| // SPDX-License-Identifier: GPL-2.0+ |
| /* |
| * Copyright (C) 2012 Altera Corporation <www.altera.com> |
| */ |
| |
| #include <common.h> |
| #include <asm/io.h> |
| #include <asm/pl310.h> |
| #include <asm/u-boot.h> |
| #include <asm/utils.h> |
| #include <image.h> |
| #include <asm/arch/reset_manager.h> |
| #include <spl.h> |
| #include <asm/arch/system_manager.h> |
| #include <asm/arch/freeze_controller.h> |
| #include <asm/arch/clock_manager.h> |
| #include <asm/arch/misc.h> |
| #include <asm/arch/scan_manager.h> |
| #include <asm/arch/sdram.h> |
| #include <asm/arch/scu.h> |
| #include <asm/arch/nic301.h> |
| #include <asm/sections.h> |
| #include <fdtdec.h> |
| #include <watchdog.h> |
| |
| DECLARE_GLOBAL_DATA_PTR; |
| |
| static struct pl310_regs *const pl310 = |
| (struct pl310_regs *)CONFIG_SYS_PL310_BASE; |
| static struct scu_registers *scu_regs = |
| (struct scu_registers *)SOCFPGA_MPUSCU_ADDRESS; |
| static struct nic301_registers *nic301_regs = |
| (struct nic301_registers *)SOCFPGA_L3REGS_ADDRESS; |
| static const struct socfpga_system_manager *sysmgr_regs = |
| (struct socfpga_system_manager *)SOCFPGA_SYSMGR_ADDRESS; |
| |
| u32 spl_boot_device(void) |
| { |
| const u32 bsel = readl(&sysmgr_regs->bootinfo); |
| |
| switch (SYSMGR_GET_BOOTINFO_BSEL(bsel)) { |
| case 0x1: /* FPGA (HPS2FPGA Bridge) */ |
| return BOOT_DEVICE_RAM; |
| case 0x2: /* NAND Flash (1.8V) */ |
| case 0x3: /* NAND Flash (3.0V) */ |
| socfpga_per_reset(SOCFPGA_RESET(NAND), 0); |
| return BOOT_DEVICE_NAND; |
| case 0x4: /* SD/MMC External Transceiver (1.8V) */ |
| case 0x5: /* SD/MMC Internal Transceiver (3.0V) */ |
| socfpga_per_reset(SOCFPGA_RESET(SDMMC), 0); |
| socfpga_per_reset(SOCFPGA_RESET(DMA), 0); |
| return BOOT_DEVICE_MMC1; |
| case 0x6: /* QSPI Flash (1.8V) */ |
| case 0x7: /* QSPI Flash (3.0V) */ |
| socfpga_per_reset(SOCFPGA_RESET(QSPI), 0); |
| return BOOT_DEVICE_SPI; |
| default: |
| printf("Invalid boot device (bsel=%08x)!\n", bsel); |
| hang(); |
| } |
| } |
| |
| #ifdef CONFIG_SPL_MMC_SUPPORT |
| u32 spl_boot_mode(const u32 boot_device) |
| { |
| #if defined(CONFIG_SPL_FAT_SUPPORT) || defined(CONFIG_SPL_EXT_SUPPORT) |
| return MMCSD_MODE_FS; |
| #else |
| return MMCSD_MODE_RAW; |
| #endif |
| } |
| #endif |
| |
| static void socfpga_nic301_slave_ns(void) |
| { |
| writel(0x1, &nic301_regs->lwhps2fpgaregs); |
| writel(0x1, &nic301_regs->hps2fpgaregs); |
| writel(0x1, &nic301_regs->acp); |
| writel(0x1, &nic301_regs->rom); |
| writel(0x1, &nic301_regs->ocram); |
| writel(0x1, &nic301_regs->sdrdata); |
| } |
| |
| void board_init_f(ulong dummy) |
| { |
| const struct cm_config *cm_default_cfg = cm_get_default_config(); |
| unsigned long sdram_size; |
| unsigned long reg; |
| |
| /* |
| * First C code to run. Clear fake OCRAM ECC first as SBE |
| * and DBE might triggered during power on |
| */ |
| reg = readl(&sysmgr_regs->eccgrp_ocram); |
| if (reg & SYSMGR_ECC_OCRAM_SERR) |
| writel(SYSMGR_ECC_OCRAM_SERR | SYSMGR_ECC_OCRAM_EN, |
| &sysmgr_regs->eccgrp_ocram); |
| if (reg & SYSMGR_ECC_OCRAM_DERR) |
| writel(SYSMGR_ECC_OCRAM_DERR | SYSMGR_ECC_OCRAM_EN, |
| &sysmgr_regs->eccgrp_ocram); |
| |
| memset(__bss_start, 0, __bss_end - __bss_start); |
| |
| socfpga_nic301_slave_ns(); |
| |
| /* Configure ARM MPU SNSAC register. */ |
| setbits_le32(&scu_regs->sacr, 0xfff); |
| |
| /* Remap SDRAM to 0x0 */ |
| writel(0x1, &nic301_regs->remap); /* remap.mpuzero */ |
| writel(0x1, &pl310->pl310_addr_filter_start); |
| |
| debug("Freezing all I/O banks\n"); |
| /* freeze all IO banks */ |
| sys_mgr_frzctrl_freeze_req(); |
| |
| /* Put everything into reset but L4WD0. */ |
| socfpga_per_reset_all(); |
| /* Put FPGA bridges into reset too. */ |
| socfpga_bridges_reset(1); |
| |
| socfpga_per_reset(SOCFPGA_RESET(SDR), 0); |
| socfpga_per_reset(SOCFPGA_RESET(UART0), 0); |
| socfpga_per_reset(SOCFPGA_RESET(OSC1TIMER0), 0); |
| |
| timer_init(); |
| |
| debug("Reconfigure Clock Manager\n"); |
| /* reconfigure the PLLs */ |
| if (cm_basic_init(cm_default_cfg)) |
| hang(); |
| |
| /* Enable bootrom to configure IOs. */ |
| sysmgr_config_warmrstcfgio(1); |
| |
| /* configure the IOCSR / IO buffer settings */ |
| if (scan_mgr_configure_iocsr()) |
| hang(); |
| |
| sysmgr_config_warmrstcfgio(0); |
| |
| /* configure the pin muxing through system manager */ |
| sysmgr_config_warmrstcfgio(1); |
| sysmgr_pinmux_init(); |
| sysmgr_config_warmrstcfgio(0); |
| |
| /* De-assert reset for peripherals and bridges based on handoff */ |
| reset_deassert_peripherals_handoff(); |
| socfpga_bridges_reset(0); |
| |
| debug("Unfreezing/Thaw all I/O banks\n"); |
| /* unfreeze / thaw all IO banks */ |
| sys_mgr_frzctrl_thaw_req(); |
| |
| /* enable console uart printing */ |
| preloader_console_init(); |
| |
| if (sdram_mmr_init_full(0xffffffff) != 0) { |
| puts("SDRAM init failed.\n"); |
| hang(); |
| } |
| |
| debug("SDRAM: Calibrating PHY\n"); |
| /* SDRAM calibration */ |
| if (sdram_calibration_full() == 0) { |
| puts("SDRAM calibration failed.\n"); |
| hang(); |
| } |
| |
| sdram_size = sdram_calculate_size(); |
| debug("SDRAM: %ld MiB\n", sdram_size >> 20); |
| |
| /* Sanity check ensure correct SDRAM size specified */ |
| if (get_ram_size(0, sdram_size) != sdram_size) { |
| puts("SDRAM size check failed!\n"); |
| hang(); |
| } |
| |
| socfpga_bridges_reset(1); |
| |
| /* Configure simple malloc base pointer into RAM. */ |
| gd->malloc_base = CONFIG_SYS_TEXT_BASE + (1024 * 1024); |
| } |