| CONFIG_ARM=y |
| CONFIG_SYS_THUMB_BUILD=y |
| CONFIG_ARCH_AT91=y |
| CONFIG_SYS_TEXT_BASE=0x23f00000 |
| CONFIG_TARGET_WB45N=y |
| CONFIG_SPL_GPIO_SUPPORT=y |
| CONFIG_SPL_LIBCOMMON_SUPPORT=y |
| CONFIG_SPL_LIBGENERIC_SUPPORT=y |
| CONFIG_NR_DRAM_BANKS=1 |
| CONFIG_ENV_OFFSET=0xA0000 |
| CONFIG_SPL_TEXT_BASE=0x300000 |
| CONFIG_SPL_SERIAL_SUPPORT=y |
| CONFIG_SPL=y |
| CONFIG_ENV_OFFSET_REDUND=0xC0000 |
| CONFIG_FIT=y |
| CONFIG_SYS_EXTRA_OPTIONS="AT91SAM9X5,SYS_USE_NANDFLASH" |
| CONFIG_BOOTDELAY=3 |
| CONFIG_USE_BOOTARGS=y |
| CONFIG_BOOTARGS="console=ttyS0,115200 earlyprintk rw noinitrd mem=64M rootfstype=ubifs root=ubi0:rootfs ubi.mtd=6" |
| CONFIG_BOARD_EARLY_INIT_F=y |
| CONFIG_SPL_NAND_SUPPORT=y |
| CONFIG_SPL_NAND_DRIVERS=y |
| CONFIG_SPL_NAND_BASE=y |
| CONFIG_HUSH_PARSER=y |
| CONFIG_CMD_BOOTZ=y |
| CONFIG_CMD_MEMTEST=y |
| CONFIG_SYS_MEMTEST_START=0x20000000 |
| CONFIG_SYS_MEMTEST_END=0x23e00000 |
| # CONFIG_CMD_FLASH is not set |
| # CONFIG_CMD_LOADS is not set |
| CONFIG_CMD_NAND=y |
| CONFIG_CMD_NAND_TRIMFFS=y |
| CONFIG_CMD_DHCP=y |
| CONFIG_CMD_MII=y |
| CONFIG_CMD_PING=y |
| CONFIG_CMD_MTDPARTS=y |
| CONFIG_ENV_OVERWRITE=y |
| CONFIG_ENV_IS_IN_NAND=y |
| CONFIG_SYS_REDUNDAND_ENVIRONMENT=y |
| CONFIG_SYS_RELOC_GD_ENV_ADDR=y |
| CONFIG_AT91_GPIO=y |
| CONFIG_MTD=y |
| CONFIG_MTD_RAW_NAND=y |
| # CONFIG_SYS_NAND_USE_FLASH_BBT is not set |
| CONFIG_NAND_ATMEL=y |
| CONFIG_PMECC_CAP=4 |
| CONFIG_SPL_GENERATE_ATMEL_PMECC_HEADER=y |
| CONFIG_ATMEL_USART=y |
| CONFIG_LZMA=y |
| CONFIG_LZO=y |
| CONFIG_OF_LIBFDT=y |