| // SPDX-License-Identifier: GPL-2.0+ |
| /* |
| * Copyright 2014 Freescale Semiconductor, Inc. |
| * |
| * Shengzhou Liu <Shengzhou.Liu@freescale.com> |
| */ |
| |
| #include <common.h> |
| #include <command.h> |
| #include <fdt_support.h> |
| #include <net.h> |
| #include <netdev.h> |
| #include <asm/mmu.h> |
| #include <asm/processor.h> |
| #include <asm/immap_85xx.h> |
| #include <asm/fsl_law.h> |
| #include <asm/fsl_serdes.h> |
| #include <asm/fsl_portals.h> |
| #include <asm/fsl_liodn.h> |
| #include <malloc.h> |
| #include <fm_eth.h> |
| #include <fsl_mdio.h> |
| #include <miiphy.h> |
| #include <phy.h> |
| #include <fsl_dtsec.h> |
| #include <asm/fsl_serdes.h> |
| |
| int board_eth_init(struct bd_info *bis) |
| { |
| #if defined(CONFIG_FMAN_ENET) |
| int i, interface; |
| struct memac_mdio_info dtsec_mdio_info; |
| struct memac_mdio_info tgec_mdio_info; |
| struct mii_dev *dev; |
| ccsr_gur_t *gur = (void *)(CONFIG_SYS_MPC85xx_GUTS_ADDR); |
| u32 srds_s1; |
| |
| srds_s1 = in_be32(&gur->rcwsr[4]) & |
| FSL_CORENET2_RCWSR4_SRDS1_PRTCL; |
| srds_s1 >>= FSL_CORENET2_RCWSR4_SRDS1_PRTCL_SHIFT; |
| |
| dtsec_mdio_info.regs = |
| (struct memac_mdio_controller *)CONFIG_SYS_FM1_DTSEC_MDIO_ADDR; |
| |
| dtsec_mdio_info.name = DEFAULT_FM_MDIO_NAME; |
| |
| /* Register the 1G MDIO bus */ |
| fm_memac_mdio_init(bis, &dtsec_mdio_info); |
| |
| tgec_mdio_info.regs = |
| (struct memac_mdio_controller *)CONFIG_SYS_FM1_TGEC_MDIO_ADDR; |
| tgec_mdio_info.name = DEFAULT_FM_TGEC_MDIO_NAME; |
| |
| /* Register the 10G MDIO bus */ |
| fm_memac_mdio_init(bis, &tgec_mdio_info); |
| |
| /* Set the two on-board RGMII PHY address */ |
| fm_info_set_phy_address(FM1_DTSEC3, RGMII_PHY1_ADDR); |
| fm_info_set_phy_address(FM1_DTSEC4, RGMII_PHY2_ADDR); |
| |
| switch (srds_s1) { |
| case 0x66: |
| case 0x6b: |
| fm_info_set_phy_address(FM1_10GEC1, CORTINA_PHY_ADDR1); |
| fm_info_set_phy_address(FM1_10GEC2, CORTINA_PHY_ADDR2); |
| fm_info_set_phy_address(FM1_10GEC3, FM1_10GEC3_PHY_ADDR); |
| fm_info_set_phy_address(FM1_10GEC4, FM1_10GEC4_PHY_ADDR); |
| break; |
| default: |
| printf("SerDes1 protocol 0x%x is not supported on T208xRDB\n", |
| srds_s1); |
| break; |
| } |
| |
| for (i = FM1_DTSEC1; i < FM1_DTSEC1 + CONFIG_SYS_NUM_FM1_DTSEC; i++) { |
| interface = fm_info_get_enet_if(i); |
| switch (interface) { |
| case PHY_INTERFACE_MODE_RGMII: |
| dev = miiphy_get_dev_by_name(DEFAULT_FM_MDIO_NAME); |
| fm_info_set_mdio(i, dev); |
| break; |
| default: |
| break; |
| } |
| } |
| |
| for (i = FM1_10GEC1; i < FM1_10GEC1 + CONFIG_SYS_NUM_FM1_10GEC; i++) { |
| switch (fm_info_get_enet_if(i)) { |
| case PHY_INTERFACE_MODE_XGMII: |
| dev = miiphy_get_dev_by_name(DEFAULT_FM_TGEC_MDIO_NAME); |
| fm_info_set_mdio(i, dev); |
| break; |
| default: |
| break; |
| } |
| } |
| |
| cpu_eth_init(bis); |
| #endif /* CONFIG_FMAN_ENET */ |
| |
| return pci_eth_init(bis); |
| } |
| |
| void fdt_fixup_board_enet(void *fdt) |
| { |
| return; |
| } |