| CONFIG_ARM=y |
| CONFIG_ARCH_CPU_INIT=y |
| CONFIG_ARCH_AT91=y |
| CONFIG_SYS_TEXT_BASE=0x20f00000 |
| CONFIG_TARGET_VINCO=y |
| CONFIG_NR_DRAM_BANKS=1 |
| CONFIG_ENV_SIZE=0x10000 |
| CONFIG_ENV_OFFSET=0x10000 |
| CONFIG_ENV_SECT_SIZE=0x1000 |
| CONFIG_DEFAULT_DEVICE_TREE="at91-vinco" |
| CONFIG_ENV_VARS_UBOOT_CONFIG=y |
| CONFIG_SPI_BOOT=y |
| CONFIG_BOOTDELAY=3 |
| CONFIG_USE_BOOTARGS=y |
| CONFIG_BOOTARGS="console=ttyS0,115200 earlyprintk rw root=/dev/mmcblk0p2 rootfstype=ext4 rootwait quiet lpj=1990656" |
| # CONFIG_DISPLAY_BOARDINFO is not set |
| CONFIG_BOARD_EARLY_INIT_F=y |
| CONFIG_HUSH_PARSER=y |
| CONFIG_SYS_PROMPT="vinco => " |
| CONFIG_CMD_BOOTZ=y |
| # CONFIG_CMD_IMI is not set |
| CONFIG_CMD_GPT=y |
| # CONFIG_CMD_LOADS is not set |
| CONFIG_CMD_MMC=y |
| CONFIG_CMD_SF=y |
| CONFIG_CMD_USB=y |
| CONFIG_CMD_DHCP=y |
| CONFIG_CMD_MII=y |
| CONFIG_CMD_PING=y |
| CONFIG_CMD_FAT=y |
| CONFIG_OF_CONTROL=y |
| CONFIG_ENV_IS_IN_SPI_FLASH=y |
| CONFIG_SYS_RELOC_GD_ENV_ADDR=y |
| CONFIG_AT91_GPIO=y |
| CONFIG_SUPPORT_EMMC_BOOT=y |
| CONFIG_SPI_FLASH=y |
| CONFIG_SF_DEFAULT_MODE=0 |
| CONFIG_SF_DEFAULT_SPEED=50000000 |
| CONFIG_PHY_SMSC=y |
| CONFIG_ETH_DESIGNWARE=y |
| CONFIG_ATMEL_USART=y |
| CONFIG_USB=y |
| CONFIG_USB_EHCI_HCD=y |
| CONFIG_USB_GADGET=y |
| CONFIG_USB_GADGET_MANUFACTURER="L+G VInCo" |
| CONFIG_USB_GADGET_ATMEL_USBA=y |
| CONFIG_USB_ETHER=y |
| CONFIG_USB_HOST_ETHER=y |
| CONFIG_USB_ETHER_SMSC95XX=y |