| // SPDX-License-Identifier: GPL-2.0+ |
| /* |
| * Copyright (c) 2017 Microchip Technology Inc. All rights reserved. |
| */ |
| |
| #include <dm.h> |
| #include <usb.h> |
| #include <linux/mii.h> |
| #include "usb_ether.h" |
| #include "lan7x.h" |
| |
| /* LAN75xx specific register/bit defines */ |
| #define LAN75XX_HW_CFG_BIR BIT(7) |
| |
| #define LAN75XX_BURST_CAP 0x034 |
| |
| #define LAN75XX_BULK_IN_DLY 0x03C |
| |
| #define LAN75XX_RFE_CTL 0x060 |
| |
| #define LAN75XX_FCT_RX_CTL 0x090 |
| |
| #define LAN75XX_FCT_TX_CTL 0x094 |
| |
| #define LAN75XX_FCT_RX_FIFO_END 0x098 |
| |
| #define LAN75XX_FCT_TX_FIFO_END 0x09C |
| |
| #define LAN75XX_FCT_FLOW 0x0A0 |
| |
| /* MAC ADDRESS PERFECT FILTER For LAN75xx */ |
| #define LAN75XX_ADDR_FILTX 0x300 |
| #define LAN75XX_ADDR_FILTX_FB_VALID BIT(31) |
| |
| /* |
| * Lan75xx infrastructure commands |
| */ |
| static int lan75xx_phy_gig_workaround(struct usb_device *udev, |
| struct ueth_data *dev) |
| { |
| int ret = 0; |
| |
| /* Only internal phy */ |
| /* Set the phy in Gig loopback */ |
| lan7x_mdio_write(udev, dev->phy_id, MII_BMCR, |
| (BMCR_LOOPBACK | BMCR_SPEED1000)); |
| |
| /* Wait for the link up */ |
| ret = lan7x_mdio_wait_for_bit(udev, "BMSR_LSTATUS", |
| dev->phy_id, MII_BMSR, BMSR_LSTATUS, |
| true, PHY_CONNECT_TIMEOUT_MS, 1); |
| if (ret) |
| return ret; |
| |
| /* phy reset */ |
| return lan7x_pmt_phy_reset(udev, dev); |
| } |
| |
| static int lan75xx_update_flowcontrol(struct usb_device *udev, |
| struct ueth_data *dev) |
| { |
| uint32_t flow = 0, fct_flow = 0; |
| int ret; |
| |
| ret = lan7x_update_flowcontrol(udev, dev, &flow, &fct_flow); |
| if (ret) |
| return ret; |
| |
| ret = lan7x_write_reg(udev, LAN75XX_FCT_FLOW, fct_flow); |
| if (ret) |
| return ret; |
| return lan7x_write_reg(udev, FLOW, flow); |
| } |
| |
| static int lan75xx_set_receive_filter(struct usb_device *udev) |
| { |
| /* No multicast in u-boot */ |
| return lan7x_write_reg(udev, LAN75XX_RFE_CTL, |
| RFE_CTL_BCAST_EN | RFE_CTL_DA_PERFECT); |
| } |
| |
| /* starts the TX path */ |
| static void lan75xx_start_tx_path(struct usb_device *udev) |
| { |
| /* Enable Tx at MAC */ |
| lan7x_write_reg(udev, MAC_TX, MAC_TX_TXEN); |
| |
| /* Enable Tx at SCSRs */ |
| lan7x_write_reg(udev, LAN75XX_FCT_TX_CTL, FCT_TX_CTL_EN); |
| } |
| |
| /* Starts the Receive path */ |
| static void lan75xx_start_rx_path(struct usb_device *udev) |
| { |
| /* Enable Rx at MAC */ |
| lan7x_write_reg(udev, MAC_RX, |
| LAN7X_MAC_RX_MAX_SIZE_DEFAULT | |
| MAC_RX_FCS_STRIP | MAC_RX_RXEN); |
| |
| /* Enable Rx at SCSRs */ |
| lan7x_write_reg(udev, LAN75XX_FCT_RX_CTL, FCT_RX_CTL_EN); |
| } |
| |
| static int lan75xx_basic_reset(struct usb_device *udev, |
| struct ueth_data *dev, |
| struct lan7x_private *priv) |
| { |
| int ret; |
| u32 val; |
| |
| ret = lan7x_basic_reset(udev, dev); |
| if (ret) |
| return ret; |
| |
| /* Keep the chip ID */ |
| ret = lan7x_read_reg(udev, ID_REV, &val); |
| if (ret) |
| return ret; |
| debug("LAN75xx ID_REV = 0x%08x\n", val); |
| |
| priv->chipid = (val & ID_REV_CHIP_ID_MASK) >> 16; |
| |
| /* Respond to the IN token with a NAK */ |
| ret = lan7x_read_reg(udev, HW_CFG, &val); |
| if (ret) |
| return ret; |
| val |= LAN75XX_HW_CFG_BIR; |
| return lan7x_write_reg(udev, HW_CFG, val); |
| } |
| |
| int lan75xx_write_hwaddr(struct udevice *dev) |
| { |
| struct usb_device *udev = dev_get_parent_priv(dev); |
| struct eth_pdata *pdata = dev_get_platdata(dev); |
| unsigned char *enetaddr = pdata->enetaddr; |
| u32 addr_lo = get_unaligned_le32(&enetaddr[0]); |
| u32 addr_hi = (u32)get_unaligned_le16(&enetaddr[4]); |
| int ret; |
| |
| /* set hardware address */ |
| ret = lan7x_write_reg(udev, RX_ADDRL, addr_lo); |
| if (ret) |
| return ret; |
| |
| ret = lan7x_write_reg(udev, RX_ADDRH, addr_hi); |
| if (ret) |
| return ret; |
| |
| ret = lan7x_write_reg(udev, LAN75XX_ADDR_FILTX + 4, addr_lo); |
| if (ret) |
| return ret; |
| |
| addr_hi |= LAN75XX_ADDR_FILTX_FB_VALID; |
| ret = lan7x_write_reg(udev, LAN75XX_ADDR_FILTX, addr_hi); |
| if (ret) |
| return ret; |
| |
| debug("MAC addr %pM written\n", enetaddr); |
| |
| return 0; |
| } |
| |
| static int lan75xx_eth_start(struct udevice *dev) |
| { |
| struct usb_device *udev = dev_get_parent_priv(dev); |
| struct lan7x_private *priv = dev_get_priv(dev); |
| struct ueth_data *ueth = &priv->ueth; |
| int ret; |
| u32 write_buf; |
| |
| /* Reset and read Mac addr were done in probe() */ |
| ret = lan75xx_write_hwaddr(dev); |
| if (ret) |
| return ret; |
| |
| ret = lan7x_write_reg(udev, INT_STS, 0xFFFFFFFF); |
| if (ret) |
| return ret; |
| |
| ret = lan7x_write_reg(udev, LAN75XX_BURST_CAP, 0); |
| if (ret) |
| return ret; |
| |
| ret = lan7x_write_reg(udev, LAN75XX_BULK_IN_DLY, DEFAULT_BULK_IN_DELAY); |
| if (ret) |
| return ret; |
| |
| /* set FIFO sizes */ |
| write_buf = (MAX_RX_FIFO_SIZE - 512) / 512; |
| ret = lan7x_write_reg(udev, LAN75XX_FCT_RX_FIFO_END, write_buf); |
| if (ret) |
| return ret; |
| |
| write_buf = (MAX_TX_FIFO_SIZE - 512) / 512; |
| ret = lan7x_write_reg(udev, LAN75XX_FCT_TX_FIFO_END, write_buf); |
| if (ret) |
| return ret; |
| |
| /* Init Tx */ |
| ret = lan7x_write_reg(udev, FLOW, 0); |
| if (ret) |
| return ret; |
| |
| /* Init Rx. Set Vlan, keep default for VLAN on 75xx */ |
| ret = lan75xx_set_receive_filter(udev); |
| if (ret) |
| return ret; |
| |
| /* phy workaround for gig link */ |
| ret = lan75xx_phy_gig_workaround(udev, ueth); |
| if (ret) |
| return ret; |
| |
| /* Init PHY, autonego, and link */ |
| ret = lan7x_eth_phylib_connect(dev, &priv->ueth); |
| if (ret) |
| return ret; |
| ret = lan7x_eth_phylib_config_start(dev); |
| if (ret) |
| return ret; |
| |
| /* |
| * MAC_CR has to be set after PHY init. |
| * MAC will auto detect the PHY speed. |
| */ |
| ret = lan7x_read_reg(udev, MAC_CR, &write_buf); |
| if (ret) |
| return ret; |
| write_buf |= MAC_CR_AUTO_DUPLEX | MAC_CR_AUTO_SPEED | MAC_CR_ADP; |
| ret = lan7x_write_reg(udev, MAC_CR, write_buf); |
| if (ret) |
| return ret; |
| |
| lan75xx_start_tx_path(udev); |
| lan75xx_start_rx_path(udev); |
| |
| return lan75xx_update_flowcontrol(udev, ueth); |
| } |
| |
| int lan75xx_read_rom_hwaddr(struct udevice *dev) |
| { |
| struct usb_device *udev = dev_get_parent_priv(dev); |
| struct eth_pdata *pdata = dev_get_platdata(dev); |
| int ret; |
| |
| /* |
| * Refer to the doc/README.enetaddr and doc/README.usb for |
| * the U-Boot MAC address policy |
| */ |
| ret = lan7x_read_eeprom_mac(pdata->enetaddr, udev); |
| if (ret) |
| memset(pdata->enetaddr, 0, 6); |
| |
| return 0; |
| } |
| |
| static int lan75xx_eth_probe(struct udevice *dev) |
| { |
| struct usb_device *udev = dev_get_parent_priv(dev); |
| struct lan7x_private *priv = dev_get_priv(dev); |
| struct ueth_data *ueth = &priv->ueth; |
| struct eth_pdata *pdata = dev_get_platdata(dev); |
| int ret; |
| |
| /* Do a reset in order to get the MAC address from HW */ |
| if (lan75xx_basic_reset(udev, ueth, priv)) |
| return 0; |
| |
| /* Get the MAC address */ |
| /* |
| * We must set the eth->enetaddr from HW because the upper layer |
| * will force to use the environmental var (usbethaddr) or random if |
| * there is no valid MAC address in eth->enetaddr. |
| * |
| * Refer to the doc/README.enetaddr and doc/README.usb for |
| * the U-Boot MAC address policy |
| */ |
| lan7x_read_eeprom_mac(pdata->enetaddr, udev); |
| /* Do not return 0 for not finding MAC addr in HW */ |
| |
| ret = usb_ether_register(dev, ueth, RX_URB_SIZE); |
| if (ret) |
| return ret; |
| |
| /* Register phylib */ |
| return lan7x_phylib_register(dev); |
| } |
| |
| static const struct eth_ops lan75xx_eth_ops = { |
| .start = lan75xx_eth_start, |
| .send = lan7x_eth_send, |
| .recv = lan7x_eth_recv, |
| .free_pkt = lan7x_free_pkt, |
| .stop = lan7x_eth_stop, |
| .write_hwaddr = lan75xx_write_hwaddr, |
| .read_rom_hwaddr = lan75xx_read_rom_hwaddr, |
| }; |
| |
| U_BOOT_DRIVER(lan75xx_eth) = { |
| .name = "lan75xx_eth", |
| .id = UCLASS_ETH, |
| .probe = lan75xx_eth_probe, |
| .remove = lan7x_eth_remove, |
| .ops = &lan75xx_eth_ops, |
| .priv_auto_alloc_size = sizeof(struct lan7x_private), |
| .platdata_auto_alloc_size = sizeof(struct eth_pdata), |
| }; |
| |
| static const struct usb_device_id lan75xx_eth_id_table[] = { |
| { USB_DEVICE(0x0424, 0x7500) }, /* LAN7500 USB Ethernet */ |
| { } /* Terminating entry */ |
| }; |
| |
| U_BOOT_USB_DEVICE(lan75xx_eth, lan75xx_eth_id_table); |