| // SPDX-License-Identifier: GPL-2.0+ |
| /* |
| * Copyright (C) 2018 Armadeus Systems |
| */ |
| |
| #include <init.h> |
| #include <asm/arch/clock.h> |
| #include <asm/arch/crm_regs.h> |
| #include <asm/arch/imx-regs.h> |
| #include <asm/arch/sys_proto.h> |
| #include <asm/io.h> |
| #include <common.h> |
| #include <env.h> |
| |
| DECLARE_GLOBAL_DATA_PTR; |
| |
| #ifdef CONFIG_FEC_MXC |
| #include <miiphy.h> |
| |
| int board_phy_config(struct phy_device *phydev) |
| { |
| phy_write(phydev, MDIO_DEVAD_NONE, 0x1f, 0x8190); |
| |
| if (phydev->drv->config) |
| phydev->drv->config(phydev); |
| |
| return 0; |
| } |
| |
| static int setup_fec(void) |
| { |
| struct iomuxc *const iomuxc_regs = (struct iomuxc *)IOMUXC_BASE_ADDR; |
| |
| /* Use 50M anatop loopback REF_CLK1 for ENET1, |
| * clear gpr1[13], set gpr1[17] */ |
| clrsetbits_le32(&iomuxc_regs->gpr[1], IOMUX_GPR1_FEC1_MASK, |
| IOMUX_GPR1_FEC1_CLOCK_MUX1_SEL_MASK); |
| |
| return enable_fec_anatop_clock(0, ENET_50MHZ); |
| } |
| #endif /* CONFIG_FEC_MXC */ |
| |
| int board_init(void) |
| { |
| /* Address of boot parameters */ |
| gd->bd->bi_boot_params = CONFIG_SYS_SDRAM_BASE + 0x100; |
| |
| #ifdef CONFIG_FEC_MXC |
| setup_fec(); |
| #endif |
| |
| return 0; |
| } |
| |
| int __weak opos6ul_board_late_init(void) |
| { |
| return 0; |
| } |
| |
| int board_late_init(void) |
| { |
| struct src *psrc = (struct src *)SRC_BASE_ADDR; |
| unsigned reg = readl(&psrc->sbmr2); |
| |
| /* In bootstrap don't use the env vars */ |
| if (((reg & 0x3000000) >> 24) == 0x1) { |
| env_set_default(NULL, 0); |
| env_set("preboot", ""); |
| } |
| |
| return opos6ul_board_late_init(); |
| } |
| |
| int dram_init(void) |
| { |
| gd->ram_size = imx_ddr_size(); |
| |
| return 0; |
| } |
| |
| #ifdef CONFIG_SPL_BUILD |
| #include <asm/arch/mx6-ddr.h> |
| #include <linux/libfdt.h> |
| #include <spl.h> |
| |
| static struct mx6ul_iomux_grp_regs mx6_grp_ioregs = { |
| .grp_addds = 0x00000030, |
| .grp_ddrmode_ctl = 0x00020000, |
| .grp_b0ds = 0x00000030, |
| .grp_ctlds = 0x00000030, |
| .grp_b1ds = 0x00000030, |
| .grp_ddrpke = 0x00000000, |
| .grp_ddrmode = 0x00020000, |
| .grp_ddr_type = 0x000c0000, |
| }; |
| |
| static struct mx6ul_iomux_ddr_regs mx6_ddr_ioregs = { |
| .dram_dqm0 = 0x00000030, |
| .dram_dqm1 = 0x00000030, |
| .dram_ras = 0x00000030, |
| .dram_cas = 0x00000030, |
| .dram_odt0 = 0x00000030, |
| .dram_odt1 = 0x00000030, |
| .dram_sdba2 = 0x00000000, |
| .dram_sdclk_0 = 0x00000008, |
| .dram_sdqs0 = 0x00000038, |
| .dram_sdqs1 = 0x00000030, |
| .dram_reset = 0x00000030, |
| }; |
| |
| static struct mx6_mmdc_calibration mx6_mmcd_calib = { |
| .p0_mpwldectrl0 = 0x00070007, |
| .p0_mpdgctrl0 = 0x41490145, |
| .p0_mprddlctl = 0x40404546, |
| .p0_mpwrdlctl = 0x4040524D, |
| }; |
| |
| struct mx6_ddr_sysinfo ddr_sysinfo = { |
| .dsize = 0, |
| .cs_density = 20, |
| .ncs = 1, |
| .cs1_mirror = 0, |
| .rtt_wr = 2, |
| .rtt_nom = 1, /* RTT_Nom = RZQ/2 */ |
| .walat = 1, /* Write additional latency */ |
| .ralat = 5, /* Read additional latency */ |
| .mif3_mode = 3, /* Command prediction working mode */ |
| .bi_on = 1, /* Bank interleaving enabled */ |
| .sde_to_rst = 0x10, /* 14 cycles, 200us (JEDEC default) */ |
| .rst_to_cke = 0x23, /* 33 cycles, 500us (JEDEC default) */ |
| .ddr_type = DDR_TYPE_DDR3, |
| .refsel = 1, /* Refresh cycles at 32KHz */ |
| .refr = 7, /* 8 refreshes commands per refresh cycle */ |
| }; |
| |
| static struct mx6_ddr3_cfg mem_ddr = { |
| .mem_speed = 800, |
| .density = 2, |
| .width = 16, |
| .banks = 8, |
| .rowaddr = 14, |
| .coladdr = 10, |
| .pagesz = 2, |
| .trcd = 1500, |
| .trcmin = 5250, |
| .trasmin = 3750, |
| }; |
| |
| void board_boot_order(u32 *spl_boot_list) |
| { |
| unsigned int bmode = readl(&src_base->sbmr2); |
| |
| if (((bmode >> 24) & 0x03) == 0x01) /* Serial Downloader */ |
| spl_boot_list[0] = BOOT_DEVICE_UART; |
| else |
| spl_boot_list[0] = spl_boot_device(); |
| } |
| |
| static void ccgr_init(void) |
| { |
| struct mxc_ccm_reg *ccm = (struct mxc_ccm_reg *)CCM_BASE_ADDR; |
| |
| writel(0xFFFFFFFF, &ccm->CCGR0); |
| writel(0xFFFFFFFF, &ccm->CCGR1); |
| writel(0xFFFFFFFF, &ccm->CCGR2); |
| writel(0xFFFFFFFF, &ccm->CCGR3); |
| writel(0xFFFFFFFF, &ccm->CCGR4); |
| writel(0xFFFFFFFF, &ccm->CCGR5); |
| writel(0xFFFFFFFF, &ccm->CCGR6); |
| writel(0xFFFFFFFF, &ccm->CCGR7); |
| } |
| |
| static void spl_dram_init(void) |
| { |
| struct ocotp_regs *ocotp = (struct ocotp_regs *)OCOTP_BASE_ADDR; |
| struct fuse_bank *bank = &ocotp->bank[4]; |
| struct fuse_bank4_regs *fuse = |
| (struct fuse_bank4_regs *)bank->fuse_regs; |
| int reg = readl(&fuse->gp1); |
| |
| /* 512MB of RAM */ |
| if (reg & 0x1) { |
| mem_ddr.density = 4; |
| mem_ddr.rowaddr = 15; |
| mem_ddr.trcd = 1375; |
| mem_ddr.trcmin = 4875; |
| mem_ddr.trasmin = 3500; |
| } |
| |
| mx6ul_dram_iocfg(mem_ddr.width, &mx6_ddr_ioregs, &mx6_grp_ioregs); |
| mx6_dram_cfg(&ddr_sysinfo, &mx6_mmcd_calib, &mem_ddr); |
| } |
| |
| void spl_board_init(void) |
| { |
| preloader_console_init(); |
| } |
| |
| void board_init_f(ulong dummy) |
| { |
| ccgr_init(); |
| |
| /* setup AIPS and disable watchdog */ |
| arch_cpu_init(); |
| |
| /* setup GP timer */ |
| timer_init(); |
| |
| /* DDR initialization */ |
| spl_dram_init(); |
| } |
| #endif /* CONFIG_SPL_BUILD */ |