blob: cbce5ffe6e336fd52c9f86955aa81fae51337966 [file] [log] [blame]
// SPDX-License-Identifier: GPL-2.0+
/*
* Copyright (C) 2018, Bin Meng <bmeng.cn@gmail.com>
*/
#include <common.h>
#include <dm.h>
#include <env.h>
#include <fdtdec.h>
#include <spl.h>
#include <init.h>
#include <virtio_types.h>
#include <virtio.h>
int board_init(void)
{
/*
* Make sure virtio bus is enumerated so that peripherals
* on the virtio bus can be discovered by their drivers
*/
virtio_init();
return 0;
}
int board_late_init(void)
{
ulong kernel_start;
ofnode chosen_node;
int ret;
chosen_node = ofnode_path("/chosen");
if (!ofnode_valid(chosen_node)) {
debug("No chosen node found, can't get kernel start address\n");
return 0;
}
#ifdef CONFIG_ARCH_RV64I
ret = ofnode_read_u64(chosen_node, "riscv,kernel-start",
(u64 *)&kernel_start);
#else
ret = ofnode_read_u32(chosen_node, "riscv,kernel-start",
(u32 *)&kernel_start);
#endif
if (ret) {
debug("Can't find kernel start address in device tree\n");
return 0;
}
env_set_hex("kernel_start", kernel_start);
return 0;
}
/*
* QEMU specifies the location of Linux (supplied with the -kernel argument)
* in the device tree using the riscv,kernel-start and riscv,kernel-end
* properties. We currently rely on the SBI implementation of BBL to run
* Linux and therefore embed Linux as payload in BBL. This causes an issue,
* because BBL detects the kernel properties in the device tree and ignores
* the Linux payload as a result. To work around this issue, we clear the
* kernel properties before booting Linux.
*
* This workaround can be removed, once we do not require BBL for its SBI
* implementation anymore.
*/
int ft_board_setup(void *blob, bd_t *bd)
{
int chosen_offset, ret;
chosen_offset = fdt_path_offset(blob, "/chosen");
if (chosen_offset < 0)
return 0;
#ifdef CONFIG_ARCH_RV64I
ret = fdt_setprop_u64(blob, chosen_offset, "riscv,kernel-start", 0);
#else
ret = fdt_setprop_u32(blob, chosen_offset, "riscv,kernel-start", 0);
#endif
if (ret)
return ret;
#ifdef CONFIG_ARCH_RV64I
ret = fdt_setprop_u64(blob, chosen_offset, "riscv,kernel-end", 0);
#else
ret = fdt_setprop_u32(blob, chosen_offset, "riscv,kernel-end", 0);
#endif
if (ret)
return ret;
return 0;
}
#ifdef CONFIG_SPL
u32 spl_boot_device(void)
{
/* RISC-V QEMU only supports RAM as SPL boot device */
return BOOT_DEVICE_RAM;
}
#endif
#ifdef CONFIG_SPL_LOAD_FIT
int board_fit_config_name_match(const char *name)
{
/* boot using first FIT config */
return 0;
}
#endif