| .. SPDX-License-Identifier: GPL-2.0+ |
| |
| mx6ullevk |
| ========= |
| |
| How to use U-Boot on Freescale MX6ULL 14x14 EVK |
| ----------------------------------------------- |
| |
| - First make sure you have installed the dtc package (device tree compiler): |
| |
| .. code-block:: bash |
| |
| $ sudo apt-get install device-tree-compiler |
| |
| - Build U-Boot for MX6ULL 14x14 EVK: |
| |
| .. code-block:: bash |
| |
| $ make mrproper |
| $ make mx6ull_14x14_evk_defconfig |
| $ make |
| |
| This generates the u-boot-dtb.imx image in the current directory. |
| |
| - Flash the u-boot-dtb.imx image into the micro SD card: |
| |
| .. code-block:: bash |
| |
| $ sudo dd if=u-boot-dtb.imx of=/dev/sdb bs=1K seek=1 conv=notrunc && sync |
| |
| - Jumper settings:: |
| |
| SW601: 0 0 1 0 |
| Sw602: 1 0 |
| |
| Where 0 means bottom position and 1 means top position (from the switch label |
| numbers reference). |
| |
| Connect the USB cable between the EVK and the PC for the console. |
| (The USB console connector is the one close the push buttons) |
| |
| Insert the micro SD card in the board, power it up and U-Boot messages should |
| come up. |
| |
| The link for the board: http://www.nxp.com/products/microcontrollers-and- \ |
| processors/arm-processors/i.mx-applications-processors/i.mx-6-processors/ \ |
| i.mx6qp/evaluation-kit-for-the-i.mx-6ull-applications-processor:MCIMX6ULL-EVK |