| spi based seps525 framebuffer display driver |
| |
| Driver for seps525 display controller (in spi mode), This binding supports selection |
| of spi chipselect, spi max frequency, gpio to drive dc and reset pin of seps525 |
| controller and spi transaction bit length. |
| |
| Required properties: |
| - compatible: "syncoam,seps525" |
| - reg: Specifies the chip-select the seps525 is connected to on the spi bus |
| - reset-gpios: gpio connected to reset pin of seps525 controller. |
| - dc-gpios: gpio connected to dc pin of seps525 controller: |
| - buswidth: bitlength of each spi transaction |
| |
| Example: |
| displayspi@0 { |
| compatible = "syncoam,seps525"; |
| reg = <0>; |
| spi-max-frequency = <10000000>; |
| spi-cpol; |
| spi-cpha; |
| buswidth = <8>; |
| reset-gpios = <&gpio 0x1c GPIO_ACTIVE_LOW>; |
| dc-gpios = <&gpio 0x1b GPIO_ACTIVE_HIGH>; |
| }; |