| // SPDX-License-Identifier: GPL-2.0+ |
| /* |
| * Copyright 2022 NXP |
| */ |
| |
| / { |
| wdt-reboot { |
| compatible = "wdt-reboot"; |
| wdt = <&wdog3>; |
| bootph-pre-ram; |
| }; |
| |
| aliases { |
| usbgadget0 = &usbg1; |
| usbgadget1 = &usbg2; |
| }; |
| |
| usbg1: usbg1 { |
| compatible = "fsl,imx27-usb-gadget"; |
| dr_mode = "peripheral"; |
| chipidea,usb = <&usbotg1>; |
| status = "okay"; |
| }; |
| |
| usbg2: usbg2 { |
| compatible = "fsl,imx27-usb-gadget"; |
| dr_mode = "peripheral"; |
| chipidea,usb = <&usbotg2>; |
| status = "okay"; |
| }; |
| |
| firmware { |
| optee { |
| compatible = "linaro,optee-tz"; |
| method = "smc"; |
| }; |
| }; |
| }; |
| |
| &{/soc@0} { |
| bootph-all; |
| bootph-pre-ram; |
| }; |
| |
| &aips1 { |
| bootph-pre-ram; |
| bootph-all; |
| }; |
| |
| &aips2 { |
| bootph-pre-ram; |
| }; |
| |
| &aips3 { |
| bootph-pre-ram; |
| }; |
| |
| &iomuxc { |
| bootph-pre-ram; |
| }; |
| |
| ®_usdhc2_vmmc { |
| u-boot,off-on-delay-us = <20000>; |
| bootph-pre-ram; |
| }; |
| |
| &pinctrl_reg_usdhc2_vmmc { |
| bootph-pre-ram; |
| }; |
| |
| &pinctrl_uart1 { |
| bootph-pre-ram; |
| }; |
| |
| &pinctrl_usdhc2_gpio { |
| bootph-pre-ram; |
| }; |
| |
| &pinctrl_usdhc2 { |
| bootph-pre-ram; |
| }; |
| |
| &gpio1 { |
| bootph-pre-ram; |
| }; |
| |
| &gpio2 { |
| bootph-pre-ram; |
| }; |
| |
| &gpio3 { |
| bootph-pre-ram; |
| }; |
| |
| &gpio4 { |
| bootph-pre-ram; |
| }; |
| |
| &lpuart1 { |
| bootph-pre-ram; |
| }; |
| |
| &usdhc1 { |
| bootph-pre-ram; |
| }; |
| |
| &usdhc2 { |
| bootph-pre-ram; |
| fsl,signal-voltage-switch-extra-delay-ms = <8>; |
| }; |
| |
| &lpi2c2 { |
| bootph-pre-ram; |
| }; |
| |
| &{/soc@0/bus@44000000/i2c@44350000/pmic@25} { |
| bootph-pre-ram; |
| }; |
| |
| &{/soc@0/bus@44000000/i2c@44350000/pmic@25/regulators} { |
| bootph-pre-ram; |
| }; |
| |
| &pinctrl_lpi2c2 { |
| bootph-pre-ram; |
| }; |
| |
| &fec { |
| phy-reset-gpios = <&pcal6524 16 GPIO_ACTIVE_LOW>; |
| phy-reset-duration = <15>; |
| phy-reset-post-delay = <100>; |
| }; |
| |
| &eqos { |
| compatible = "fsl,imx-eqos"; |
| }; |
| |
| ðphy1 { |
| reset-gpios = <&pcal6524 15 GPIO_ACTIVE_LOW>; |
| reset-assert-us = <15000>; |
| reset-deassert-us = <100000>; |
| }; |
| |
| &usbotg1 { |
| status = "okay"; |
| extcon = <&ptn5110>; |
| }; |
| |
| &usbotg2 { |
| status = "okay"; |
| extcon = <&ptn5110_2>; |
| }; |
| |
| &s4muap { |
| bootph-pre-ram; |
| status = "okay"; |
| }; |