
#include <reset.h>
#include <spi.h>
#include <spi-mem.h>
#include <linux/errno.h>
#include <linux/sizes.h>
#include "cadence_qspi.h"
#define CQSPI_STIG_READ 0
#define CQSPI_STIG_WRITE 1
#define CQSPI_READ 2
#define CQSPI_WRITE 3
static int cadence_spi_write_speed(struct udevice *bus, uint hz)
{
struct cadence_spi_platdata *plat = bus->platdata;
struct cadence_spi_priv *priv = dev_get_priv(bus);
cadence_qspi_apb_config_baudrate_div(priv->regbase,
plat->ref_clk_hz, hz);
/* Reconfigure delay timing if speed is changed. */
cadence_qspi_apb_delay(priv->regbase, plat->ref_clk_hz, hz,
plat->tshsl_ns, plat->tsd2d_ns,
plat->tchsh_ns, plat->tslch_ns);
return 0;
}
static int cadence_spi_read_id(void *reg_base, u8 len, u8 *idcode)
{
struct spi_mem_op op = SPI_MEM_OP(SPI_MEM_OP_CMD(0x9F, 1),
SPI_MEM_OP_NO_ADDR,
SPI_MEM_OP_NO_DUMMY,
SPI_MEM_OP_DATA_IN(len, idcode, 1));
return cadence_qspi_apb_command_read(reg_base, &op);
}
/* Calibration sequence to determine the read data capture delay register */
static int spi_calibration(struct udevice *bus, uint hz)
{
struct cadence_spi_priv *priv = dev_get_priv(bus);
void *base = priv->regbase;
unsigned int idcode = 0, temp = 0;
int err = 0, i, range_lo = -1, range_hi = -1;
/* start with slowest clock (1 MHz) */
cadence_spi_write_speed(bus, 1000000);
/* configure the read data capture delay register to 0 */
cadence_qspi_apb_readdata_capture(base, 1, 0);
/* Enable QSPI */
cadence_qspi_apb_controller_enable(base);
/* read the ID which will be our golden value */
err = cadence_spi_read_id(base, 3, (u8 *)&idcode);
if (err) {
puts("SF: Calibration failed (read)\n");
return err;
}
/* use back the intended clock and find low range */
cadence_spi_write_speed(bus, hz);
for (i = 0; i < CQSPI_READ_CAPTURE_MAX_DELAY; i++) {
/* Disable QSPI */
cadence_qspi_apb_controller_disable(base);
/* reconfigure the read data capture delay register */
cadence_qspi_apb_readdata_capture(base, 1, i);
/* Enable back QSPI */
cadence_qspi_apb_controller_enable(base);
/* issue a RDID to get the ID value */
err = cadence_spi_read_id(base, 3, (u8 *)&temp);
if (err) {
puts("SF: Calibration failed (read)\n");
return err;
}
/* search for range lo */
if (range_lo == -1 && temp == idcode) {
range_lo = i;
continue;
}
/* search for range hi */
if (range_lo != -1 && temp != idcode) {
range_hi = i - 1;
break;
}
range_hi = i;
}
if (range_lo == -1) {
puts("SF: Calibration failed (low range)\n");
return err;
}
/* Disable QSPI for subsequent initialization */
cadence_qspi_apb_controller_disable(base);
/* configure the final value for read data capture delay register */
cadence_qspi_apb_readdata_capture(base, 1, (range_hi + range_lo) / 2);
debug("SF: Read data capture delay calibrated to %i (%i - %i)\n",
(range_hi + range_lo) / 2, range_lo, range_hi);
/* just to ensure we do once only when speed or chip select change */
priv->qspi_calibrated_hz = hz;
priv->qspi_calibrated_cs = spi_chip_select(bus);
return 0;
}
static int cadence_spi_set_speed(struct udevice *bus, uint hz)
{
struct cadence_spi_platdata *plat = bus->platdata;
struct cadence_spi_priv *priv = dev_get_priv(bus);
int err;
if (hz > plat->max_hz)
hz = plat->max_hz;
/* Disable QSPI */
cadence_qspi_apb_controller_disable(priv->regbase);
/*
* Calibration required for different current SCLK speed, requested
* SCLK speed or chip select
*/
if (priv->previous_hz != hz ||
priv->qspi_calibrated_hz != hz ||
priv->qspi_calibrated_cs != spi_chip_select(bus)) {
err = spi_calibration(bus, hz);
if (err)
return err;
/* prevent calibration run when same as previous request */
priv->previous_hz = hz;
}
/* Enable QSPI */
cadence_qspi_apb_controller_enable(priv->regbase);
debug("%s: speed=%d\n", __func__, hz);
return 0;
}
static int cadence_spi_probe(struct udevice *bus)
{
struct cadence_spi_platdata *plat = bus->platdata;
struct cadence_spi_priv *priv = dev_get_priv(bus);
int ret;
priv->regbase = plat->regbase;
priv->ahbbase = plat->ahbbase;
ret = reset_get_bulk(bus, &priv->resets);
if (ret)
dev_warn(bus, "Can't get reset: %d\n", ret);
else
reset_deassert_bulk(&priv->resets);
if (!priv->qspi_is_init) {
cadence_qspi_apb_controller_init(plat);
priv->qspi_is_init = 1;
}
return 0;
}
static int cadence_spi_remove(struct udevice *dev)
{
struct cadence_spi_priv *priv = dev_get_priv(dev);
return reset_release_bulk(&priv->resets);
}
static int cadence_spi_set_mode(struct udevice *bus, uint mode)
{
struct cadence_spi_platdata *plat = bus->platdata;
struct cadence_spi_priv *priv = dev_get_priv(bus);
/* Disable QSPI */
cadence_qspi_apb_controller_disable(priv->regbase);
/* Set SPI mode */
cadence_qspi_apb_set_clk_mode(priv->regbase, mode);
/* Enable Direct Access Controller */
if (plat->use_dac_mode)
cadence_qspi_apb_dac_mode_enable(priv->regbase);
/* Enable QSPI */
cadence_qspi_apb_controller_enable(priv->regbase);
return 0;
}
static int cadence_spi_mem_exec_op(struct spi_slave *spi,
const struct spi_mem_op *op)
{
struct udevice *bus = spi->dev->parent;
struct cadence_spi_platdata *plat = bus->platdata;
struct cadence_spi_priv *priv = dev_get_priv(bus);
void *base = priv->regbase;
int err = 0;
u32 mode;
/* Set Chip select */
cadence_qspi_apb_chipselect(base, spi_chip_select(spi->dev),
plat->is_decoded_cs);
if (op->data.dir == SPI_MEM_DATA_IN && op->data.buf.in) {
if (!op->addr.nbytes)
mode = CQSPI_STIG_READ;
else
mode = CQSPI_READ;
} else {
if (!op->addr.nbytes || !op->data.buf.out)
mode = CQSPI_STIG_WRITE;
else
mode = CQSPI_WRITE;
}
switch (mode) {
case CQSPI_STIG_READ:
err = cadence_qspi_apb_command_read(base, op);
break;
case CQSPI_STIG_WRITE:
err = cadence_qspi_apb_command_write(base, op);
break;
case CQSPI_READ:
err = cadence_qspi_apb_read_setup(plat, op);
if (!err)
err = cadence_qspi_apb_read_execute(plat, op);
break;
case CQSPI_WRITE:
err = cadence_qspi_apb_write_setup(plat, op);
if (!err)
err = cadence_qspi_apb_write_execute(plat, op);
break;
default:
err = -1;
break;
}
return err;
}
static int cadence_spi_ofdata_to_platdata(struct udevice *bus)
{
struct cadence_spi_platdata *plat = bus->platdata;
ofnode subnode;
struct clk clk;
int ret;
plat->regbase = (void *)devfdt_get_addr_index(bus, 0);
plat->ahbbase = (void *)devfdt_get_addr_size_index(bus, 1,
&plat->ahbsize);
plat->is_decoded_cs = dev_read_bool(bus, "cdns,is-decoded-cs");
plat->fifo_depth = dev_read_u32_default(bus, "cdns,fifo-depth", 128);
plat->fifo_width = dev_read_u32_default(bus, "cdns,fifo-width", 4);
plat->trigger_address = dev_read_u32_default(bus,
"cdns,trigger-address",
0);
/* Use DAC mode only when MMIO window is at least 8M wide */
if (plat->ahbsize >= SZ_8M)
plat->use_dac_mode = true;
/* All other paramters are embedded in the child node */
subnode = dev_read_first_subnode(bus);
if (!ofnode_valid(subnode)) {
printf("Error: subnode with SPI flash config missing!\n");
return -ENODEV;
}
/* Use 500 KHz as a suitable default */
plat->max_hz = ofnode_read_u32_default(subnode, "spi-max-frequency",
500000);
/* Read other parameters from DT */
plat->page_size = ofnode_read_u32_default(subnode, "page-size", 256);
plat->block_size = ofnode_read_u32_default(subnode, "block-size", 16);
plat->tshsl_ns = ofnode_read_u32_default(subnode, "cdns,tshsl-ns",
200);
plat->tsd2d_ns = ofnode_read_u32_default(subnode, "cdns,tsd2d-ns",
255);
plat->tchsh_ns = ofnode_read_u32_default(subnode, "cdns,tchsh-ns", 20);
plat->tslch_ns = ofnode_read_u32_default(subnode, "cdns,tslch-ns", 20);
ret = clk_get_by_index(bus, 0, &clk);
if (ret) {
#ifdef CONFIG_CQSPI_REF_CLK
plat->ref_clk_hz = CONFIG_CQSPI_REF_CLK;
#else
return ret;
#endif
} else {
plat->ref_clk_hz = clk_get_rate(&clk);
clk_free(&clk);
if (IS_ERR_VALUE(plat->ref_clk_hz))
return plat->ref_clk_hz;
}
debug("%s: regbase=%p ahbbase=%p max-frequency=%d page-size=%d\n",
__func__, plat->regbase, plat->ahbbase, plat->max_hz,
plat->page_size);
return 0;
}
static const struct spi_controller_mem_ops cadence_spi_mem_ops = {
.exec_op = cadence_spi_mem_exec_op,
};
static const struct dm_spi_ops cadence_spi_ops = {
.set_speed = cadence_spi_set_speed,
.set_mode = cadence_spi_set_mode,
.mem_ops = &cadence_spi_mem_ops,
/*
* cs_info is not needed, since we require all chip selects to be
* in the device tree explicitly
*/
};
static const struct udevice_id cadence_spi_ids[] = {
{ .compatible = "cdns,qspi-nor" },
{ .compatible = "ti,am654-ospi" },
{ }
};
U_BOOT_DRIVER(cadence_spi) = {
.name = "cadence_spi",
.id = UCLASS_SPI,
.of_match = cadence_spi_ids,
.ops = &cadence_spi_ops,
.ofdata_to_platdata = cadence_spi_ofdata_to_platdata,
.platdata_auto_alloc_size = sizeof(struct cadence_spi_platdata),
.priv_auto_alloc_size = sizeof(struct cadence_spi_priv),
.probe = cadence_spi_probe,
.remove = cadence_spi_remove,
.flags = DM_FLAG_OS_PREPARE,
};