| // SPDX-License-Identifier: GPL-2.0+ |
| /* |
| * Copyright (C) 2019 Philippe Reynes <philippe.reynes@softathome.com> |
| * |
| * based on: |
| * drivers/led/led_bcm6328.c |
| * drivers/led/led_bcm6358.c |
| */ |
| |
| #include <common.h> |
| #include <dm.h> |
| #include <errno.h> |
| #include <led.h> |
| #include <log.h> |
| #include <asm/io.h> |
| #include <dm/lists.h> |
| #include <linux/bitops.h> |
| |
| #define LEDS_MAX 32 |
| #define LEDS_WAIT 100 |
| #define LEDS_MAX_BRIGHTNESS 7 |
| |
| /* LED Mode register */ |
| #define LED_MODE_REG 0x0 |
| #define LED_MODE_OFF 0 |
| #define LED_MODE_ON 1 |
| #define LED_MODE_MASK 1 |
| |
| /* LED Controller Global settings register */ |
| #define LED_CTRL_REG 0x00 |
| #define LED_CTRL_MASK 0x1f |
| #define LED_CTRL_LED_TEST_MODE BIT(0) |
| #define LED_CTRL_SERIAL_LED_DATA_PPOL BIT(1) |
| #define LED_CTRL_SERIAL_LED_CLK_POL BIT(2) |
| #define LED_CTRL_SERIAL_LED_EN_POL BIT(3) |
| #define LED_CTRL_SERIAL_LED_MSB_FIRST BIT(4) |
| |
| /* LED Controller IP LED source select register */ |
| #define LED_HW_LED_EN_REG 0x08 |
| /* LED Flash control register0 */ |
| #define LED_FLASH_RATE_CONTROL_REG0 0x10 |
| /* LED Brightness control register0 */ |
| #define LED_BRIGHTNESS_CONTROL_REG0 0x20 |
| /* Soft LED input register */ |
| #define LED_SW_LED_IP_REG 0xb8 |
| /* Parallel LED Output Polarity Register */ |
| #define LED_PLED_OP_PPOL_REG 0xc0 |
| |
| struct bcm6858_led_priv { |
| void __iomem *regs; |
| u8 pin; |
| }; |
| |
| #ifdef CONFIG_LED_BLINK |
| /* |
| * The value for flash rate are: |
| * 0 : no blinking |
| * 1 : rate is 25 Hz => 40 ms (period) |
| * 2 : rate is 12.5 Hz => 80 ms (period) |
| * 3 : rate is 6.25 Hz => 160 ms (period) |
| * 4 : rate is 3.125 Hz => 320 ms (period) |
| * 5 : rate is 1.5625 Hz => 640 ms (period) |
| * 6 : rate is 0.7815 Hz => 1280 ms (period) |
| * 7 : rate is 0.390625 Hz => 2560 ms (period) |
| */ |
| static const int bcm6858_flash_rate[8] = { |
| 0, 40, 80, 160, 320, 640, 1280, 2560 |
| }; |
| |
| static u32 bcm6858_flash_rate_value(int period_ms) |
| { |
| unsigned long value = 7; |
| int i; |
| |
| for (i = 0; i < ARRAY_SIZE(bcm6858_flash_rate); i++) { |
| if (period_ms <= bcm6858_flash_rate[i]) { |
| value = i; |
| break; |
| } |
| } |
| |
| return value; |
| } |
| |
| static int bcm6858_led_set_period(struct udevice *dev, int period_ms) |
| { |
| struct bcm6858_led_priv *priv = dev_get_priv(dev); |
| u32 offset, shift, mask, value; |
| |
| offset = (priv->pin / 8) * 4; |
| shift = (priv->pin % 8) * 4; |
| mask = 0x7 << shift; |
| value = bcm6858_flash_rate_value(period_ms) << shift; |
| |
| clrbits_32(priv->regs + LED_FLASH_RATE_CONTROL_REG0 + offset, mask); |
| setbits_32(priv->regs + LED_FLASH_RATE_CONTROL_REG0 + offset, value); |
| |
| return 0; |
| } |
| #endif |
| |
| static int led_set_brightness(struct udevice *dev, unsigned int brightness) |
| { |
| struct bcm6858_led_priv *priv = dev_get_priv(dev); |
| u32 offset, shift, mask, value; |
| |
| offset = (priv->pin / 8) * 4; |
| shift = (priv->pin % 8) * 4; |
| mask = 0xf << shift; |
| |
| /* 8 levels of brightness achieved through PWM */ |
| value = (brightness > LEDS_MAX_BRIGHTNESS ? |
| LEDS_MAX_BRIGHTNESS : brightness) << shift; |
| |
| debug("%s: %s brightness set to %u\n", __func__, dev->name, value >> shift); |
| |
| clrbits_32(priv->regs + LED_BRIGHTNESS_CONTROL_REG0 + offset, mask); |
| setbits_32(priv->regs + LED_BRIGHTNESS_CONTROL_REG0 + offset, value); |
| |
| return 0; |
| } |
| |
| static enum led_state_t bcm6858_led_get_state(struct udevice *dev) |
| { |
| struct bcm6858_led_priv *priv = dev_get_priv(dev); |
| enum led_state_t state = LEDST_OFF; |
| u32 sw_led_ip; |
| |
| sw_led_ip = readl(priv->regs + LED_SW_LED_IP_REG); |
| if (sw_led_ip & (1 << priv->pin)) |
| state = LEDST_ON; |
| |
| return state; |
| } |
| |
| static int bcm6858_led_set_state(struct udevice *dev, enum led_state_t state) |
| { |
| struct bcm6858_led_priv *priv = dev_get_priv(dev); |
| |
| debug("%s: Set led %s to %d\n", __func__, dev->name, state); |
| |
| switch (state) { |
| case LEDST_OFF: |
| clrbits_32(priv->regs + LED_SW_LED_IP_REG, (1 << priv->pin)); |
| #ifdef CONFIG_LED_BLINK |
| bcm6858_led_set_period(dev, 0); |
| #endif |
| break; |
| case LEDST_ON: |
| setbits_32(priv->regs + LED_SW_LED_IP_REG, (1 << priv->pin)); |
| #ifdef CONFIG_LED_BLINK |
| bcm6858_led_set_period(dev, 0); |
| #endif |
| break; |
| case LEDST_TOGGLE: |
| if (bcm6858_led_get_state(dev) == LEDST_OFF) |
| return bcm6858_led_set_state(dev, LEDST_ON); |
| else |
| return bcm6858_led_set_state(dev, LEDST_OFF); |
| break; |
| #ifdef CONFIG_LED_BLINK |
| case LEDST_BLINK: |
| setbits_32(priv->regs + LED_SW_LED_IP_REG, (1 << priv->pin)); |
| break; |
| #endif |
| default: |
| return -EINVAL; |
| } |
| |
| return 0; |
| } |
| |
| static const struct led_ops bcm6858_led_ops = { |
| .get_state = bcm6858_led_get_state, |
| .set_state = bcm6858_led_set_state, |
| #ifdef CONFIG_LED_BLINK |
| .set_period = bcm6858_led_set_period, |
| #endif |
| }; |
| |
| static int bcm6858_led_probe(struct udevice *dev) |
| { |
| struct bcm6858_led_priv *priv = dev_get_priv(dev); |
| void __iomem *regs; |
| unsigned int pin, brightness; |
| |
| regs = dev_remap_addr(dev_get_parent(dev)); |
| if (!regs) |
| return -EINVAL; |
| |
| pin = dev_read_u32_default(dev, "reg", LEDS_MAX); |
| if (pin >= LEDS_MAX) |
| return -EINVAL; |
| |
| priv->regs = regs; |
| priv->pin = pin; |
| |
| /* this led is managed by software */ |
| clrbits_32(regs + LED_HW_LED_EN_REG, 1 << pin); |
| |
| /* configure the polarity */ |
| if (dev_read_bool(dev, "active-low")) |
| clrbits_32(regs + LED_PLED_OP_PPOL_REG, 1 << pin); |
| else |
| setbits_32(regs + LED_PLED_OP_PPOL_REG, 1 << pin); |
| |
| brightness = dev_read_u32_default(dev, "default-brightness", |
| LEDS_MAX_BRIGHTNESS); |
| led_set_brightness(dev, brightness); |
| |
| return 0; |
| } |
| |
| U_BOOT_DRIVER(bcm6858_led) = { |
| .name = "bcm6858-led", |
| .id = UCLASS_LED, |
| .probe = bcm6858_led_probe, |
| .priv_auto = sizeof(struct bcm6858_led_priv), |
| .ops = &bcm6858_led_ops, |
| }; |
| |
| static int bcm6858_led_wrap_probe(struct udevice *dev) |
| { |
| void __iomem *regs; |
| u32 set_bits = 0; |
| |
| regs = dev_remap_addr(dev); |
| if (!regs) |
| return -EINVAL; |
| |
| if (dev_read_bool(dev, "brcm,serial-led-msb-first")) |
| set_bits |= LED_CTRL_SERIAL_LED_MSB_FIRST; |
| if (dev_read_bool(dev, "brcm,serial-led-en-pol")) |
| set_bits |= LED_CTRL_SERIAL_LED_EN_POL; |
| if (dev_read_bool(dev, "brcm,serial-led-clk-pol")) |
| set_bits |= LED_CTRL_SERIAL_LED_CLK_POL; |
| if (dev_read_bool(dev, "brcm,serial-led-data-ppol")) |
| set_bits |= LED_CTRL_SERIAL_LED_DATA_PPOL; |
| if (dev_read_bool(dev, "brcm,led-test-mode")) |
| set_bits |= LED_CTRL_LED_TEST_MODE; |
| |
| clrsetbits_32(regs + LED_CTRL_REG, ~0, set_bits); |
| |
| return 0; |
| } |
| |
| static int bcm6858_led_wrap_bind(struct udevice *parent) |
| { |
| ofnode node; |
| |
| dev_for_each_subnode(node, parent) { |
| struct udevice *dev; |
| int ret; |
| |
| ret = device_bind_driver_to_node(parent, "bcm6858-led", |
| ofnode_get_name(node), |
| node, &dev); |
| if (ret) |
| return ret; |
| } |
| |
| return 0; |
| } |
| |
| static const struct udevice_id bcm6858_led_ids[] = { |
| { .compatible = "brcm,bcm6858-leds" }, |
| { /* sentinel */ } |
| }; |
| |
| U_BOOT_DRIVER(bcm6858_led_wrap) = { |
| .name = "bcm6858_led_wrap", |
| .id = UCLASS_NOP, |
| .of_match = bcm6858_led_ids, |
| .probe = bcm6858_led_wrap_probe, |
| .bind = bcm6858_led_wrap_bind, |
| }; |